GE GFD55GSSN, GFD55GSPN Specification
GFD55GSSN/GSPN
GE® 7.8 cu. ft. Capacity Front Load Gas Dryer
DIMENSIONS AND INSTALLATION INFORMATION (IN INCHES)
GAS DRYER RATING
120V 60Hz, 8A
EXHAUST OPTIONS: 4-way via rear, left, right,
and bottom. (The right, left, and bottom venting
options require Side Vent Kit: GFA28DSVN)
CIRCUIT REQUIREMENTS: An individual,
properly grounded branch circuit, protected by
a 15-20 amp circuit breaker or a time-delay fuse,
is required.
NOTE: Dryer wall outlet must be located within
36" of service cord entry and accessible when dryer
is mounted in position.
INS TA LLATIO N INFO RMATIO N: For complete
information, see installation instructions packed
with your dryer.
OPTIONAL LP CONVERSION KIT: WE25M87
28
32
39-3/4
3-5/8
For answers to your Monogram, GE Café™, GE Profile™ or
GE Appliances product questions, visit our website at
geappliances.com or call GE Answer Center® Service, 800.626.2000.
6-1/8
Specification Revised 2/21
GFD55GSSN/GSPN
GE® 7.8 cu. ft. Capacity Front Load Gas Dryer
STACKED DIMENSIONS
STAC KED I NSTAL L ATION :
Brackets for stacking dryer over washer are not included with the
washer. Order part no. GFA28KITN.
ALCOVE OR CLOSET INSTALLATION:
If your dryer is approved for installation in an alcove or closet, it will
be stated on a label on the dryer back.
The dryer MUST be exhausted to the outside.
Minimum clearances between dryer cabinet and adjacent walls or other
surfaces are: 0" all sides and top.*
Closet doors must be louvered or otherwise ventilated and must
contain a minimum of 60 sq. in. of open area equally distributed. If
this closet contains both a washer and a dryer, doors must contain a
minimum of 120 sq. in. of open area equally distributed.
No other fuel-burning appliance shall be installed in the same closet
with a gas dryer.
BATHROOM OR BEDROOM INSTALLATION:
The dryer MUST be exhausted to the outdoors.
The installation must conform with the local codes, or in the absence
of local codes, with the National Electric Code and National Fuel Gas
Code, ANSI Z223 for gas dryers.
MINIMUM CLEARANCE OTHER THAN ALCOVE OR CLOSET
INS TA LLATIO NS:
Minimum clearances to combustible surfaces 0" all sides and top.*
FOR MORE INFORMATION ON VENTING KITS AND
ACCESSORIES,
PLEASE CALL 1-800-GE-CARES.
(IN INCHES)
PEDESTAL DIMENSIONS
(IN INCHES)
GFP1528PNDG - DIAMOND GRAY
GFP1528PNRS - SAPPHIRE BLUE
GFP1528PNSN - SATIN NICKEL
GFP1528SNWW - WHITE
This optional 16" pedestal raises
the door opening and height of
the washer or dryer.
54-1/2
"
79-1/2
28"
16"
*For improved per formance, a 1/2" clearance is suggested on each side.
For answers to your Monogram, GE Café™, GE Profile™ or
GE Appliances product questions, visit our website at
geappliances.com or call GE Answer Center® Service, 800.626.2000.
28-7/8"
Specification Revised 2/21
Loading...