Pub. 42004-622L2A
GAI-TRONICS® CORPORATION
A HUBBELL COMPANY
Model 7325-104 Outdoor Metallic
Emergency Part y Line Ampli f ier Enclosure
Confidentiality Notice
This ma nual is p rovided solely as an operat ion, inst allation, and maintena nc e gu ide and contains sens itive
bus ines s and t echnic al infor ma tion tha t is confident ial and prop rieta ry to GAI - Tr onic s. GAI- Tr onic s retains
all intellectual prop erty a nd other r ights in or to the information contained herein, and s uch infor ma tion may
only be used in connection with t he op erat ion of your GAI-T ronics produ c t or s ystem. This manu al may not
be disclos ed in any form, in whole or in pa rt, direct ly or indirectly, t o any third party.
General Information
The Model 7325-104 Outdoor Metallic E mer gency Party Line Amplifier Enclos ure is desi gned t o be a
component in a GAI-Tronics SmartSeries system. It is a multi-party, 115 V amplifier enclosure that mates
with a Model 701-80x or 701-90x Series Handset/Speaker Amplifier to form a SmartSeries station.
When connected to a SmartS eries sys tem, this sta tion is equip ped to rep ort t he following inf ormation when
the handset is t aken off-hook:
• Zone number
• Station address
• Pa rty line (1 or 2)
All station r ep orts are received by the Master Control Unit and annu nc iated on a n access panel located in
the SmartSeries control cabinet.
OTES:
N
1. The Model 7325-104 Enclosure can also mate with a standard 701 or 751 Series Amplifier; however
the reporting feature is not op erab le wit h this combination.
2. E mer gency party line func tionalit y is only possible if your sys tem’s software is properly configured.
Your system must also have the address of the s tat ion intended to mat e wit h the enclosure enabled. Should
you have qu es tions a s to the capabilities of your s ystem, please contact your nea rest G AI - Tr onic s Servic e
Center.
GAI-Tronics Corporation P.O. Box 1060, Reading, PA 19607-1060 USA
610-777-1374 800-492-1212 Fax : 610-796-5954
ISIT WWW.GAI-TRONICS.COM FOR PRODUCT LITERATURE AND MANUALS
V
Pub. 42004-622L2A
Model 7325-104 Outdoor Metallic Emergency Party Line Amplifier E nc losure Page:
Installation
2 of 8
CAUTION
indicated on the approval list ing in the Sp ec ification section of this manual. Such installation may
cause a safety hazard and consequent injury or property damage.
When installing an add-on st ation, consult the sys tem layout diagrams at the end of this ma nual. These
figures, when used in conjunct ion with the st ation ins tallation information and cable layout guide, should
provide all the infor ma tion necessary to insta ll additional Pa ge/ Party< stations.
Do not install this equipment in hazardous areas or areas other than those
Enclos ure Placement
All GAI-Tronics Pa ge/ Party® units are wired in parallel. G ood system layout design minimizes the cable
required for ea ch insta llation. GAI-Tronics multi-condu c tor cable, des igned especially for this applic ation,
is recommended. The number, size, and color-coding of condu c tors are lis ted in the acc ompanying sys tem
connection diagra ms .
System layout and power c able length are ver y important when inst alling Page/Party< equipment.
Although it vari es f or differ ent systems, the general guideline is t hat t he t otal p ower cable length should not
exceed one mile (5280 feet) for 115 V ac systems. The total cable length is the most important
consideration while cable length between the sta tions is generally not a fa c tor.
Mounting
The Model 7325-104 Weatherproof Metallic Enclosure is sup plied with pre-drilled cable openings and
conduit hubs with top and bot tom cap plugs in p l ace to p revent contaminat ion. Whenever possible, do not
enter an enclosure from t he t op. We highly r ec ommend using only the bott om entry to prevent moisture
from dr ipping onto the termina ls or PCBAs. The b es t location for c onduit holes is along the bottom of the
enclosure near the r ear su rface. If the t o p open i n g i s to be used, carefully seal around the fi tti n g to prevent
moisture from entering.
For specific details including mounting hole dimensions, refer t o Figur e 1 . There ar e fou r 7/ 16-inch
diameter mounting holes in the corners of the amplifier enclosure. The suggested mounting height for a ll
station enclosures is 54 inches (137 cm) to the centerline of the enclosure.
OTE: Labels denoting whic h party line(s) is configured as the emergency party line are included in a n
N
envelope inside the enclosu re. The labels ar e f or Part y Line 1, Party Line 2 , and Party Lines 1 and 2
configurat ions. Ap ply the appr op ria te label ins ide you r enclosu re.
\\s_eng\gtc proddoc s \ s t andard iom s - current release\42004 inst r. m anuals \ 42004-622l2a. doc
10/03
Pub. 42004-622L2A
Model 7325-104 Outdoor Metallic Emergency Party Line Amplifier E nc losure Page:
3 of 8
Figure 1. Model 7325-104 Metallic Enclosu re Mount ing Details
\\s_eng\gtc proddoc s \ s t andard iom s - current release\42004 inst r. m anuals \ 42004-622l2a. doc
10/03
Loading...