GE GFDR270EH0WW, GFDR270GH0WW, GFDR275EH0MC, GFDR275GH0MC, GFDR480EF0WW Installation Guide

o,_h_,t_ _'_'_J_F°_!_'_c _¸ _ _ _°_t_"_'fd_hy_

/' h............. c,<.... c,<

Appliances

Procedure for Programming Controls: WEO4X23216

and WEO4X23220

When replacing the User Interface control, the dryer will not function properly until the replacement
control has been programmed.
Once the UI has been replaced, it may sometimes power up with all of the UI LEDs blinking. If this is the

case, follow only Steps 5-10 below. Otherwise, follow all of the steps from the beginning.

Step 1

Begin with the dryer in Idle Mode (all LEDs on display off).

Step 2

Press the following key sequence to enter Service Mode:
Ply Cycle --> Delay Dry --> Ply Cycle --> Delay Dry

Note: The sequence must be done in order. If there are any other button presses or buttons are pressed out of order,
the sequence must be started from the beginning.

Step 3

Upon entering the Service Mode, the Ul will be in Test Selection Mode and will show "tl" (Test Number 1).

Step 4

Press the Start/Pause button when "tl" is displayed.

Step 5

Simultaneously press and hold both the Tamp & Level buttons for three seconds to prepare the Ul for selecting the model.

Step 6

Press the Level button to increase or press the Tamp button to decrease the Model Code number selection until the
correct number is displayed, per the table below.

Dryer Model Number Catalog # Model Code

GFDS260EFWW / GFDS260GFWW WE04X23220 001

GFDS265EFPlC / GFDS265GFMC

GFDS265EFRR / GFDS265GFRR

GFDR270EHWW / GFDR270GHWW WE04X23216 001

GFDR275EHMC / GFDR275GHMC

GHDS360EFWW / GHDS360GFWW WE04X23220 002

GHDS365EFPlC / GHDS365GFMC

GHDS365EFRR / GHDS365GFRR

GFDS480EFWW / GFDS480GFWW WE04X23220 003

GFDS485EFPlC / GFDS485GFMC

GFDS485EFRR / GFDS485GFRR

Step 7

Press the Start/Pause button to temporarily save the Ul Model Code number.

Step 8

Next, the Heater Type selection is displayed as "g" for Gas or "E" for Electric. Press the Temp or Level to alternate the
7-segment display between the two Heater Type selections.

Step 9

Press and hold the Start/Pause button for three seconds to set the Heater Type. The board will then return to an idle state
and will exit the Service Mode. It could take up to 10 seconds for the dryer to respond after exiting the Service Mode.

Step 10

The dryer is now ready for use.
Note: If the above sequence is interrupted at any time, the Ul Model and Heater Type will not be saved properly.

If an error is made in selecting the correct model number or heater type, repeat the steps.

GEAppliances & Lighting
General Electric Company

Louisville, KY40225
GEAppliances.com

WH00×718

31-16724-305-15GE