Garmin TB 10, PRO Trashbreaker User Manual
Pro Trashbreaker
Owner’s Manual
March 2014 190-01726-00_0B Printed in Taiwan
All rights reserved. Under the copyright laws, this manual may not be copied, in whole or in part, without the written consent of Garmin. Garmin reserves the
right to change or improve its products and to make changes in the content of this manual without obligation to notify any person or organization of such
changes or improvements. Go to www.garmin.com for current updates and supplemental information concerning the use of this product.
All rights reserved. Under the copyright laws, this manual may not be copied, in whole or in part, without the written consent of Garmin®. Garmin® reserves
the right to change or improve its products and to make changes in the content of this manual without obligation to notify any person or organization of such
changes or improvements.
Garmin® and the Garmin logo are trademarks of Garmin Ltd. or its subsidiaries, registered in the USA and other countries. BarkLimiter™ and Bark
Odometer™ are trademarks of Garmin Ltd. or its subsidiaries. These trademarks may not be used without the express permission of Garmin.
Getting Started
WARNING
See the Important Safety and Product Information guide in the
product box for product warnings and other important
information.
Setting Up the Pro Trashbreaker System
Before you can use the Pro Trashbreaker system, you must set
up the devices.
Attach the dog collar device to the collar strap (Attaching the
1
Dog Collar Device to the Collar Strap).
Charge the handheld device (Charging the Handheld
2
Device).
Charge the dog collar device (Charging the Collar).
3
Turn on the devices (Turning On the Dog Collar Device).
4
If necessary, pair the dog collar device with the handheld
5
device (Pairing a Dog Collar Device with the Handheld
Device).
Device Overviews
Pro Trashbreaker Handheld Device
Attaching the Dog Collar Device to the Collar Strap
With the buckle À facing outward, insert the end of the collar
1
strap through the slot Á on the collar device.
Pull most of the collar strap through the two slots  on the
2
dog device.
Insert the end of the collar strap through the slot à on the
3
opposite side of the device.
Pull the strap until it is tight across the front of the device.
4
Wrap the antenna keeper Ä around the collar strap.
5
NOTE: Do not bend the antenna sharply. You should
6
lengthen the collar strap on the side with the antenna keeper
to avoid bending the antenna sharply.
Slide the antenna Å through the antenna keeper.
Intensity level and training mode dial
À
Battery level
Á
Dog collar device toggle switch
Â
Training keys
Ã
Pro Trashbreaker Dog Device
À
Á
Â
Ã
Ä
Power key
Status LED
Lights
Contact points
Charging clip contacts
Charging the Handheld Device
You should fully charge the battery before you use the device
for the first time or whenever the battery is low (Checking the
Battery Level). It is normal for the battery to discharge in
approximately 7 to 10 weeks when the device is not in use.
Charging a fully depleted battery takes about 2 hours.
NOTE: The device will not charge when it is outside the
temperature range of 32° to 104°F (0° to 40°C).
Lift the weather cap À.
1
Plug the small end of the power cable into the mini-USB port
2
on the device.
Á
Plug the other end of the power cable into an appropriate
3
power source.
The status LED is solid red when the device is charging.
After the status LED turns solid green, unplug the power
4
cable from the device.
Getting Started 1
Loading...