GAL MOVFR Installation Instructions Manual

G.A.L. Manufacturing Corporation

50 East 153rd Street, Bronx, N.Y. 10451
Phone [phone] Fax [phone] 10/5/2005

MOVFR Operator Hand Swap Procedure

This document should be used as a guide to convert a side slide operator to its opposite hand. The following will show
the steps necessary to complete this task. It should take approximately 1 to 1 1/2 hours to complete. Take note of the
entire operator assembly and location of components to avoid reassembly problems.

Doc. No.: MOVFR Hand Swap.doc 1

G.A.L. Manufacturing Corporation

50 East 153rd Street, Bronx, N.Y. 10451
Phone [phone] Fax [phone] 10/5/2005

1. Remove the operator motor drive belt from the motor. Remove nuts, washers and rubber spacers on motor
mount tensioner.

2. Separate connecting link assembly from the operator crank arm. Note: During reassembly in the opposite
hand, you must separate the 2 halves of the connecting link, and reassemble with the slotted link facing
outward.

3. Remove 2 bolts on the door drive arm support assembly to separate door drive arm.

Doc. No.: MOVFR Hand Swap.doc

2

G.A.L. Manufacturing Corporation

50 East 153rd Street, Bronx, N.Y. 10451
Phone [phone] Fax [phone] 10/5/2005

4. Remove the operator controls enclosure cover.

5. Remove speed limit cams by sliding them off the bearing shaft. Note: During reassembly in opposite hand,
reference the appendix section of this document.

6. Remove 4 screws holding the operator controls enclosure to the base.

Doc. No.: MOVFR Hand Swap.doc

3