Gasboy CFN III Cancel Transaction Decal User Manual

Purpose

This document provides instructions to install the Cancel Transaction Decal on Island Card Readers (ICRs) that are under the direct control of the CFN III Site Controller.

Scope

This decal provides user information about the transaction time-out feature and the Weights and Measures mandated 3-minute limit. It also provides information on how the user can canc el the current card transaction.

System Requirements

Installation of this decal is a Weights and Measures requirement. The decal must be installed on any remote Card Reader under the direct control of the CFN III Site Controller. Dispenser-mounted Card Readers do not require this decal.

Parts List

Item Description Part Number Quantity

1 Information Decal

M10680B001

Installing the Cancel Transaction Decal

Figure 1: Cancel Transaction Decal

MDE-4877

Cancel Transaction Decal Installation

Instructions for CFN III

November 2009

Note: Dimensions are in millimeters (mm).

To install the Cancel Transaction Decal, proceed as follows:

1 Peel the backing from the decal and install on the pedestal in the area shown in Figure 2. Ensure that the decal is clearly

visible to the user.

Notes: 1) You must install the decal on the pedestal of all remote Card Readers at the site, which are under the direct

Figure 2: Installi ng the Decal

control of a CFN III Site Controller.

2) Ensure that the surface where the decal is to be installed is clean and grease-free. Clean the surface with an appropriate cleaner, if needed.

Install the Decal

here.

2 Repeat step 1 for all ICRs at the site.

7300 West Friendly Avenue · Post Office Box 22087 · Greensboro, North Carolina 27420 · Phone 1-800-444-5529 · http://www.gasboy.com · Printed in the U.S.A.