GAI-Tronics 40404-045 User Manual

Pub. 42003-202D

GAI-TRONICS® CORPORATION

A HUBBELL COMPANY

Emergency Telephone Auxiliary Power

Supply Replacement Kit

Model 40404-045

Confidential ity Notice

This manual is provided solely as an operational, installation, and maintenance guide and contains
sensitive business and technical information that is confidential and proprietary to GAI-Tronics.
GAI-Tronics retains all intellectual property and other rights in or to the information contained herein,
and such information may only be used in connection with the operation of your GAI-Tronics product or
system. This manual may not be disclosed in any form, in whole or in part, directly or indirectly, to any
third party.

General Information

The Model 40404-045 Emergency Telephone Auxiliary Power Supply Replacement Kit is for use on
GAI-Tronics emergency phones. This kit includes a 5-volt regulated dc power supply. The power supply
cable has a pre-installed plug-in connector.

Installation

ATTENTION

1. Remove the phone front panel by removing the tamper-resistant screws.

2. Disconnect the telephone line from TB1, labeled T

3. Remove the jumper on P17. For 300 Series Emergency telephones, install this jumper across pins of

J18, located adjacent to P17.

4. Replace the jumper on P17 with the power supply connector. If the cable must be extended or

modified in any manner, please verify polarity.

Pin 4 = +5 V dc

Pin 1 = Gnd/ −V dc

5. Reconnect the telephone to the telephone line at TB1.

This power supply must be mounted in a dry location.

IP and RING. Refer to Figure 1 on page 2.

6. Plug in the power supply.

7. Refer to the applicable phone manual to complete the telephone setup.

GAI-Tronics Corporation 400 E. Wyomissing Ave. Mohnton, PA 19540 USA

610-777-1374  800-492-1212  Fax: [phone]

V

ISIT WWW.GAI-TRONICS.COM FOR PRODUCT LITERATURE AND MANUALS

Pub. 42003-202D

ODEL 40404-045 EMERGENCY TELEPHONE AUXILIARY POWER SUPPLY REPLACEMENT KIT Page 2 of 3

M

Figure 1. Jumper and terminal block locations on telephone PCBA

No. 69411-101 used in 200 Series Emergency Phones

f:\standard ioms - current release\42003 kit manuals \42003-202d. doc
02/13