Ruler
The Pro-Pointer AT has a ruler molded into its exterior to measure a target’s depth in either centimeters or inches.
Low Battery Alarm
When the battery becomes low, the detector will sound an alternating dual-tone alarm. Replace the 9V battery as soon as possible.
Battery Replacement
Simply rotate the battery cover counterclockwise to remove and clockwise to tighten by hand. To properly install the 9V battery, match the larger battery terminal to the larger opening in the compartment. Remove the battery when the unit is to be stored more than 30 days.
Operational Information and Tips
• Operation is completely automatic. All metals will be detected including ferrous and non-ferrous.
• When a target is detected, the Pro-Pointer AT will produce an audio and/or vibration alert. The rate of the pulsing audio and vibrations increase proportionately as the pinpointer is moved closer to a metallic target.
• Maximum detection of very small targets is obtained against the side about ½” from the tip.
• To avoid cancelling out a target, do not turn on the Pro-Pointer AT while
it is adjacent to the target.
6
•Because the Pro-Pointer AT is a static, non-motion detector, optimum operation is achieved when the unit is switched off between uses.
•Avoid using the Pro-Pointer AT as a digging or prying tool. It is designed for flat side-scanning and precise pinpointing with its tip. It is not intended to be used with excessive force.
•For water use, do not exceed 10 feet (3 meters) depth. Make sure the battery cap threads are free of sand, sediment, etc. and that O-ring is periodically lubricated with silicone grease to maintain a tight seal.
•To remove dried dirt, mud or other debris from the unit, simply hand wash it with soap, water, and a soft cloth. Do not use any type of abrasive or chemical cleaners which could scratch or erode its surface.
7
MADE IN |
® |
|
THE USA |
||
|
The Garrett Pro-Pointer AT is manufactured in the United States of America and in accordance with Garrett’s ISO 9001 internationally certified Quality Management System and meets the following international standards:
• FCC • CE • RoHS • ICNIRP • IEC 529-IP 68
SPECIFICATIONS
Model Name: |
Garrett Pro-Pointer® AT |
|
Model Number: |
1140900 |
|
Operating Temperatures: |
-35ºF (-37ºC) to 158ºF (70ºC) |
|
Operating Frequency: |
11.5 kHz |
|
Waterproof Rating: |
10 foot (3 meter) maximum depth; IP 68 |
|
Tuning: |
Automatic or manual retune |
|
Indicators: |
Proportional audio/vibration pulse rate |
|
Controls: |
Power, Retune, Adjust switch |
|
Dimensions: |
Length: |
9” (22.9 cm) |
|
Thickness: 1.5” (3.8 cm) tapered to |
|
|
.875” (2.2 cm) |
|
Weight: |
6.5 oz. (0.2 kg.), with battery in |
|
Battery: |
Single 9V (included) |
|
Battery Life: |
Carbon: 16 hours |
|
|
Alkaline: 30 hours |
|
|
Rechargeable: 8 hours |
|
Warranty: |
2 Years, Limited Parts/Labor |
|
Patent Information: |
US 7,575,065; D583,261 and |
|
|
patents pending |
Garrett Metal Detectors, garrett.com and PRO-POINTER AT are trademarks and registered trademarks of Garrett Electronics
Inc. © 2015 Garrett Metal Detectors. |
1538800.B.0315 |