Gasmate PO106 User Manual

3189 05/11

Important: Retain these instructions for future use.

Gasmate® is a registered trademark of: Sitro Group Australia Pty Ltd www.gasmate.com.au

Aber, Hamilton, N.Z. www.gasmate.co.nz

Pizza Oven with Light

FOR OUTDOOR USE ONLY

• Deluxe outdoor oven for versatile cooking -

from cooking pizzas with a delicious wood fired
flavour to a beautifully cooked roast dinner

• Cooks up to 3 pizzas at a time

• Convenient electronic ignition

• Cool touch heat resistant handle

• Includes food safe ceramic pizza stone

• Powerful 22MJ/h stainless steel burner

• Large viewing window with temperature gauge

• Easy clean vitreous enamel interior

• Tested to NZ Standards

• Operates on LPG

Model No. PO106

2

Gas Installation Codes

• Appliances must be used in accordance with
New Zealand Standard 5261 “Gas Installations”.

• Appliances for use with bottled gas are labelled
‘LPG’.

Clearances

Minimum Clearances from combustible materials
must be:
Rear - 350mm Sides - 300mm Above - 600mm

Hose & Regulator Safety

The regulator and hose assembly supplied with the
appliance are suitable for LPG only.

A gas regulator adjusted to have an outlet
pressure of 2.75kPA is supplied for connection to
the LPG cylinder. The pressure regulator and
hose assembly supplied with the appliance
must be used. Replacement pressure regulators
and hose assemblies must be those specified by
the appliance manufacturer.

When connecting the hose and regulator assembly
to the gas cylinder, take care to avoid unnecessary

twisting or kinking of the flexible hose.

After the assembly has been secured, turn on the
gas and check for leaks by brushing a soap and
water solution over all connections.

If you are unable to correct the leak by tightening
the connections, turn off the gas and contact the
supplier immediately.

Always ensure the appliance is kept away from

flammable materials and the gas cylinder clear

of any heat source. When changing over from
an empty gas cylinder to a full one make sure

this procedure is carried out in a flame free

atmosphere.

Gas Cylinder Use & Safety

This is a low pressure appliance and must only be
used with the hose and regulator supplied. It is
designed for use with 9Kg LPG cylinders.

The cylinder should be filled by a reputable gas
supplier and visually inspected and re-qualified at
each filling.

Always keep cylinder in an upright position.

GENERAL INFORMATIONCONTENTS

Section Page

General information 2-3

General assembly 4

Lighting procedure 4

Operating procedure 5

Care and maintenance 5

Important safeguards 6

Service and safety 7

Operating instructions 7

Electrical data 7

Assembly instructions 8-10

Usage Tips 11

Side clearances of 300mm must
be maintained to allow adequate

airflow for combustion.

Rear clearance of 350mm must be maintained
to avoid overheating surrounding surfaces.

Safe appliance locations 12

3

Always close the cylinder valve when the appliance
is not in use. Do not subject the cylinder to
excessive heat.

Specifications

Specifications can be found on the data label

attached to body panel.

Never Store your Gas Cylinder Indoors.

If you store your appliance indoors, ALWAYS
disconnect the cylinder first and store it safely

outside. Cylinders must be stored outdoors in a
well ventilated area out of reach of children, and
must not be stored in a building, garage or any
other enclosed area.

WARNING

Failure to comply with these instructions could

result in a fire or explosion which could cause

serious bodily injury, death or property damage.

Accessible parts may be very hot.

Keep young children away.

Any modifications to this appliance may
be dangerous.

Do not move this appliance during use.

Turn off gas supply at the cylinder after use.

Read instructions before using the appliance.

Parts sealed by the manufacturer or their
agent must not be manipulated by the user.

Never operate this appliance without
a regulator

Do not test for gas leaks with an open flame

If this information is not followed exactly, a
fire causing death or serious injury may occur.

Do not store a spare gas cylinder under or
near this appliance. Never fill the cylinder
beyond 85% full. This appliance is only to be
used and stored outdoors.

If you smell gas

1. Shut off gas to the appliance at its source,
if possible.

2. Extinguish any open flame.

3. Open door.

4. If odour continues, immediately call your
gas supplier or fire department.

Do not connect your appliance to a gas
cylinder exceeding 9kg capacity.

Never connect an unregulated gas cylinder.

Read carefully before assembling and operating
your appliance.

Location of your Appliance

DO NOT use in garages, porches, sheds,
breezeways or other enclosed areas. Your
appliance is to be used OUTDOORS and is not
intended to be installed in or on recreational
vehicles and/or boats and should not be placed
on any surface that will burn. Do not obstruct the
flow of combustion and ventilation air around the
outer housing. Side clearance must be 300mm.

Check for any Damage

Contact your supplier for assistance regarding
replacement of any damaged or missing parts.

Do not operate an appliance that appears
damaged.

Protect Children

Keep children away during use and until the
appliance has cooled after you have finished. Do
not allow children to operate the appliance.

Always ensure that no sporting or physical
activities are carried out in close proximity to the
appliance during use and while still hot.

For your safety:

• Do not store or use petrol or other
flammable liquids in the vicinity of this or
any other appliance.

• Do not store empty or full spare gas
cylinders under or near this or any other
appliance.

• Ensure the gas hose is not in contact with
the appliance.

• Keep the gas hose away from hot surfaces

and protect from dripping grease. Avoid
unnecessary twisting of hose. Visually
inspect the hose prior to each use for

cracks, excessive wear or other damage.
Replace the hose if necessary.

• Never test for gas leaks with a lit match or

open flame. Never light with the door closed
or before checking to ensure the burner tube
is fully seated over gas valve orifice.

• Never alter or modify the regulator or gas
supply assembly.

• This appliance must not be used indoors.

• Ensure the appliance is set up on a level

and stable surface.

• Do not move the appliance while in use or
when hot.

• Remove the drip tray before moving.

4

GENERAL ASSEMBLY

Connecting & Disconnecting to
Gas Source

Familiarise yourself with the general information
and safety guidelines located at the front of this
manual.

Check:

1. The cylinder is filled. A sloshing sound will be
heard when shaken.

2. The burner control is in the ‘OFF’ position

Connecting:

1. Ensure cylinder valve is in its full off position.

2. Check for any damage to either the cylinder

connection or the hose. NEVER attempt to use
damaged equipment.

3. When connecting the hose to the cylinder

tighten the nut to a positive stop by hand
or spanner.

4. Open cylinder valve fully. If a leak can be heard

at either end of the hose turn cylinder off and
tighten joint. Wait 5 minutes before re-testing
and use a soapy water solution to check the

joint. If bubbles appear, the connection will
need to be re-tightened.

Disconnecting:

1. Ensure burner control is in the ‘OFF’ position.

2. Ensure cylinder valve is in the full off position.

For storage and cylinder exchange, disconnect
hose at the cylinder only, DO NOT disconnect hose

from appliance.

LIGHTING PROCEDURE

Burner Operation &
Ignition System Check

1. With cylinder valve in ‘OFF’ position press the
electronic ignitor button. Check for sparking to
the burner.

2. If spark is not evident at the burner ignition
point, check that the ignition lead is firmly
attached to the control and sparker tip.

3. Open the door and ensure that it remains
open while lighting the burner.

4. With sparking established turn the cylinder
valve ‘ON’. Then push and turn the control

knob to ‘HIGH’ and press the ignitor button.

5. If the burner fails to light after several attempts
turn off gas supply at cylinder and inspect for
obstructions to gas flow.

If re-ignition is necessary while the appliance is

still hot, you must wait for a minimum of

5 minutes before commencing to re-ignite

(this allows accumulated gas fumes to clear).

IMPORTANT

• Before connecting and disconnecting to gas
source, make sure burner control is in ‘OFF’

position.

• Caution: When the appliance is not in use,
the gas must be turned off at the cylinder.

• Important: The appliance control knob must
be in the ‘OFF’ position before opening the

cylinder valve.

• Be aware of the hot door if re-igniting after
use.

• Check performance of burner prior to
installing ceramic stone.

• Do not smoke when attempting to ignite
burner.

• Always use protective gloves when handling

hot components.

• During use the side and top surfaces will
be HOT.

• Note: If for some reason, ignitor fails to

produce a spark at the electrode, appliance
can be lit by a long barbecue match. With
door open insert lighted match into the gap on

the front of the ceramic stone. Push and turn

control knob to ‘HIGH’. Burner ignition can be
checked through this gap.

Nominal Hourly Gas Consumption

Gas Type

Number of

Burners

Injector Size

Main Burner

Total Gas

Consumption

MJ/h

Gas

Pressure

kPa

General

Product LPG

1 1.25mm 21 MJ/h 2.75 kPa