GE DXR500L Operating Manual
GE
Sensing & Inspection Technologies
DXR500L
Direct Radiography
Designed for industrial use, the DXR500L provides the
highest image quality in a rugged production environment.
The DXR500L allows for easy detection of subtle indications.
Utilizing Endurance™ technology, developed specically to
reduce radiation wear out and to maximize cost savings. GE
Sensing & Inspection Technologies detectors incorporate
a temperature controller, allowing for longer calibration
intervals and quick, consistent images. DXR500L provides
application results efciently with a cycle time reduction.
Features and Benets
• High-resolution images for easy detection of subtle
indications
• Endurance™ scintillator technology reduces
radiation wear out
• Temperature controlled for stable offsets over longer
periods, enabling more consistent imaging and fewer
calibrations
Applications
• Aerospace investment castings
• Industrial gas turbine investment castings
• Wax and ceramic patterns
• Metrology
• Materials science/geology
Al-6061
Ti-6Al4V
Detector Characterization Charts
The detector characterization charts provided on the left
are completed in accordance to ASTM E2507-07 Standard
Practice for the Manufacturing Characterization of Digital
Detector Arrays. This standard allows for the direct
comparison of DDAs by ensuring data is collected and
reported in a consistent and specied manner. The standard
also enables guidance for the appropriate pairings of
detectors with applications.
Pixels are identied as bad per one or more of the seven
denitions described in the ASTM E2597-07 document.
The pixels marked as bad will be corrected through GE’s
software utilizing data collected from good neighborhood
pixels.
Inconel 718
Technical Specifications
Detector Specications
Flat Panel Type Amorphous Silicon
Scintillator Material CsI
Active Area (approx.) 307 x 240 mm (12 x 9 in)
Image Format 3072x2400
Pixel Pitch 100µm
A/D Conversion 14 bits
Minimum Exposure Time 375ms
Interface Gigabit Ethernet
Dynamic Range 10,000:1
Dimensions 356 x 360 x 122.5mm
Weight 15 kg (33 lb)
Operating Temperature 10° to 35° C (50° to 95° F)
Operating Humidity 10-90% non-condensing
Power Supply
Voltage 100-240V, 50-60Hz
UT Output Connector 163 x 287 x 56 mm (6 x 11 x 2 in)
Weight 3 kg (7 lb)
Temperature Controller
Voltage 100-240V, 50-60Hz
Dimensions 220 x 286 x 382 mm (9 x 11 x 15 in)
Weight 8 kg (19 lb)
www.gesensinginspection.com
GEIT-40045EN (11/09)
© 2009 General Electric Company. All Rights Reserved. Specications are subject to change without notice. GE is a registered trademark of General Electric Company. Other company or product names mentioned in this document may be trademarks or registered trademarks of their respective companies, which are not afliated with GE.
Loading...