GAO EMW202TD, EMW202R1 User manual

Instruction manual

for the remote controlled socket and transmitter

Type: EMW202TD + EMW202R1

Function

1. The remote-controlled socket switches the connected lighting and devices with a wireless

transmitter on and off, on radio basis within a range of up to 25 meters.

2. The product is ideal for lighting control, home automation and energy saving.

3. The receiver has an indicator light for the power condition.

Operation

1. There is no program setting required, the frequency is preset.

2. The transmitter controls the countdown function for 30 minutes, 60 minutes, 2 hours and 4

hours, as well as the ON / OFF function.

3. Connect the remote-controlled socket to the power supply.

4. Turn off the power to the consumer before connecting to the remote-controlled power outlet.

5. After connecting to the remote-controlled socket, the connected device must be switched on

again.

6. Remove the plastic cover on the battery compartment of the transmitter.

7. Push the “ ”, “ ” buttons on the transmitter to turn the connected devices on and off

with the remote control.

8. The countdown function automatically switches off the connected load after the selected time

has elapsed (30 minutes, 60 minutes, 2 hours or 4 hours).

9. The indicator light on the receiver flashes once when the signal for on / off is received.

10. When the indicator light on the transmitter goes dark, the battery needs to be replaced. Open

the battery compartment and replace the battery with an equivalent one

Warning

1. Always turn off your device before connecting.

2. For use in dry indoor areas only.

3. The devices connected to the remote control outlet should not exceed the specifications listed

below.

4. The socket must be easily accessible.

5. The household product safety standard does not allow remote control of all products. The remote

control must not be used to control products that could be at risk. For example, Curling iron, fryer,

heater, heating pad or hair dryer.

6. Voltage-free only with pulled plug.

7. Do not stick in a row.

Specifications

EMW202R1 (radio-controlled socket)

1. Voltage: 230V ~, 50Hz,

2. Resistive load: 1000W max.

3. Frequency: 433.92 MHz

4. Distance: up to 25 meters

EMW202TD (transmitter)

1. Battery: CR2032 3VDC (incl.)

2. Frequency: 433.92 MHz

3. Distance: up to 25 meters

Correct disposal of this product

Within the EU, this symbol indicates that this product should not be disposed of with the trash. Old

equipment contains valuable recyclable materials that should be recycled and so as not to harm the

environment or human health through uncontrolled waste disposal. Please dispose of old devices

via suitable collection systems or send the device to the point where you bought it for disposal. This

will then lead the device to recycling.

Disused batteries must be disposed of in an environmentally sound manner and in accordance with
the applicable regulations.

1) Please insert the batteries correctly according to the polarity (+ and -) marked on the battery

and the device.

2) Discharge the battery by operating the device until it stops.

3) Remove the battery from the device.

4) Dispose of the battery at a chemical waste collection point.

Maufacturer:

Everflourish Electrical Co., Ltd.
Renjiu Village, Wuxiang Town, Yinzhou Ningbo 315111 P.R. China

Declaration of conformity (DOC):

Hereby the manufacturer declares that this product complies with the essential requirements and the other
relevant provisions of Directive 1999/5 / EC located. The Declaration of Conformity for this product can be found
at www.everflourish-europe.eu.