GAI-Tronics 4115A User Manual

Pub. 42004-272B

GAI-TRONICS® CORPORATION

A HUBBELL COMPANY

Model 4115A Surface-Mount

Strobe Mounting Bracket Assembly

Confidential ity Notice

This manual is provided solely as an operational, installation, and maintenance guide and contains
sensitive business and technical information that is confidential and proprietary to GAI-Tronics.
GAI-Tronics retains all intellectual property and other rights in or to the information contained herein,
and such information may only be used in connection with the operation of your GAI-Tronics product or
system. This manual may not be disclosed in any form, in whole or in part, directly or indirectly, to any
third party.

General Information

The Model 4115A Surface-Mount Strobe Mounting Bracket Assembly includes the following
components:

Qty Description Figure Item #

1 Cover, aluminum oval 1
1 Conduit pipe, galvanized 2
1 Elbow, aluminum 3
1 Gasket for oval cover 4
1 Wall-mounting bracket, aluminum 5
2 Screws, stainless steel 6
1 Lock nut 7

Installation

Refer to Figure 1 on page 2 for the location of the items with numbers.

1. Secure the wall-mounting bracket (Item 5) to the wall.

OTE: Mounting hardware is not included.

N

2. Thread the lock nut (Item 7) onto the elbow end of the conduit pipe (Item 2).

3. Thread the ¾-inch female end of the elbow (Item 3) into the conduit pipe.

4. Thread the other end of the conduit pipe into the wall-mounting bracket.

GAI-Tronics Corporation 400 E. Wyomissing Ave. Mohnton, PA 19540 USA

610-777-1374  800-492-1212  Fax: [phone]

V

ISIT WWW.GAI-TRONICS.COM FOR PRODUCT LITERATURE AND MANUALS

Pub. 42004-272B

Model 4115A Surface-Mount Strobe Mounting Bracket Assembly Page 2 of 2

5. Feed the strobe wires through the elbow and down the conduit pipe assembly to the oval opening of

the wall-mounting bracket for strobe connections.

6. Tighten the elbow in the vertical position, and then tighten the lock nut against the elbow to secure.

7. Wire the strobe to the GAI-Tronics product that uses the strobe. Refer to the strobe’s installation

manual for wiring procedure.

8. Secure the gasket (Item 4) and the cover (Item 1) using the screws provided (Item 6).

Figure 1. Strobe Mounting Details

e:\standard ioms - current release\42004 i nstr. manuals\4 2004-272b.doc
10/14