Gasboy 9820Q User Manual

INSTALLATION INSTRUCTIONS, 9820Q TOTALIZER KI T
This instruction sheet details installation of the 9820Q totalizer kit. Be sure to read and obey all warnings and safeguards as outlined in the enclosed Warnings and Safeguards Sheet. Kit contents are as follows:
Item P/N Description
1 015113 Bracket, 9 dig. tot. mount, Qty 1 2 039070 Nut, #8-32 Hex Keps, Qty 2 3 039824 Odometer, 9-dig. CCW, Gallon, Qty 1 039825 Odometer, 9-dig. CCW, Liter, Qty 1 4 017366 Cable Assy., Drive, 9-dig. tot. , Qty 1 5 043220 Pin, Spirol, 1/16” x 1/2” , Qty 1
1. Turn off and lock out all power to the system.
2. Remove sheet metal cover from the unit.
3. Install Totalizer Bracket (9) to the frame with two 1/4-20 x 1/2 Taptite screws (10). (See Figure 1.)
4. Install the Drive Cable Assembly (4) to the Totalizer/Odometer (3) using the Spirol Pin (5) NOTE: Cable end fitting with smaller mounting hole goes to totalizer. (See Figure 2, Detail B.)
5. Install assembled Drive Cable Assembly (4) with the Odometer/Totalizer (3) to the Totalizer Bracket mount (1), using the two 6-32 screws ( 6). Then, use the two 8-32 hex keps nuts (2) to attach this completed assembly to the Totalizer Bracket (9) that was installed in Step 3. (See Figure 2, Detail B.)
6. Route the Drive Cable Assembly under the meter and up to the flange of the frame. Use the cable tie (8) to secure the drive cable in place where a hole is located in the frame. (See Figure
1.)
7. Install the loose end of the Drive Cable Assembly to the Gear Train Assembly under the pulser housing using the Cotter Pin (7). (See Figure 1, Detail A.)
8. Restore power to the unit and check for proper operation of the totalizer.
Item P/N Description
6 C04039 Screw, #6-32 x 1/2” Phil. Pan Hd, Qty 2 7 042290 Pin, Cotter, 3/64” x 1/2” , Qty 1 8 C08126 Cable Tie, Qty 1 9 022577 Totalizer Bracket, Qty. 1 10 053919 Screw, Qty. 2 031907 Installation Instructions
031907 Rev. 12/03/03
Loading...