GE JGGN24, JGGR24 Assembly Instructions

1
Questions? Call 866.GE.GRILL (866.434.7455)
or Visit our Website at:
www.GEAppliances.com
READ CAREFULLY.
KEEP THESE INSTRUCTIONS
.
Assembly Outdoor Cooking Instructions Center
Read these instructions completely and carefully.
IMPORTANT
Observe all
governing codes and ordinances.
Note to Assembler –Be sure to leave these
instructions with the Consumer.
Note to Consumer –Keep these
instructions for future reference.
Skill level – Assembly of this grill requires basic
mechanical skills.
BEFORE YOU BEGIN
Proper assembly is the responsibility of the assembler.
Product failure due to improper assembly is not
covered under the Warranty.
If you received a damaged grill, you should contact your dealer.
Note –Grill must be completely assembled before
any gas connections are made.

TOOLS YOU WILL NEED

Phillips screwdriver
7/16open end wrench or deep socket with extension
Rubber mallet (optional)
JGGN24, JGGR24
Block of wood or cardboard
(optional)
2
Assembly Instructions

PARTS INCLUDED (Not all models have all parts)

Wheel Axle Bolt (2)
Thumb Screw (2)
Large Bolt (8)
Large Wheel Washer (2)
Wheel Clip (2)
Wheel (2)
Wing Nut (19)
Handle Bolt (2)
Handle Nut (2) Base Assembly (1)
Rotisserie Burner (1)
(On some models)
Retractable Shelf (1)
Side-by-side Grids (2)
LP Tank Bracket (1)
Small Bolt (1)
(For LP Tank Bracket)
Small Washer (1)
(For LP Tank Bracket)
Upper Rear Brace (1)
Front Banner (1)
Side Grid (1)
Left Side Burner/Shelf (1)
Side Shelf (1 or 2)
Bin (1)
Grease Cup
Holder (1)
Flav-R-Wave®* (1)
or
Grill Body (1)
Handle with
Spacer (2)
Shelf Handle (1)
Screw (2)
(Depending on model)
Carriage Bolt (2)
*Flav-R-Wave®is a registered trademark of Onward Multi-Corp, Inc.
3
Carefully cut open the box, remove the contents
and group like parts together.

UNPACK THE GRILL

1
Assembly Instructions
4. Grasp the pan on both sides and raise it up until
the legs are standing squarely on the floor.
To aid assembly, all parts in bold type in the following assembly steps match the illustrations shown in the
PARTS INCLUDED section.
NOTE TO ASSEMBLER
1. Make sure the open side of the pan in the base
assembly is facing up.
2. Lift up on the right side of the pan.
3. Lift the left ends of the legs and swing them over
the wheels to lay flat on the floor.

UNFOLD THE BASE ASSEMBLY

2
RIGHT
SIDE
LEFT SIDE
Casters should
be on the
right top side
Pan
3. Slide a wheel axle bolt through a wheel, large wheel
washer, and through the top hole on the left leg.
Secure the wheel in place by sliding a wheel clip through the hole in the wheel axle bolt. Repeat for the other leg.
4
1. Thread a thumb screw into each of the lower holes
on the right side and through the pan. Secure them in place with wing nuts.
2. Insert a carriage bolt into each of the center holes
on the left side and through the pan. Secure them in place with wing nuts.

ASSEMBLE THE LOWER BASE

3
Carriage Bolt
RIGHT
SIDE
LEFT SIDE
Assembly Instructions
Wheel Axle Bolt (2)
Thumb Screw (2)
Wing Nut (4)
Large Wheel Washer (2)
Wheel Clip (2)
Wheel Axle Bolt
Wheel
Large Wheel Washer
Wheel Clip
Wing Nut
RIGHT
SIDE
LEFT SIDE
Thumb Screw
Wing Nut
Carriage Bolt (2)
Pan
Pan
5
1. Turn the grill body upside-down and wedge
cardboard or a block of wood under the front side to prevent tipping during assembly.
2. Slide the bolt on each of the back legs into the
slots on the back ends of the grill. Secure in place with wing nuts.
3. Hook the two bolts in the front legs into the holes
on the front ends of the grill. Secure in place with wing nuts.

ASSEMBLE BASE TO GRILL BODY

4
Wing Nuts
Wing Nuts
Assembly Instructions
4. Thread a large bolt into the front bottom hole on
each side. Secure in place with wing nuts.
5. Position the upper rear brace between the upper
back legs and secure it to the legs at each end with two large bolts and wing nuts.
Wing Nuts
Upper Rear Brace
Large Bolts
Large Bolt (6)
Wing Nut (10)
1. Lower the wheels toward you and rest the back legs
on the floor.
2. From the back top side of the grill, lift the grill
onto its wheels.

SET THE GRILL ON ITS WHEELS

5
BACK OF
GRILL
Block of wood or cardboard
BACK OF
GRILL
Block of wood or cardboard
BACK OF GRILL
FRONT OF
GRILL
BACK OF GRILL
Large Bolts
Loading...
+ 11 hidden pages