GE LED Accent Lighting, PowerGrid Installation Guide

GE

Lighting

Tetra® Dimming Module

LED ARCHITECTURAL SERIES

Product Codes

75612

Installation Guide

LED System Features

• Certied to UL 2108

• IP54: Dry or damp location rated

• Compatible with any 12 or 24 Volt Tetra LED System

• Compatible with most 0-10V Dimming Controllers

For use in the following applications:

• Creates custom lighting levels

Save These Instructions

This product is intended solely for the use of non-

residential architecture lighting and is not intended
for use in any other applications.

BEFORE YOU BEGIN

Read these instructions completely and carefully

WARNING/AVERTISSEMENT

Risk of electrical shock. Disconnect power before servicing or

installing product.
Risque de choc électrique. Couper l’alimentation avant le
dépannage ou avant l’installation du produit.

Prepare Electrical Wiring

Electrical Requirements

• Do not use in wet locations.

• The grounding and bonding of the LED Driver shall be
done in accordance with National Electric Code (NEC)

Article 600.

• Follow all National Electric Codes (NEC) and local codes.

imagination at work

Attach Tetra Dimming Module to Tetra LED Lighting Systems

Option A

Tetra LED system - two wire systems

White (-)

Red (+)

Tetra Dimming Module

Option B

Center wire (-)

White (-)

Red (+)

Tetra Dimming Module

White (-)

Red (+)

Outside wires (+)

Connect the (+) red output wire of the Tetra Dimming Module to

the red (+) input wire of the Tetra LED system. Connect the (-) white
output wire of the Tetra Dimming Module to the (-) white input wire
of the Tetra LED system. Refer to the Tetra LED system for specic

connection and loading information.

Tetra Contour

Connect the (+) outside wires of Tetra Contour to the (+) red wire

of the Tetra Dimming Module. Connect the (-) inside wire of Tetra
Contour to the (-) white wire of the Tetra Dimming Module.

Attach Tetra Dimming Module to Dimming Controller

Dimming
controller

Negative lead (-)

Gray (-)

To LED Driver

Positive lead (+)

Purple (+)

Tetra Dimming Module

Connect the (+) purple and (-) gray wires of the Tetra Dimming Module
to the 0-10V dimming controller. Refer to the dimming controller
installation instructions for specic connection information.