GE CGU366SEHSS Specification Sheet

CGU366SEH

Front of deep cabinets can align
with control panel beveled edge.

GE Café™ Series 36" Gas Rangetop with 6 Burners (Natural Gas)

DIMENSIONS AND INSTALLATION INFORMATION

Professional rangetops offer a number of choices in
size and rangetop configurations.

PRODUCT DIMENSIONS AND CLEARANCE:
A 36"- or 42"-wide professional vent hood with
a minimum 480 CFM is recommended for
installation over this rangetop.

Clearances between rangetop and side wall or
combustible material must be at least 12" on each
side.

Allow 8" free space below the top surface of
countertop. Allow additional clearances below the
burner box to install the regulator and make house
gas supply connections. Use a 90° elbow to route
the gas connections and limit interference with
drawers or other cabinetry.

* The opening between a 4" high backsplash must
be 36" to allow the rangetop to slide back against
the wall.

Control panel projects forward
from standard-depth cabinets.

WAR NING: Installations without a hood require
48" minimum to combustibles above the rangetop.
A custom hood installation with exposed horizontal
combustible surfaces must have an "auto-on" feature.
Refer to hood installation instructions for specific
hood clearances. The surface of the entire back wall
above the countertop and below the hood must be
covered with a non-combustible material such as
metal, ceramic tile, brick, marble or other stone.

For answers to your Monogram, GE Café™ Series, GE Profile™ Series or
GE Appliances product questions, visit our website at geappliances.com
or call GE Answer Center® Service, 800.626.2000.

Front of deep cabinets can align
with control panel beveled edge.

Speci fication Rev ised 5/16

CGU366SEH

GE Café™ Series 36" Gas Rangetop with 6 Burners (Natural Gas)

DIMENSIONS AND INSTALLATION INFORMATION

BACKSPLASH ACCESSORIES: The rangetop requires a 12" minimum
clearance to a vertical combustible surface at the rear. A backsplash
is required for installations with less than 12" clearance. The following
backsplash accessories are available, or a custom, non-combustible
backsplash can be used.

ZX12B36PSS, 12" backsplash

ZXADJB36PSS, 30"-36" adjustable-height backsplash with warming shelf

BACKSPLASH WITH WARMING SHELF: All Professional Hoods
feature infrared warming lights. The 30"-36" adjustable backsplash with
warming shelf is a perfect complement when installed with the tapered or
straight-sided hoods.

- Restaurant-Style Professional Hoods are shipped with a 22" stainless
steel backsplash and warming shelf.

ADVANCE PLANNING FOR 36" PROFESSIONAL RANGETOPS:

Professional rangetops offer a number of choices in size and rangetop
configurations.

- All Professional rangetops are factory set for natural or liquid propane
gas. The correct model should be ordered for the installation situation.

NOTE: Conversion kits are included with the rangetop if the wrong gas
type was ordered. High Altitude kit, WB28K10553, is also available. The
kits must be installed by a qualified service technician at additional cost.

ELECTRICAL REQUIREMENTS: Rangetops must be supplied with
120V, 60Hz, and connected to an individual, properly grounded branch
circuit protected by a 15 amp circuit breaker or time-delay fuse.

GAS SUPPLY:

- Natural gas models are designed to operate at 5" water column
pressure. For proper operation, the pressure of the natural gas supplied
to the regulator must be between 7” and 13” water column.

- The liquid propane models are designed to operate at 10" water
column pressure. For proper operation, the pressure of the LP source
to the regulator must be between 11” and 13” water column.

Side View with a Backsplash

Universal Utility Locations

For answers to your Monogram, GE Café™ Series, GE Profile™ Series or
GE Appliances product questions, visit our website at geappliances.com
or call GE Answer Center® Service, 800.626.2000.

Speci fication Rev ised 5/16