GE Easy Touch 681131066136, Easy Touch 681131066938, Easy Touch GE106613, Easy Touch GE106693 Owner's Manual

Item Stock Number
GE106613

UPC:
681131066136

Item Stock Number
GE106693

UPC:
681131066938

Easy Touch®Can Opener

For product service, call customer service at [phone]

GE106613:

681131066136 •

GE106693:

681131066938

How to Sharpen Knives

Do not attempt to sharpen hollow ground blades or those with serrated edges.

1. Be sure knife is clean and free of
grease.

2. Place heel of knife into the guide
slot located on the side of the can
opener. Lightly draw the blade
towards you, applying a slight
downward pressure. Repeat this
procedure four to five times to put
on a “factory sharp” edge.

1. Read all instructions.

2. To protect against risk of electrical

shock, do not immerse cord, plug
or motor unit in water or other
liquid.

3. Close supervision is necessary when
any appliance is used by or near
children.

4. Unplug from outlet when not in
use, before putting on or taking off
parts, and before cleaning.

5. Avoid contacting moving parts.

6. Do not operate any appliance with a

damaged cord or plug, or after the
appliance malfunctions or is
dropped or damaged in any

manner. Call Customer Service (see
warranty) to return for
examination, repair, or electrical or
mechanical adjustment.

7. The use of attachments not
recommended or sold by
manufacturer may cause fire,
electric shock or injury.

8. Do not use outdoors.

9. Do not let cord hang over edge of

table or counter, or contact hot
surfaces, including the stove.

10. Do not open pressurized (aerosol­type) cans or cans of flammable
liquids, such as lighter fluids.

IMPORTANT SAFEGUARDS

SAVE THESE INSTRUCTIONS!

When using electrical appliances, basic safety precautions should always be
followed, including the following:

Parts and Features

Piercing Lever

Cutting Blade

Feed Wheel

Can Rest

Magnet

1

2

3

4

5

12

3

5

4

How to Open Cans

1. Plug cord into 120 volt, AC outlet.

2. Raise piercing lever, tilt can so that

the rim of the can rests on the edge
of the feed wheel, lower the lever
until the blade pierces the can.

3. Press lever down all the way to pierce
lid and start cutting action. “Power
Pierce” feature: When you press
lever, motor will start rotating can for
easier piercing.

4. Let go of lever and can opener will
continue cutting and will stop
automatically when can has been

How to Clean Blade Assembly

Never submerge can opener in water.

1. Unplug cord.

2. Wipe can opener with a damp cloth.

Clean around blade area with
toothpick or cotton swab if
necessary.

This appliance has a polarized plug
(one blade is wider than the other).
As a safety feature, this plug will fit in a
polarized outlet only one way. If the
plug does not fit fully in the outlet,
reverse the plug. If it still does not fit,

contact a qualified electrician. Do not
attempt to defeat this safety feature.

CAUTION: To reduce the risk of electric
shock, do not immerse the can opener in
water.

Consumer Safety Information

THIS APPLIANCE IS INTENDED FOR HOUSEHOLD USE ONLY.