GAI-Tronics 127401-001 User Manual
Pub. 42003-134
GAI-TRONICS® CORPORATION
A HUBBELL COMPANY
EZ Page Mount i ng Bracket Kit
Model 12704-001
Confidentiality Notice
This manua l is provide d sole ly as an operatio nal, installation, and ma inte nance guide and conta ins
sensitive business and t e chnic al infor ma tion w hich is conf ident ial and pr op riet ary to GAI-Tro nics.
GAI-Tronics retains all intellectual property and other rights in or to the information contained herein,
and such information may only be used in connection with the operation of your GAI-Tronics product or
system. This manu al may not be dis clos e d in any form, in whole or in pa rt, direct ly or i ndir ectly, to a ny
third pa r ty.
General Information
The Model 12704-001 Mounting Bracket Kit is intended for use with the EZ Page Industrial Intercom,
Models GC-AC1, GC-DC1, and GC-AC2, when mounting the unit to any building structure. This kit
includes the following components:
Qty. Description
1 Mounting bracket
2 5/16-inch flat washer
2 5/16-inch lock washer
2 5/16-inch nuts
1 Instruction sheet
You will need a 1/2-inch wrench to install this kit.
Installation
NOTE: To prevent damage and possible personal injury, ensure that the building structure and customersupplied hardware are suitable to support the weight of the EZ Page unit (approximately 15 lbs).
1. Mount the bracket to the building structure using the two 0.375 inch (9.5 mm) holes and appropriate
customer-supplied hardware so that the center of the EZ Page Intercom will be positioned
approximately 54 inches above the floor. The mounting holes are spaced 6.625 inches (168.3 mm)
apart.
GAI-Tronics Corporation P.O. Box 1060, Readi ng, PA 19607-1060 USA
610-777-1374 800-492-1212 Fax: 610-796-5954
ISIT WWW.GAI-TRONICS.COM FOR PRODUCT LITERATURE AND MANUALS
V
Pub. 42003-134
EZ
PAGE MOUNTING BRACKET KIT Page: 2 of 2
2. Mount the EZ Page Intercom onto the bracket mounting studs using the 0.406-inch mounting holes.
Fasten securely using the flat washers, lock washers, and nuts supplied in this kit. Refer to Figure 1
below.
7.875
(200mm)
6.625
(168.3mm)
5.875
(149.2mm)
Ø.375 (9.5 mm )
BRACKET
MOUNTING HOLES
(2 PLACES)
)
0
m
0
m
5
5
.
.
3
2
6
(
Ø.406 (10.3 mm )
MOUNTING HOLES
(2 PLACES)
FRONT VIEW RIGHT SIDE VIEW
FLAT WASHER
NUT
LOCK WASHER
MOUNTING
BRACKET
Figure 1. EZ Page Intercom with Model 12704-001 Mounting Bracket
\\s_eng\gtc proddoc s \st andard iom s - current release\42003 kit manuals \ 42003-134. doc
01/00
Loading...