GE JCP340BC, JCP340WC, JCP350BC, JCP350WC, JCP930BC Installation Instructions Manual

...
Installation
30” Electric Cooktop
JCP340BC, JCP340WC, JCP350BC, JCP350WC,
Instructions
If you have questions, call 800-361-3400 or visit our Website at: www.GEappliances.ca
JCP930BC, JCP930SC, JCP930TC
CAUTION:
Read these instructions carefully and completely.
IMPORTANT – Save these instructions for local
inspector’s use.
IMPORTANT – Observe all governing codes and
ordinances.
the Consumer.
Note to Consumer – Keep these instructions for future
reference.
BEFORE YOU BEGIN
PARTS INCLUDED
4 screws
Foam Strips
NOTE: This appliance must be properly grounded.
Skill level – Installation of this appliance requires basic
mechanical and electrical skills.
Completion time – 2–3 hours.
Proper installation is the responsibility of the installer.
Product failure due to improper installation is not
covered under the Warranty.
TOOLS YOU WILL NEED
1/8” Drill Bit & Electric or Hand Drill
Phillips Screwdriver
Pencil
2 Hold Down Brackets
MATERIALS NEEDED
Junction Box
Pub. No. 31-10428
229C4053P127
Wire Nuts
Ruler or Straightedge
11
1
11
Hand or Saber Saw
Installation Instructions
IMPORTANT SAFETY INSTRUCTIONS
FOR YOUR SAFETY
For Personal Safety remove the house fuse or open
the circuit breaker before beginning installation. Failure to do so could result in serious injury or death.
Be sure your cooktop is installed properly by a
qualified installer or service technician.
To eliminate the risk of burns or fire by reaching
over heated surface elements, cabinet storage located above the surface units should be avoided. If cabinet storage space is to be provided, the risk can be reduced by installing a range hood that projects horizontally a minimum of 5 beyond the bottom of the cabinets. Cabinet installation above the cooktop may be no deeper than 13.
Make sure the cabinets and wall coverings around
the cooktop can withstand the temperatures (up to 200°F) generated by the cooktop.
The cooktop should be easy to reach and lighted
with natural light during the day.
Always disconnect the electrical service to the
cooktop before repairing or servicing the cooktop. This can be done by disconnecting the fuse or circuit breaker. Failure to do so could result in a dangerous or fatal shock. Know where your main disconnect switch is located. If you do not know, have your electrician show you.
ELECTRICAL REQUIREMENTS
This appliance must be supplied with the proper voltage and frequency, and connected to an individual, properly grounded branch circuit, protected by a circuit breaker or fuse, having amperage as noted on rating plate. (Rating Plate is located on cooktop.)
We recommend you have the electrical wiring and hookup of your cooktop connected by a qualified electrician. After installation, have the electrician show you where your main cooktop disconnect is located.
Check with your local utilities for electrical codes which apply in your area. Failure to wire your cooktop according to governing codes could result in a hazardous condition. If there are not local codes, your cooktop must be wired and fused to meet the requirements of CSA.
You must use a three-wire, single-phase A.C. 208/120 Volt or 240/120 Volt, 60 hertz electrical system. If you connect to aluminum wiring, properly installed connectors approved for use with aluminum wiring must be used.
2
Installation Instructions
PRE-INSTALLATION CHECKLIST
A
Remove Installation Instructions from literature
CAUTION:
cooktop supply line must be shut off whilecooktop supply line must be shut off while
cooktop supply line must be shut off while
cooktop supply line must be shut off whilecooktop supply line must be shut off while connections are being made. Failure to doconnections are being made. Failure to do
connections are being made. Failure to do
connections are being made. Failure to doconnections are being made. Failure to do so could result in serious injury or death.so could result in serious injury or death.
so could result in serious injury or death.
so could result in serious injury or death.so could result in serious injury or death.
The electrical power to theThe electrical power to the
The electrical power to the
The electrical power to theThe electrical power to the
When preparing cooktop opening, make sure that
the inside of the cabinet and the cooktop do not interfere with each other.
Remove packaging materials and literature from the
cooktop before beginning installation.
Literature
Package
Styro Foam
Packaging
pack and read them carefully before you begin. Be sure to place all literature, Owner’s Manual, Installations, etc. in a safe place for future reference.
Installation Instructions
If you have questions, call 800-GECARES or visit our Website at: www.GEAppliances.com
CAUTION:
Read these instructions carefully and completely.
IMPORTANT –
inspector’s use.
IMPORTANT –
ordinances.
Note to Installer – Be sure to leave these instructions with
the Consumer.
Note to Consumer – Keep these instructions for future
reference.
PARTS INCLUDED
4 screws
MATERIALS NEEDED
Junction Box
Pub. No. 31-10428
229C
4053P127
30” Electric Cooktop
JCP340BC, JCP340WC, JCP350BC, JCP350WC, JCP930BC, JCP930SC, JCP930TC
BEFORE YOU BEGIN
Save these instructions for local
Observe all governing codes and
Foam Strips
2 Hold Down Brackets
Wire Nuts
NOTE: This appliance must be properly grounded.
Skill level – Installation of this appliance requires basic
mechanical and electrical skills.
Completion time – 2–3 hours.
Proper installation is the responsibility of the installer.
Product failure due to improper installation is not
covered under the Warranty.
TOOLS YOU WILL NEED
1/8” Drill Bit &
Phillips
Electric or Hand Drill
Screwdriver
Ruler or Straightedge
11
1
11
Hand or Saber Saw
Pencil
HOT
Cooktop
Make sure you have all the tools and materials you
need before starting the installation of the cooktop.
ON
Your home must provide the adequate electrical
service needed to safely and properly use your cooktop.
Make sure that the addition of the cooktop will not
overload the household circuit on which it is used.
When installing your cooktop in your home, make
sure that all local codes and ordinances are followed exactly as stated.
3
Loading...
+ 5 hidden pages