GBC System Two Instruction Manual

GBC System Two

Binding Machine

Instruction Manual

For Models:

GBC VeloBind System Two
GBC SureBind System Two

SYSTEM TWO

OPERATING INSTRUCTIO NS

Punching

1. Adjust the punch edge guide to the correct paper length. Check the punch
alignment by punching a sheet of paper and folding it in half along the
punched edge (See Figure 4-1). Match the holes up; if the corners of the
paper match with no overlap, the alignment is correct. If not, readjust the
guide and repeat the process until the edges are square.

2. Place the paper fully in the punch throat, slide the paper to the left against
the punch edge guide, and press the punch button.

3. To prevent jamming, only 22 sheets of 20 pound bond paper should be
punched at one time (fewer sheets if the paper is heavier). Punch one 22
sheet segment of your document at a time, and stack the punched sections
on the binding surface. Do not punch more than 4 composition covers or 3
plastic covers at one time.

4. If you try to punch too much paper the Jam-Stopper feature will sense the
high paper load, retract the punch pins, and you will hear a beeping sound.
Simply separate the paper stack, and punch fewer pages at a time.

Figure 4- 1