GE GFD45GSSMWW, GFD45GSPMDG Specifications

GFD45GSSM/GSPM

GE Appliances 7.5 Cu. Ft. Capacity Frontload Dryer With Steam

DIMENSIONS AND INSTALLATION INFORMATION (IN INCHES)

GAS DRYER RATING

120V 60Hz, 6A

EXHAUST OPTIONS: 3-way via rear, left, and
bottom.

CIRCUIT REQUIREMENTS: An individual,
properly grounded branch circuit, protected by a
15-20 amp circuit breaker or a time-delay fuse, is
required.

NOTE: Dryer wall outlet must be located within
36" of service cord entry and accessible when dryer
is mounted in position.

INS TA LLATI O N IN F O RMATI O N: For complete
information, see installation instructions packed
with your dryer.

27

33

39-3/8

4-3/8

5-3/8

For answers to your Monogram, GE Café™ Series, GE Profile™ Series or
GE Appliances product questions, visit our website at geappliances.com
or call GE Answer Center® Service, 800.626.2000.

Speci fication Created 1/18

GFD45GSSM/GSPM

GE Appliances 7.5 Cu. Ft. Capacity Frontload Dryer With Steam

SPECIAL INSTALLATION REQUIREMENTS

STAC KED I NSTAL L ATIO N :

Brackets for stacking dryer over washer are not included with the
washer. Order part no. GEFLSTACK or part no. WE25X10018.

ALCOVE OR CLOSET INSTALLATION:

If your dryer is approved for installation in an alcove or closet, it will
be stated on a label on the dryer back.

The dryer MUST be exhausted to the outside.

Minimum clearances between dryer cabinet and adjacent walls or other
surfaces are: 0" either side, 1" top, front and rear.

Minimum vertical space from floor to overhead cabinets, ceilings, etc.
is 52".

Closet doors must be louvered or otherwise ventilated and must
contain a minimum of 60 sq. in. of open area equally distributed. If
this closet contains both a washer and a dryer, doors must contain a
minimum of 120 sq. in. of open area equally distributed.

No other fuel-burning appliance shall be installed in the same closet
with a gas dryer.

BATHROOM OR BEDROOM INSTALLATION:

The dryer MUST be exhausted to the outdoors.

The installation must conform with the local codes, or in the absence
of local codes, with the National Electric Code and National Fuel Gas
Code, ANSI Z223 for gas dryers.

MINIMUM CLEARANCE OTHER THAN ALCOVE OR CLOSET
INS TA LLATI O NS:

Minimum clearances to combustible surfaces 0" both sides, 3" rear.

FOR MORE INFORMATION ON VENTING KITS AND
ACCESSORIES,
PLEASE CALL 1-800-GE-CARES.

STACKED DIMENSIONS (IN INCHES)

50-5/8

24-7/8

3-1/2

PEDESTAL DIMENSIONS
(IN INCHES)
SBSD137HWW - WHITE

This optional 13" pedestal
raises the door opening and
height of the washer or dryer.
Feet on 13" pedestal allow it to
adjust to 13-3/8" height.

3

39-3/8

13"

79-5/8"

27"

28-3/4"

For answers to your Monogram, GE Café™ Series, GE Profile™ Series or
GE Appliances product questions, visit our website at geappliances.com
or call GE Answer Center® Service, 800.626.2000.

Speci fication Created 1/18