Gardena 38 E mulchCut, 38 E easyMove, 34 E easyMove, 4034, 4038 Operating Instructions Manual
...
34 E easyMove Art. 4034 38 E easyMove Art. 4038
38 E mulchCut Art. 4039
GARDENA
®
D Gebrauchsanweisung
Elektro-Lenkmäher
GB Operating Instructions
Electric Flexible Steerable Lawnmower
F Mode d’emploi
Tondeuse électrique multidirectionnelle
NL Gebruiksaanwijzing
Elektrische zwenkmaaier
S Bruksanvisning
Flexibelt styrbar gräsklippare
I Istruzioni per l’uso
Rasaerba elettrico “Slalom”
E Manual de instrucciones
Cortacésped con volante
P Instruções de utilização
Máquina de Cortar Relva com Volante, eléctrica
DK Brugsanvisning
Flexibel bevægelig plæneklipper
D
GBFNLS
I
E
P
DK
12
GB
Correct use:
Please note
GARDENA Electric Flexible Steerable Mower
34 E easyMove / 38 E easyMove / 38 E mulchCut
Welcome to the Garden with GARDENA...
Please read these operating instructions carefully and observe
the notes given. Use these operating instructions to familiarise
yourself with the electric flexible steerable mower, its proper
use and the notes on safety.
For safety reasons, children under the age of 16 and people
not familiar with these operating instructions must not use this
electric flexible steerable mower.
v Please keep these operating instructions in a safe place.
1. Where to Use Your GARDENA Flexible Steerable Mower
. . . 12
2. Safety instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12
3. Assembly
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14
4. Operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14
5. Storage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 17
6. Maintenance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 18
7. Trouble-Shooting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 18
8. Technical Data
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 20
9. Warranty/ Service . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 20
1. Where to Use Your GARDENA Flexible Steerable Mower
The GARDENA flexible steerable mower is designed for cutting
lawns in and around the garden.
Do not use the mower on a slope steeper than 20° maximum.
To prevent injury, the flexible steerable mower must not
be used for trimming bushes, hedges, shrubs, for cutting
and pruning of climbers or grass on roofs or in balcony
boxes. In addition, the flexible steerable mower must not
be used for chopping up branches, twigs or for levelling
irregularities in the soil.
Contents
2. Safety instructions
V Please read the notes on safety on the flexible steerable mower.
Warning!
V Please read the opera-
ting instructions before
using the mower!
Danger!
Risk of injury!
V Keep bystanders away!
Danger!
V Cutting mechanism can cause
injuries!
V Unplug from the mains before
maintenance or if the mains
lead is damaged.
V Keep the connection cable
away from the mower.
13
GB
Check each time you use the mower :
Inspect the mower each time before you use
it. Do not use the mower if the safety devices
(switch handle, protective cover, cable strain
relief, start button, grassbox) and/ or the cutting mechanism are damaged or worn.
Replace damaged or worn parts. Never disable safety devices.
Check the grass to be cut before you start
work. Remove any foreign bodies present
(e.g. stones, branches).
Check the cutting tool for damage regularly
and have it professionally repaired if necessary.
Operation:
This electric flexible steerable mower can
cause serious injuries!
You are responsible for the safety of the
working area.
Do not tilt the mower on its side whilst using it.
Never lift or carry the mower with the motor
running.
Only use the flexible steerable mower for the
purposes specified in these instructions.
Wear sturdy shoes and long trousers to
protect your legs.
Keep your fingers and feet away from the cut-
ting tool and the cutting channel!
Make sure you always take up a safe and
stable stance whilst working, especially on
slopes.
Be particularly careful if you change direction
on a slope.
Be careful when going backwards.
Risk of stumbling!
Look out for foreign bodies when working
(e. g. stones).
Do not let the handle fall forwards freely when
folding it up.
Interruptions of work:
Never leave the flexible steerable mower
unattended at the working area.
If you interrupt your work store the unit in a
safe place.
Disconnect the mains plug!
When you interrupt work in order to go to
another working area, always switch off the
electric flexible steerable mower during
transport.
Environmental influences:
Only work when visibility is good.
Familiarise yourself with the surroundings of
your working area. Check for possible risks
which might be not audible due to the noise
of the machine.
Make sure that there are no other people
(especially children) or animals anywhere
near the working area.
If you do strike an obstacle when working,
release the switch handle, pull out the
mains plug and remove the obstacle.
Check the mower for damage and have it
repaired if necessary.
Do not use the flexible steerable mower if it
is raining or in moist, wet conditions.
Please observe any local restrictions or noise
levels.
Electrical safety:
DANGER!
Electric shock!
If the insulation is damaged on the screw
fastening the blade in position, this must
be replaced by GARDENA Service or a
specialist dealer authorised by GARDENA.
The electric flexible steerable mower must
only be operated with an undamaged electric
cable. If the electric cable or the extension
cable is damaged disconnect the mains plug
immediately.
The connection cable must be checked regularly for signs of damage and ageing (e.g.
cracks).
The cable strain relief on the steering upright
must be used (see 3 Fitting the cable clip).
Do not use the flexible steerable mower close
to swimming pools or garden ponds.
For portable units, which are used outdoors,
we recommend to use a residual-current device having a residual-current rating ≤ 30 mA.
In Switzerland use of a residual-current device
is obligatory.
The socket of an extension cable should be
water-proof and the connection sockets for
extension cables must be made of rubber or
be encased in rubber.
Only use permitted extension cables.
Ask your electrician.
Keep the extension cable away from the area
you are cutting.
14
GB
3. Assembly
All 4 wheels must always be screwed in at the same cutting
height (see 4 Operation “Setting the cutting height”).
1. Insert screw 1through the bore in the hub cap 2and push
the 6-sided head fully into the hub cap 2.
Insert the short screw in the small hub cap and the large
screw in the large hub cap.
2. Press covering cap 3into the hub cap 2until it snaps in
place.
3. Insert screw
1
through the wheel 4and screw the wheel
4
firmly in place by hand at the side and ensure it is securely
located.
Screw in the small wheels (13 cm diameter) at the front
and the large wheels (16 cm diameter) at the rear.
1. Place the box cover 7on the grass box 8from above in such
a way that ALL the eyes care positioned over the hooks d.
2. Press the box cover
7
on to the grass box 8until the hooks
d
engage securely.
3. Inspect: Check that all the hooks
d
are engaged securely.
4. Operation
DANGER!
A Cutting tool can cause injuries!
V Wait until the cutting tool is stationary before
undertaking any adjustment work, wear suitable
work gloves and pull out the mains plug.
34 E easyMove
Fitting the wheels:
Fitting the grass box:
The mains voltage and the equipment voltage
stated on the type plate must be the same. If
extension cables are used, these must comply
with the minimum cross-sections in the table
below:
Voltage Cable Cross-
length section
220-240V/ 50Hz Up to 20 m 1.5 mm
2
220-240V/ 50Hz 20 - 50 m 2.5 mm
2
A brief voltage dip may occur when you switch
on your shredder (due to conditions of the
power supply) that may affect other devices
(e.g. a lamp may flicker).
This problem should not occur with supply
impedances of Z
max
< 0,46 Ohm.
8
d
c
7
3
1
2
4
Loading...