GE KL919DM, KL913AM, KL912AM Use and Care Manual
MoNumber
MASTER CONTROL
THERMOSTAT
SerialNumber
Dateof Purchase
OFF – Turns air conditioner off.
HIGH FAN –
MED FAN –
LOW FAN –
Permits high fan speed operation without cooling.
Permitsmedium fan speedoperation without cooling.
Permits low fan speed operation without cooling.
NOTE: For fan only positionsENERGY SAVER must be set to
the NORM position.
HIGH COOL – Permitscooling with high speedoperation.
MED COOL –
Permits cooling with medium fan speedoperation.
LOW COOL – Permits cooling with low fan speed operation.
The rotary control marked THERMOSTAT is the automatically
control of the indoor air. The higher the number selected the
cooler the indoor air will be.
SAVE ENERGY RANGE
The save energy range allows you to conserveenergy by selecting
a higher room temperature.
The rotary control marked VENT! LATE is the vent door control.
When in the closed position only the air inside the room can be
circulated and conditioned. When the control is in the open position someoutside air is brought into the room.
The slide switch marked ENERGY SAVER controls the fan operation. With the ENERGY SAVER in the NORM position the fan
will continuously circulate room air. In the SAVE position the fan
will automatically cycle on and off with the compressorto provide
the most economical operation.
FOR NORMAL COOLING 3. Position ENERGY SAVER to the NORM position for
1.
Position the MASTER CONTROL switch to Cool High
Set the
2.
(usuallythe mid-point is a good starting position). [f the
room temperature is not satisfactory after a reasonable
period of tirrlf?,
m.Jrnber(for a cooler indoorair temperature) or a lower
n{~rfi?~er{for ;i warmer indoorair temperature).
TEMPERA~UF4Econtrol to the desirednumber
adjustthe temperaturecontrol to a higher
continuousfan operationor to the SAVE positionto
matically cycle the fan on and off with the compressor.
FOR MAXIMUM COOLING
1, Position the MASTER CONTROL switch to Cool High.
2. SetTEMPERATURE controlon 8.
3, PositionVENTI LATE to CLOSED position.
4. PositionENERGY SAVER to the NORM position.
auto-
FOR QUIETER OPERATION at-,all air downward, or, al! air dischargedstraightahead,or,any ;
—-
=,>—
Foiiow steps2 and3 under NORMAL COOLING. Then position
the MASTER CONTROL to Low Cool, This will permit cooling
at a lowerandquieterfans~eed. allowsvou to dischargeall air to the right, or, all air to the i+:.
EXTREME TEMPERATURE OPERATION
Remember, for highest economy and best performance,you ~ioned
alwaysusehighspeedfor extremelyhot days.
VENTILAT:ON
With the controlsset for coolingor fan operationonly, room air
canbe exhaustedto the outsideby positioningthe VENTI LATE
control in the OPEN position. This can be helpful in removing
staleair, smokeor odorsfrom the room . . . and permitsoutdoor
air to enter through openingsnormalto houseconstruction.
NOTE: Cooling effectivenessis reducedwhen the
CONTROL
longperiods,particularlyon hot, humiddays.
~;~
For air circulation and filtering without cooling, selecteither
FAN H!r or FAN LOW positionon the
is OPEN, so it is suggestedit not be left OPEN for
CIRCULATION
MASTER CONTROL.
VENTILATE
combinationbetweenthe positionsmentioned.
The Horizontaladjustmentisdonewith threetabs.Thethreetabs
r
or, some air to the right and the remai;der to the left, or, all ai=”
straightahead,or, any combination betweenthe positionsmen-
.
With adjustmentof both the Vertical and Horizontal louvers,
canbedischargedinany desirablepattern,
.-.:’
t-10RIZONTAL
AIR DIRECTION
TO ADJUST Al R DIRECTION
The grille hastwo waysof adjustingair direction.The Verticalair
direction is adjustedby positioningthe louversup or down.The
Vertical air adjustmentsallow you to dischargeall air upward,
Care and
MaHn~enance
TURN AIR CONDITIONER OFF AND
TO CLEAN FILTER
The filter shouldbe washedat leastevery30 daysor asoften as
required.The inlet baffle of the front grille must be removedto
gainaccessto the air filter. Grasp the upper portion of the inlet
baffle and pull out the inlet baffle. The nameplateshowingthe
Model and Serial numberscan be seenat this time. To remove
the foam filter from the grille frame, lift filter from the four (4)
tabsen grilleframe.
NOTE: Your air conditioner should not be operatedwithout a
filter. Replacement filters can be obtained from your local
Customer Care Service,Parts Department found in the Yellow
Pages.
Vacuum filter on the dusty side or washwith runningwater.
Run water from the cleanerside of the filter to drive out the
accumulateddust and lint. Shake to dry. To replaceair filter,
replacefilter on the four (4) tabson grille frame. Replaceinlet
baffle,
CLEANING THE AIR CONDITIONER
Fro]~t grille may be wipped with a cloth dampenedin a mild
detergent solution.
Cabinet may be washed with mild soap
REMOVE PLUG FROM RECEPTACLE
or detergent and lukewarm water. To assurecontinued
efficiency, condensercoils (weather side of unit) should be
checkedperiodically and cleaned if cloggedwith soot or dirt
from the atmosphere.
for its recommendationof the method and freql:ency with
whichthisserviceshouldbeperformedin your locality.
Consult your Hotpoint service outlet
peak
.-
--
;<&
1.”>J
->
~?:;
,-,%7{
‘:JJ
-+.<)
~>:
ing.)
2. Vent should be in the closedpositionfor mostefficientcoolingor heating.
3. During vacationsor extended periods away from hometurn the air conditioner off.
4. I<eepcondensercoil clean. (Seecare and maintenancesection,)
,
L.&
.....
.“==---.s
~eY
Loading...