GE DXR250RT Operating Manual

GE

Inspection Technologies

DXR250RT

Direct Radiography

Optimized for industrial use, the DXR250RT provides very
quick image acquisition while maintaining it’s full resolving
capabilities. Utilizing Endurance™ scintillator technology,
the DXR250RT is able to provide the premium image quality
of a CsI detector without the typical image lag limitations
of CsI. GE detectors incorporate a temperature controller,
allowing for longer calibration intervals and quick consistent
images. The DXR250RT allows for fast applications results

without sacricing image quality.

Features and Benets

• Quick image acquisition rates (30 fps) with full-resolution

and corrections applied

• Endurance technology for optimal image quality and lag

• Temperature controller for stable offsets over longer

periods, enabling more consistent imaging and fewer
calibrations

Applications

• High throughput castings

• Pipe manufacturing

• Electronics

• Integrated manipulation systems

Al-6061

Ti-6Al4V

Detector Characterization Charts

The detector characterization charts provided on the left

are completed in accordance to ASTM E2597-07 Standard
Practice for the Manufacturing Characterization of Digital

Detector Arrays. This standard allows for the direct
comparison of DDAs by ensuring data is collected and

reported in a consistent and specied manner. The standard

also enables guidance for the appropriate pairings of
detectors with applications.

Pixels are identied as bad per one or more of the seven
denitions described in the ASTM E2597-07 document.
The pixels marked as bad will be corrected through GE’s

software utilizing data collected from good neighborhood

pixels.

Inconel 718

Technical Specifications

Detector Specications

Flat Panel Type Amorphous Silicon
Scintillator Material CsI

Active Area (approx.) 205 x 205 mm (8 x 8 in)
Image Formate 1024 x 1024
Pixel Pitch 200µm

A/D Conversion 14 bits

Max. Frame Rate 30 fps

Interface Fiber Optic
Dynamic Range 10,000:1
Dimensions 260 x 260 x 114.3 mm
Weight 14 kg (31 lb)
Operating Temperature 10° to 35° C (50° to 95° F)

Operating Humidity 10-90% non-condensing

Power Supply

Voltage 100-240V, 50-60Hz
UT Output Connector 163 x 287 x 56 mm (6 x 11 x 2 in)
Weight 3 kg (7 lb)

Temperature Controller

Voltage 100-240V, 50-60Hz
Dimensions 220 x 286 x 382 mm (9 x 11 x 15 in)
Weight 8 kg (19 lb)

www.gsensinginspection.com

GEIT-40049EN (03/10)

© 2010 General Electric Company. All Rights Reserved. Specications are subject to change without notice. GE is a registered trademark of General Electric Company. Other company or product names menti-

oned in this document may be trademarks or registered trademarks of their respective companies, which are not afliated with GE.