GE 56789 User Manual

MAGNETIC

2. Push the 'Battery Test' pushbutton in the battery

OPERATION

SENSOR

compartment. If the green light illuminates, the battery is still good. If it fails to illuminate,

SIREN

replace all batteries.
3. Insert (4) LR44 button batteries noting polarity.

ON/OFF

4. Replace battery compartment cover.
IMPORTANT: Remove batteries before storing the
BAHERY
COMPARTMENT
Alarm for extended periods. Batteries corrode over time and may cause permanent damage to the unit.
Different types of batteries or new and used batteries should not be mixed. Depleted batteries should be removed from the unit and disposed of properly.

GAP BETWEEN ALARM AND MAGNETIC SENSOR

INSTALLATION

(Alsmi is activated when switched ON and gap between
Using the double sided adhesive tape provided,
mount the alarm and magnetic sensor on window,

BATTERY TEST AND INSTALLATION

door, or cabinet to be protected, placing one of the
1. To arm the unit, slide cover off the battery
compartment located on the front of the main unit. Toggle ON/OFF switch to the ON position.
The window on the housing will become red.
Replace battery compartment cover. Whenever the protected window, door or cabinet is opened (causing the alarm to be separated from the magnetic sensor by more than 0.5"), the alarm siren will sound continuously until disarmed.
2. To disarm the unit, slide cover off the battery
compartment. Toggle ON/OFF switch to OFF
Position. Make sure the window, door or
cabinet is closed before rearming.
NOTE: To test, a cloth can be used to cover
the alarm to reduce risk of hearing damage.
The Magnetic Window Alarm reguires (4) L044 button batteries (included). Average battery life for typical usage is 1 year.
1. Slide cover off the battery compartment located on the front of the main unit.
units on the part of the fixture that opens (window) and the other unit on the stationary part of the fixture (frame). Mount so that when the window, door or cabinet is closed, the gap between the alarm and sensor is no more than 0.5" (preferably less).
1
2

CARE AND MAINTENANCE

To clean the unit housing, use a soft cloth slightly
dampened with water and wipe dry. Do not use chemical agents as this may damage and discolor the unit.
3
performance and audible alarm signals may be outside of

WAR NING

Limitations of Alarm Products

This product should be tested weekly to make sure it is working
properly. The product, if used properly, may reduce the risk of burglary, robbery, fire, or other adverse events. However,
JASCO is not an insurer, this product is neither insurance nor a
guarantee that such an event will be prevented, and users should protect themselves with proper insurance. JASCO makes no representation that this product cannot be compromised or circumvented, that it will provide an adequate
warning, or that it will prevent any personal injuries, property
damage, or other losses. Like any alarm product, including expensive commercial systems, it may be bypassed, it is subject
hearing range, muted by doors, walls, and floors, unheard by deep sleepers or the hearing-impaired, or overwhelmed by other sounds.
90
DAY LIMITED WARRANTY:
productto be free from manufacturing defects for a period of ninety days
from the original date of consumer purchase. This warranty is limited to the
repair or replacement of this product only and does not extend to
consequential or incidental damage to other products that may be used with this unit This warranty is in lieu of all other warranties express or implied. Some states do not allow limitations on how long an implied warranty lasts
or perm it the exclusion or limitation of incidental or consequential damages, so the above limitations may not apply to you. This warranty gives you specific rights, and you may also have other rights which vary from state to state. If unit should prove defective within the warranty period, return
Magne ti c W ind ow Ala rm

User's Manual

For In d o or Us e O nl y
Jasco Products Company \warrants this
Do N ot U se in W e t L o ca t io n s

A W ARNI NG

Risk of personal injury
• Prolonged exposure to alarm sjren
jna^cause^emi^^
to compromise, and it may fail to warn for a variety of reasons,
including, but not limited to: improper installation or positioning; improper maintenance: tampering; dead or improperly installed batteries: sensing limitations; component failures; smoke may not reach detectors; for wireless systems, the functional range may be adversely affected by certain environmental conditions,
radio frequency interference and obstructions between the transmitters and receivers; for systems using telephone lines, the lines may be out of service or disrupted; for infrared
products, intrusions may be outside of a product's designed
range and certain environmental conditions may impact
prepaid with dated proof of purchase to: Jasco Products Company 311 N.W. 122nd
Oklahoma City, OK. 73114
is a trademark of General Electric Company
and is used under license to Jasco Products Company LLC, 311 N.W. 122nd Street,
Oklahoma City, OK 73114
Or visit us at www.jascoproducts.com
4
5
567 8 9 12/05/ 0 5
Batteries may leak harmful liquids or ignitable materials or explode causing injury and product damage
• Do not mix old and new or other battery types
• Replace all batteries at the same time
• Replace fully discharged
batteries immediately
Loading...