Page 1
Pub. 42004-446A
GAI-TRONICS®
A HUBBEL L COMPAN Y
Model 13354-001 Wall-Mount Speaker
for 6-Channel Radio
Confidentiality Notice
This manual is provided solely as an operational, installation, and maintenance guide and contains
sensitive business and technical information that is confidential and proprietary to GAI-Tronics. GAITronics retains all intellectual property and other rights in or to the information contained herein, and such
information may only be used in connection with the operation of your GAI-Tronics product or system.
This manual may not be disclosed in any form, in whole or in part, directly or indirectly, to any third party.
General Information
The Model 13354-001 Wall-Mount Speaker for 6-Channel Radio is equipped with a pre-installed cable
assembly intended for use with the GAI-Tronics Model 4512-001 and 4514-001 6-Channel Radios. The
speaker assembly plugs into the radio with a standard 3-pin amphenol connector.
GAI-TRONI CS CORP.
MOHNTON, PA
USA
Figu
re 1. Model 13354-001 Speaker with Volume Control Outline
GAI-TRONICS 3030 KUTZTOWN RD. READING, PA 19605 USA
610-777-1374 800-492-1212 Fax: 610-796-5954
VISIT WWW.GAI-TRONICS.COM FOR PRODUCT LITERATURE AND MANUALS
Page 2
Pub. 42004-446A
Model 13354-001 Wall-Mount Speaker for 6-Channel Radio Page:
2 of 3
Mounting
There are four 0.280-inch mounting holes located in the four corners of the rear enclosure for mounting
the speaker. Refer to Figure 2.
1. To access these mounting holes, loosen the six captive screws on the front of the enclosure.
2. Gently
3. D
pull the front enclosure of the speaker away from
the rear enclosure.
isconnect the white and yellow quick-connect receptacles from the terminal block
in the rear
enclosure.
4. Mount the rear enclosure to the desired surface using
econnect the white quick-connect receptacle to the terminal block term
5. R
per the term
ohm on the terminal block term
8-
lign the front enclosure with the rear enclosure of the speaker. Tighten the front enclosure screws
6. A
to 16–20 in-l
inal block label (com – white). Reconnect the yellow quick-c
inals in the rear enclosure.
bs. torque.
the mounting holes shown in Figu
inals in the rear enclosure
onnect receptacle to the
re 2.
f:\standard ioms - current release\42004 instr. manuals\42004-446a.doc
4/11
F
igure 2. Mounting Hole Details
Page 3
Pub. 42004-446A
Model 13354-001 Wall-Mount Speaker for 6-Channel Radio Page:
Connect the speaker to the 6-channel radio as shown in Figure 3 below.
3 of 3
Fig
ure 3. Speaker Connection Diagram
Operation
Use the speaker audio level control provided on the side of the speaker to adjust the volume as desired.
Specifications
Mechanical
Enclosure ....................................................................................Glass-reinforced polyester, 0.20 inch thick
Hardware......................................................................................Urethane gaskets, stainless steel hardware
Electrical
RMS power rating............................................................................................................................. 16 watts
Sensitivity.............................................................................................................. 107 dB, 1 watt at 1 meter
Nominal coverage when surface-mounted to wall (ref. –6 dB)
Vertical ..............................................................................................................Upward: 40 degrees
Downward: 60 degrees
Horizontal.........................................................................................................................90 degrees
Replacement Parts
Part Number Description
12533-001 Speaker Replacement Kit
61526-008 L-Pad Assembly
CN3018 Weatherproof Cable Assembly
f:\standard ioms - current release\42004 instr. manuals\42004-446a.doc
4/11
Page 4
Warranty
Equipment. GAI-Tronics warrants for a period of one (1) year from the date of shipment, that any
GAI-Tronics equipment supplied hereunder shall be free of defects in material and workmanship, shall
comply with the then-current product specifications and product literature, and if applicable, shall be fit
for the purpose specified in the agreed-upon quotation or proposal document. If (a) Seller’s goods prove
to be defective in workmanship and/or material under normal and proper usage, or unfit for the purpose
specified and agreed upon, and (b) Buyer’s claim is made within the warranty period set forth above,
Buyer may return such goods to GAI-Tronics’ nearest depot repair facility, freight prepaid, at which time
they will be repaired or replaced, at Seller’s option, without charge to Buyer. Repair or replacement shall
be Buyer’s sole and exclusive remedy. The warranty period on any repaired or replacement equipment
shall be the greater of the ninety (90) day repair warranty or one (1) year from the date the original
equipment was shipped. In no event shall GAI-Tronics warranty obligations with respect to equipment
exceed 100% of the total cost of the equipment supplied hereunder. Buyer may also be entitled to the
manufacturer’s warranty on any third-party goods supplied by GAI-Tronics hereunder. The applicability
of any such third-party warranty will be determined by GAI-Tronics.
Services. Any services GAI-Tronics provides hereunder, whether directly or through subcontractors,
shall be performed in accordance with the standard of care with which such services are normally
provided in the industry. If the services fail to meet the applicable industry standard, GAI-Tronics will
re-perform such services at no cost to buyer to correct said deficiency to Company's satisfaction provided
any and all issues are identified prior to the demobilization of the Contractor’s personnel from the work
site. Re-performance of services shall be Buyer’s sole and exclusive remedy, and in no event shall GAITronics warranty obligations with respect to services exceed 100% of the total cost of the services
provided hereunder.
Warranty Periods. Every claim by Buyer alleging a defect in the goods and/or services provided
hereunder shall be deemed waived unless such claim is made in writing within the applicable warranty
periods as set forth above. Provided, however, that if the defect complained of is latent and not
discoverable within the above warranty periods, every claim arising on account of such latent defect shall
be deemed waived unless it is made in writing within a reasonable time after such latent defect is or
should have been discovered by Buyer.
Limitations / Exclusions. The warranties herein shall not apply to, and GAI-Tronics shall not be
responsible for, any damage to the goods or failure of the services supplied hereunder, to the extent
caused by Buyer’s neglect, failure to follow operational and maintenance procedures provided with the
equipment, or the use of technicians not specifically authorized by GAI-Tronics to maintain or service the
equipment. THE WARRANTIES AND REMEDIES CONTAINED HEREIN ARE IN LIEU OF AND
EXCLUDE ALL OTHER WARRANTIES AND REMEDIES, WHETHER EXPRESS OR IMPLIED BY
OPERATION OF LAW OR OTHERWISE, INCLUDING ANY WARRANTIES OF
MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE.
Return Policy
If the equipment requires service, contact your Regional Service Center for a return authorization number
(RA#). Equipment should be shipped prepaid to GAI-Tronics with a return authorization number and a
purchase order number. If the equipment is under warranty, repairs or a replacement will be made in
accordance with the warranty policy set forth above. Please include a written explanation of all defects to
assist our technicians in their troubleshooting efforts.
Call 800-492-1212 (inside the USA) or 610-777-1374 (outside the USA) for help identifying the
Regional Service Center closest to you.
(Rev. 10/06)
Loading...