Mini Wireless Optical Mouse
Instruction Manual
HO97985
www.jascoproducts.com
TABLE OF CONTENTS
1. PACKAGE CONTENTS ---------------------------------------3
2. SYSTEM REQUIREMENTS ---------------------------------3
3. SPECIAL MOUSE FUNCTIONS ----------------------------3
4. BATTERY INSTALLATION----------------------------------4
5. HARDWARE INSTALLATION------------------------------5
6. SOFTWARE INSTALLATION -------------------------------6
7. UNINSTALL MOUSE SOFTWARE----------------------- 15
8. TROUBLE SHOOTING ------------------------------------- 17
9. FIVE YEAR LIMITED WARRANTY -------------------- 19
10. FCC STATEMENT ---------------------------------------- 20
Page 2
1. Package Contents
• Mini Wireless Optical Mouse • Mini USB Receiver
• Mini Software CD • Mini Instruction Manual
• 2 AAA Batteries • Travel Bag
2. System Requirements
• Windows® 98 SE or higher • Available USB Port
• CD-ROM drive
3. Special Mouse Functions
• To turn your mouse off while traveling, press and hold the
scroll wheel button. While pressing the scroll wheel button,
press the link button on the bottom of the mouse. To turn the
mouse on repeat this process.
• The mouse will go to sleep when idle for a long period of time
to save batteries. To wake the mouse, press any mouse button.
• When the Low Battery LED (located near the scroll wheel) is
illuminated, change the batteries. See Section 4. You will need
to re-link your mouse. See Section 5.
Page 3
4. Battery Installation
FRONT BACK
PRESS
PULL
HERE
1) Grip the front of the mouse (the end with the buttons) with
Battery Compartment Cover
your left hand.
2) With your right hand hold the back of the mouse (end opposite
the buttons) with your thumb on the bottom, and your index
finger and middle finger resting on top.
3) Grip the mouse firmly, pressing down slightly on the GE logo
on top of the mouse with the index and middle finger of your
right hand, then pull back to release the battery cover.
4) Set the battery compartment cover aside. Insert 2 AAA
batteries, being sure to match the polarity of the batteries with
the polarity markings inside the battery compartment.
5) Replace the battery compartment cover.
6) Re-link your mouse. See Section 5.
Page 4
5. Hardware Installation
Please keep these directions in a safe place. Each time you replace
the batteries you will need to re-link your mouse.
1) Insert the enclosed batteries into the battery compartment of
your mouse following the directions in Section 3.
2) Plug the Optical Mini Mouse receiver into an available USB
port on your computer or USB hub. It is not necessary to
reboot your computer.
3) If prompted, insert your Windows disk and follow the on
screen instructions. (This step is not necessary for all
operating systems. Your system will prompt you if it is
necessary.)
4) Press the link button on your receiver.
5) Press the link button on the bottom of your mouse.
6) Your mouse should now function normally. Move your mouse
to test functionality.
Page 5
6. Software Installation
The mouse will function normally without the included software.
The software is only necessary to program the function of the scroll
wheel. It is always a good idea to back up your system before adding
any new software to your computer.
1) Uninstall any previously installed third-party mouse software.
DO NOT uninstall the standard Microsoft mouse driver.
To do this, please consult the user’s manual for your existing
software. (In most cases you will use “Add/Remove
Programs” in the Control Panel. The Control Panel is located
in the Start Menu. In some operating systems, the Control
Panel is located under “Settings” in the Start Menu.)
2) Close all open applications, then insert the included CD into
your CD drive.
Page 6
3) If the CD does not run automatically, open My Computer.
Double-click on your CD Drive. Double-click on Setup. The
CD should run.
4) Follow the on screen instructions to complete the software
installation
a) Select “English” and click Next.
Page 7
b) Click Next on the Welcome Screen.
Page 8