GE GFWN1100L Specification

GFWN1100L

GE® EnErgy Star® 3.5 DOE Cu. Ft. Capacity Frontload Washer with Stainless Steel Basket

Dimensions and Installation Information (in inches)

Installation Information: For complete information, see installation instructions packed with your washer.

31-1/4	1-5/8
	1-5/8
	41-1/2

For answers to your Monogram,® GE Profile™ or GE® appliance questions, visit our website at geappliances.com or call GE Answer Center® service, 800.626.2000.

Above illustration intended for dimensional reference only. Refer to photography for actual product appearance.

Listed by

Underwriters

Laboratories

Specification Revised 4/11

360478

GFWN1100L

GE® EnErgy Star® 3.5 DOE Cu. Ft. Capacity Frontload Washer with Stainless Steel Basket

Special Installation Requirements:

Stacked Installation:

•Brackets for stacking dryer over washer are not included with the washer.

Order part no. GEFLSTACK or part no. WE25X10018.

Alcove or Closet Installation:

•If your dryer is approved for installation in an alcove or closet, it will be stated on a label on the dryer back.

•The dryer MUST be exhausted to the outside.

•Minimum clearances between dryer cabinet and adjacent walls or other surfaces are: 0" either side, 3" front and rear

•Minimum vertical space from floor to overhead cabinets, ceilings, etc. is 52".

•Closet doors must be louvered or otherwise ventilated and must contain a minimum of 60 sq. in. of open area equally distributed. If this closet contains both a washer and a dryer, doors must contain a minimum of 120 sq. in. of open area equally distributed.

•No other fuel-burning appliance shall be installed in the same closet with a gas dryer.

Bathroom or Bedroom Installation:

•The dryer MUST be exhausted to the outdoors.

•The installation must conform with the local codes, or in the absence of local codes, with the National Fuel Gas Code, ANSI Z223.

Minimum Clearance other than Alcove or Closet Installations:

• Minimum clearances to combustible surfaces 0" both sides, 3" rear.

For more information on venting kits and accessories, please call 1-800-GE-CARES.

For answers to your Monogram,® GE Profile™ or GE® appliance questions, visit our website at geappliances.com or call GE Answer Center® service, 800.626.2000.

Stacked Dimensions (in inches)

Pedestal Dimensions (in inches) SBSD137HWW - white

This optional 13" pedestal raises the door opening and height of the washer or dryer. Feet on 13" pedestal allow it to adjust to 13-3/8" height.

80-1/8

28-3/4

Above illustrations intended for dimensional reference only. Refer to photography for actual product appearance.

Listed by Underwriters Laboratories

Specification Revised 4/11

360478

+ 1 hidden pages