GE Monogram ZISS360NRSS, EWF10771 W, LS-B50, VXA-210 Datasheet
ZISS360NRSS – GE Monogram 36" Stainless Steel Built-In Side-by-Side
15"
13"
R
*84" From
Floor to
Top Frame
36"
Frame to Frame
35"
Case Width
*83-1/2"
at
Rear
25-3/4"
27-3/4"
including
handle
35-1/2"
6"
5"
Electrical
Area
84-1/2" max
83-1/2" min
Finished
Opening
75" From Floor
to Bottom
of Electrical
Area
24"
5"
5"
3-1/2"
Water Supply
3-1/2"
36" Models 12"
23-7/8"
Behind
Frame
20-5/8
4" Min.
to Wall
Refrigerator with Automatic Icemaker and Water Filter
The Installation Space
Water and Electrical Locations
The opening must be prepared with the electrical and water
supply located as shown.
The cutout depth must be 24
".
The refrigerator will project forward, slightly beyond adjacent
cabinetry, depending on your installation.
The cutout depth beneath a soffit :
When installed beneath a soffit, the soffit cannot exceed the
24" installation depth shown. The top case trim overlaps the
bottom of the soffit.
Frameless cabinets:
The case trim overlaps cabinets at the top and sides.
Therefore, frameless cabinets may require filler strips to
prevent interference with cabinet door swing. The opening
must allow for filler strips.
Additional Specifications
• A 115 volt 60Hz., 15 or 20 amp power supply is required.
An individual properly grounded branch circuit or circuit
breaker is recommended. Install a properly grounded
3-prong electrical receptacle recessed into the back wall.
Electrical must be located on rear wall as shown.
Note: GFI (ground fault interrupter) is not recommended.
• Water line can enter the opening through the floor or back
wall. The water line should be 1/4" O.D. copper tubing or
GE SmartConnect
water connection location, long enough to extend to the
front of the refrigerator. Installation of an easily accessible
shut off valve in the water line is recommended.
Specification Revised 1/ 04
110104
™
kit between the cold water line and
* Shipping height.
The refrigerator
can be adjusted to
fit into a cutout that
is 83-1/2” min. to
84-1/2” max. height
Note that the top
case trim at the
front is 1/2” higher
and will overlap
upper cabinetry or
soffit. Use leveling
legs and wheels for
a maximum 1" height
adjustment.
Product Clearances
These refrigerators are equipped with a 2 position door stop.
The factory set 130° door swing can be adjusted to 90° if
clearance to adjacent cabinets or walls is restricted.
Allow minimum clearances for freezer door and fresh food
door for a full 130° door swing and to allow for pan removal.
4" minimum clearance is required when door swing is adjusted
to 90°. If the 90° door stop position is used, pan access is
maintained, but pan removal is restricted.
Installation Information: Before installing, consult
installation instructions packed with product, or available
at Monogram.com, for current dimensional data.
As an ENERGY STAR®
Listed by
Under writers
For answers to your Monogram,® GE Profile™ or
®
GE
GEAppliances.com or call
GE Answer Center
Laboratories
appliance questions, visit our website at
®
service, 800.626.2000.
partner, GE has determined
that this product meets the
ENERGY STAR
for energy efficiency.
guidelines
ZISS360NRSS – GE Monogram 36" Stainless Steel Built-In Side-by-Side
Refrigerator with Automatic Icemaker and Water Filter
Features and Benefits
• 21.6 cu. ft. total capacity
• Overhead evaporator
• Integrated Ice
into the icemaker, not the freezer door, freeing
up valuable storage space
• Upfront electronic controls with digital readout
™
System – The ice bucket is integrated
• Multi-shelf halogen light tower (Both fresh food
and freezer section)
• Multi-shelf air management tower
• Climate control drawer with Express Chill,
Express Thaw and Select Temp
• Sealed adjustable humidity produce pan with
easy access lid and full extension slides
• Model ZISS360NRSS – Stainless steel wrap,
non-dispenser
Specification Revised 1/ 04
110104
As an ENERGY STAR®
partner, GE has determined
that this product meets the
ENERGY STAR
for energy efficiency.
guidelines
Loading...