
WCVH4800K/4815K
GE® 2.2 DOE Cu. Ft. Capacity Frontload Washer with Stainless Steel Basket
Dimensions and Installation Information (in inches)
Installation Information: For complete information, see
installation instructions packed with your washer.
WRINKLE FREE
COLORS / NORMAL
ACTIVE WEAR
WHITES / HEAVY DUTY
DELICATES
WASH RINSEPRESPINEXTRA
HAND WASH
SPEED WASH
DELAY
DOOR LOCKED
EXTRA LIGHT
E
STIMATED TIME REMAINING
RINSE & SPIN
DRAIN
SPIN
&
BASKETCLEAN
BLEACH ONLY
POWER
POWER
DELAY START
XTRA HIGH EXTRA HEAVY
ANITIZE
E
S
HEAVY
HIGH
HOT
EXTRA RINSE
NORMAL
MEDIUM
WARM
LIGHT
LOW
COLD
MY CYCLE
NO SPIN
TAP COLD
HOLD 3
START
START
SECONDS
TO STORE
PAUSE
S
PAUSE
S
T
OIL
PIN
EMP
IGNAL
S
HOLD 3 SECS TO
HOLD 3 SECS TO
LOCK & UNLOCK
LOCK & UNLOCK
CONTROL PANEL
CONTROL PANEL
For answers to your Monogram,® Profile™
Series or GE® appliance questions, visit our
website at geappliances.com or call GE
Answer Center® service, 800.626.2000.
Specification Revised 3/13
Listed by
Underwriters
Laboratories
360422

WCVH4800K/4815K
GE® 2.2 DOE Cu. Ft. Capacity Frontload Washer with Stainless Steel Basket
Special Installation Requirements:
• Drain hose extension part number WH41X10082 (sold separately)
Stacked Installation:
• Kit for stacking dryer over washer are is not included with the washer.
Order part no. GE24STACK.
Alcove or Closet Installation:
• If your dryer is approved for installation in an alcove or closet, it will be
stated on a label on the dryer back.
• The dryer MUST be exhausted to the outside with the exeption of the condensing dryer.
• Minimum clearances between dryer cabinet and adjacent walls or other surfaces are:
0" either side, 3" front and rear
• Minimum vertical space from floor to overhead cabinets, ceilings, etc. is 52".
• Closet doors must be louvered or otherwise ventilated and must contain a
minimum of 60 sq. in. of open area equally distributed. If this closet contains
both a washer and a dryer, doors must contain a minimum of 120 sq. in. of
open area equally distributed.
• No other fuel-burning appliance shall be installed in the same closet with a gas dryer.
Bathroom or Bedroom Installation:
• The dryer MUST be exhausted to the outdoors with the exeption of the condensing dryer.
• The installation must conform with the local codes, or in the absence of
local codes, with the National Electric Code and National Fuel Gas Code,
ANSI Z223 for gas dryers.
Minimum Clearance other than Alcove or Closet Installations:
• Minimum clearances to combustible surfaces 0" both sides, 3" rear.
For more information on venting kits and accessories,
please call 1-800-GE-CARES.
Stacked Dimensions (in inches)
23 3/4”
23 1/2”
WRINKLE FREE
MIXED LOAD
SENSOR DRY
ACTIVE WEAR
COTTONS
POWER
POWER
DELICATES
SPEED DRY
T
IME DRY
WARM UP
DEWRINKLE
TIMED DRY
ACTIVE WEAR
DELICATES
HAND WASH
SPEED WASH
RINSE & SPIN
DRAIN & SPIN
DELAY START
80
ANTI-BACTERIAL
EXTRA DRY
DRYING COOLDOWNDAMP
70
M
HIGH
ORE DRY
EXTEND TUMBLE
60
50
DRY
MEDIUM
40
30
LOW
LESS DRY
CLEAN LINT FILTERDELAY
20
DAMP ALERT
EXTRA LOW
10
DAMP
E
STIMATED TIME REMAINING
START
START
PAUSE
PAUSE
T
IMESENSORTEMP
SIGNAL
AIR FLUFF
NO HEAT
ADJUST
ADJUST
HOLD 3 SECS TO
HOLD 3 SECS TO
TIME DRY
TIME DRY
LOCK & UNLOCK
LOCK & UNLOCK
CONTROL PANEL
CONTROL PANEL
WRINKLE FREE
COLORS / NORMAL
WHITES / HEAVY DUTY
POWER
POWER
DELAY START
EXTRA HIGH EXTRA HEAVY
SANITIZE
WASH RINSEPRESPINEXTRA
HEAVY
HIGH
HOT
EXTRA RINSE
NORMAL
MEDIUM
WARM
LIGHT
LOW
COLD
DELAY
DOOR LOCKED
MY CYCLE
EXTRA LIGHT
NO SPIN
TAP COLD
HOLD 3
E
STIMATED TIME REMAINING
START
START
SECONDS
TO STORE
PAUSE
PAUSE
SOIL
SPIN
TEMP
SIGNAL
BASKETCLEAN
BLEACH ONLY
HOLD 3 SECS TO
HOLD 3 SECS TO
LOCK & UNLOCK
LOCK & UNLOCK
CONTROL PANEL
CONTROL PANEL
26 1/2”
23 3/4”
4”
For answers to your Monogram,® Profile™
Series or GE® appliance questions, visit our
website at geappliances.com or call GE
Answer Center® service, 800.626.2000.
Specification Revised 3/13
Listed by
Underwriters
Laboratories
360422