GE Lumination 93047465, Lumination 93047707, Lumination 93047706, Lumination 93047708, Lumination 93047709 Installation Manual

GE

Lighting

TM

Lumination

LHX Series Barn Door Accessory

LED Track Light

Installation Guide

BEFORE YOU BEGIN

Read these instructions completely and carefully.

FOR USE WITH CEILING MOUNTED TRACK ONLY.

READ TRACK MANUFACTURER’S INSTALLATION
INSTRUCTIONS FOR GUIDELINES ON TRACK INSTALLATION.

WARNING

RISK OF ELECTRIC SHOCK

Turn power off before inspection, installation or removal.

Material

SKU

93047465 LHLBDWHITE LHL WHITE BARN DOOR
93047706 LHLBDBLCK LHL BLACK BARN DOOR
93047707 LHSBDWHTE LHS WHITE BARN DOOR
93047708 LHSBDBLCK LHS BLACK BARN DOOR
93047709 LHMBDWHTE LHM WHITE BARN DOOR
93047710 LHMBDBLCK LHM BLACK BARN DOOR
93047708 LHSBDBLCK LHS BLACK BARN DOOR

Description

Product
Description

IMPORTANT SAFETY INSTRUCTIONS

When installing or using this track system, basic safety
precautions should always be followed, including the
following:
a. Read all instructions
b. Do not install this track in damp or wet locations.
c. Do not cut any track sections.
d. Do not install any part of a track system less than

5 feet above the oor.

e. Do not install any luminaire assembly closer than

6 inches from any curtain, or similar combustible
material.

f. Disconnect electrical power before adding to or

changing the conguration of the track.

g. Do not attempt to energize anything other than

lighting track luminaires on the track. To reduce

the risk of re and electric shock, do not attempt to

connect power tools, extension cords, appliances,
and the like to the track.

h. Do not connect a track to more than one branch

circuit unless the track is constructed so that it can
be used with more than one branch circuit. Check

with a qualied electrician. Although the track

lighting system may seem to operate acceptably, a
dangerous overload of the neutral may occur and

result in a risk of re.

SAVE THESE INSTRUCTIONS

For future reference when adding xtures

or changing the track conguration.

1

Installation of Barn Door on the LHX Series Track Light

Metal ring

Begin with xture disconnected

1

from the track.

Tighten down the screw on

3 4

the outside of the accessory,

cinching the exible silver metal
ring tight around the xture.

Slide the barn door accessory over the top of the xture, ensuring

2

that the exible silver metal ring on the inside of the accessory sits
completely around the outside of the xture.

Once screw is tightened, check
that the accessory is securely
attached.

www.currentbyge.com, www.gelighting.com

All trademarks are the property of their respective owners. Information provided is subject to
change without notice. All values are design or typical values when measured under laboratory
conditions. Current, powered by GE is a business of the General Electric Company.
© 2017

IND431 (Rev 07/10/17)

2