Gaggenau DI240410 User Manual

Gaggenau Operating instructions
Dishwasher DI 240
9000 413 643 (8902–1) en
en
Index
Safety instructions 4 . . . . . . . . . . . . . . . . . . . . . . . . .
Getting to know your appliance 5 . . . . . . . . . . . . . .
Filling the salt dispenser 6 . . . . . . . . . . . . . . . . . . . .
Adding rinse aid 6 . . . . . . . . . . . . . . . . . . . . . . . . . . .
Utensils 7 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Detergent 9 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
auto 3in1 10 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Overview of programmes 11 . . . . . . . . . . . . . . . . . . .
Washing dishes 12 . . . . . . . . . . . . . . . . . . . . . . . . . . .
Additional options 13 . . . . . . . . . . . . . . . . . . . . . . . . .
Maintenance and care 14 . . . . . . . . . . . . . . . . . . . . .
Fault finding 15 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Customer Service 16 . . . . . . . . . . . . . . . . . . . . . . . . .
Information 16 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Installation 17 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Waste disposal 18 . . . . . . . . . . . . . . . . . . . . . . . . . . . .
4
Safety instructions Delivery
Immediately check the packaging and dishwasher for any damage which may have been caused in transit. Do not use a damaged appliance, but consult your supplier.
Please dispose of packaging material properly.
Installation
Install and connect the appliance according to the installation and assembly instructions.
The dishwasher must NOT be connected to the power supply during installation.
Ensure that the protective conductor system of the domestic electricity supply has been installed correctly.
Electrical connection conditions must correspond with the specifications on the rating plate of the dishwasher.
If the dishwasher is to be installed in a high-sided unit, ensure that the unit is attached properly and also at the rear.
Built-under and built-in appliances should always be installed under a continuous work surface which is attached to the adjacent cupboards, in order to ensure that the appliance is entirely stable.
After the appliance has been installed, the mains plug should still be easily accessible.
Not on all models: The plastic housing on the water input contains an electrically operated valve. The connecting wires are inside the inlet hose. Do not cut through this hose and do not immerse the plastic housing in water.
Warning
For safety reasons, if the appliance is not fitted in a recess, thereby making a side wall accessible, the door hinge area should be covered at the side. (Risk of injury) Covers are available as optional accessories from customer services or specialist stores.
In daily use
Warning
Knives and other sharp-pointed utensils must be placed with the points down in the cutlery basket or horizontally in the utensils basket.
Use the dishwasher only in the household and only for its designed purpose, i.e. for washing domestic dishes.
Do not lean or sit on the open door. The appliance could tip.
Please note that free-standing appliances may tip over if the baskets are overloaded.
The water in the appliance is not drinking water. Do not add any solvents to the washing chamber.
Danger of explosion! Open the door carefully when the programme is still
running. There is a risk of hot water spraying out of the appliance.
To prevent injuries, e.g. caused by stumbling, open the dishwasher only briefly in order to load and unload the dishwasher.
Read and observe the safety nformation and instructions for use on the packaging for cleaning and rinsing agents.
Children in the household
If fitted, use the childproof lock. An exact description can be found in the back of the envelope.
Do not allow children to play with or operate the appliance.
Keep children away from detergents and rinse aid. These may cause chemical burns in the mouth, throat and eyes or asphyxiation.
Keep children away from an open dishwasher. There could still be detergent residue inside.
If the appliance is installed at eye-level, ensure when opening and closing the door that children are not caught or crushed between the appliance door and the cupboard door situated below.
Childproof lock (button lock)
You can secure your appliance from being unintentionally switched over (e.g. improper operation by children).
Activating the button lock:
Select the required programme. Hold down the button B for approx. 4 sec. until this
is indicated on the digital display.
If any button is pressed while the programme is running, this
is indicated on the digital display. It is
not possible to end (reset) the programme. Deactivating the button lock:
Hold down the button B for approx. 4 sec. until the display
goes out.
At the end of the programme (
on the digital display) the button lock is cancelled. If there is a power failure, the button lock is retained. Whenever a programme is restarted, the button lock must be reactivated.
Damage
The appliance may be repaired and opened up by a technician only. First disconnect the appliance from the power supply. Pull out the mains plug (do not tug the power cord!) or switch off the fuse. Turn off the tap.
Disposal
Make redundant appliances unusable to prevent subsequent accidents.
Dispose of the appliance in an environmentally friendly manner.
Warning
Children could get locked in the appliance (risk of suffocation) or get stuck in other positions. Therefore: Remove the mains plug, cut the mains wire and set aside. Damage the door lock so that the door can no longer be closed.
5
Getting to know your appliance
Diagrams of the control panel and the interior of the appliance can be found in the envelope at the front. Individual positions are referred to in the text.
Control panel
1
Main switch
2
Door opener
3
Digital display/ Programme progress indicator
4 Time delay * 5
Additional options *
6 Salt refill indicator 7
Rinse-aid refill indicator
8 “Check water supply” indicator * 9
Programme buttons
* not included with all models
Appliance interior
20
Upper basket with additional cup rack
21
Additional cutlery basket for the top basket*
22
Top spray arm
23
Bottom spray arm
24
Dispenser for salt
25
Filters
26
Cutlery basket
27
Bottom basket
28
Lock for detergent dispenser
29
Dispenser for rinse aid
30
Detergent dispenser
31
Rating plate
* some models
You will need to purchase the following before using the dishwasher for the first time:
– special salt for use in dishwashers – detergent – rinse-aid
Only use products, which are suitable for dishwashers.
Water softener
In order to rinse dishes and glasses satisfactorily, the dishwasher requires soft water, i.e. containing little or no lime, otherwise water stains will be left behind on crockery and glasses, etc. If the tap water exceeds a certain level of hardness, it must be softened, i.e. decalcified, so that it can be used in the dishwasher. This is achieved by adding a special salt to the water softener inside the dishwasher. The water softener, that is the required amount of salt, is set up according to how hard the tap water is.
Setting up the water softener
Determine the level of hardness of your tap water. Your local water company or service agent can help you with this.
Identify setting from the following water hardness table.
Water hardness table
Press and hold the B programme button, and set the main switch
1
to ON, before releasing the programme button again. The indicator lamp for the
B button flashes, as
does the figure in the numerical display. The latter represents the value that was pre-set in the factory.
To change the setting: Press the
B programme button
9
.
Every time the button is pressed, the figure increases by one. After reaching
, the display
starts at
again. Set the main switch 1 to OFF. The new setting is stored in the appliance’s memory.
Approx. 4 litres of water are required for regenerating the water softening system. The overall water consumption per load can therefore be increased by between 0 and a maximum of 4 litres according to the water hardness setting.
6
Filling the salt dispenser
Salt must always be filled before the appliance is switched on, so that excess salt solution is immediately flushed away to prevent corrosion.
Open the screw-type cap of the compartment 24 . Before using the appliance for the first time, pour
about 1 litre of water in the salt container. Then refill with salt (not cooking salt) until the salt
container is full (max. 1.5 kg). When you refill the salt, water is being displaced and drains off.
The LOW SALT indicator 6 on the front panel will light up initially but will extinguish again after a short period when the salt solution has become sufficiently concentrated.
When the control is set to
, it is not necessary to fill up with salt as none will be consumed while the dishwasher is operating. The LOW SALT indicator is switched off. If the control is set between
and ,
then salt must be added to the dispenser.
Warning
Do not pour detergent into the container for special salt. This would destroy the water softener.
Salt refill indicator
As soon as the salt refill indicator 6 is lit on the control panel, refill with salt immediately before the next rinse cycle.
Depending on the washing frequency and the hardness setting, the regeneration salt may not have to be topped up for several months.
Adding rinse aid
The rinse aid is required for stain-free utensils and clear glasses. Use only rinse aid for domestic dishwashers.
Open the cover on the rinse-aid dispenser 29 . To do this, press the mark (1
) on the cover and
simultaneously lift the cover on the control plate (2
).
Carefully pour in the rinse aid to just below the edge of the filler opening.
Close the lid, ensuring that you hear it snap closed.
To prevent excessive foam formation during the next rinse cycle, remove any rinse aid which has run over with a cloth.
Adjusting the amount of rinse-aid
The amount of rinse-aid added to the water can be varied by adjusting the stepless control. The rinse-aid control has been set to ”4” in the factory.
Do not alter the setting of the rinse-aid control unless streaks (turn knob towards ”–”) or water marks (turn knob towards ”+”) are left on the dishes.
29
Rinse aid controller
Rinse-aid refill indicator
As soon as the rinse-aid refill indicator lights up on the control panel
7
, refill with rinse aid.
If using detergent products with integrated rinse aid, the rinse-aid refill indicator can be switched off (see “Switching the rinse-aid refill indicator off and on” in the “auto 3in1” chapter).
7
Utensils Not suitable
Cutlery and utensils made of wood. Fragile decorative glasses, hand-crafted and antique
utensils. These decorative items are not dishwasher-proof.
Plastic parts sensitive to hot water. Copper and tin utensils. Utensils which are soiled with ash, wax, lubricating
grease or ink. Absorbent materials such as sponges and cloths.
Aluminium and silver parts have a tendency to discolour and fade during the wash cycle. Even some types of glass (e.g. crystal glass objects) may turn cloudy after many wash cycles.
Recommendation:
In future buy utensils which are identified as dishwasher-proof.
Damage to glassware and other dishes
Possible causes:
type of glass or manufacturing process chemical composition of detergent water temperature and duration of dishwasher
programme.
Suggested remedy:
Use glassware or porcelain dishes that have been marked ’dishwasher–proof’ by the manufacturer.
Use a mild detergent that is described as ’kind to dishes’. If necessary, seek further information from detergent manufacturers.
Select a programme with as low a temperature and as short a duration as possible.
To prevent damage, take glass and cutlery out of the dishwasher as soon as possible after the programme has ended.
Loading the dishwasher
Remove large food remnants. It is not necessary to rinse them off under running water.
When loading the dishwasher, ensure that
D
all utensils are secure and cannot fall over.
D
the openings of all receptacles are face down.
D
curved or indented utensils are at an incline, allowing water to drain.
D
the two spray arms can rotate freely.
Very small items should not be washed in the dishwasher as they could easily fall out of the baskets.
Removing the dishes
To prevent water dripping from the top basket onto the dishes in the lower basket, we recommend that you empty the lower basket first and then the top basket.
Cups and glasses
Upper basket
20
* not included with all models
Pots and pans
Lower basket
27
Cutlery
Cutlery should be placed in the dishwasher always unsorted and with the eating surface pointing downwards. The spray jet is then better able to reach the individual parts.
To prevent injuries, place long, pointed accessories and knives on the étagère (some models) or on the knife shelf (available as an accessory).
Folding spikes *
* on applicable models To improve stacking of pots and pans, the spikes can
be folded down.
Loading...
+ 14 hidden pages