Futaba SBS-01T User Manual

＜表面＞

●電圧 ： DC3.7 ～ 7.4V

●全長 ： 535mm●重量 ： 4.7g

●測定範囲 ： -20℃～ 200℃

●用途 ： 温度センサー

Telemetry SystemTelemetry System

Temperature Sensor

Temperature Sensor

＜裏面＞

WARNING WARNING

To utilize the SBS-01T temperature sensor, connect it
to the S.BUS2 port of the Futaba telemetry enabled
receivers.

S.BUS port or other channel ports.

Ensure that the unit is connected properly to the
receiver. Failure to do so could result in damage to
the sensor.

To prevent any burns, always mount the SBS-01T to
the engine after it has completely cooled.

Do not use the SBS-01T with anything other than an
R/C model.

The SBS-01T will not function properly if connected to an

Temperature Sensor

4 51 3886 30 6 2 7 3

MADE IN TAIWAN

温度センサー

00106836-1
SBS-01T-01

1M25A11701

The maximum operating temperature for the SBS-01T
is 200℃.

temperature there is the risk of damaging the unit.

Ensure that the unit is mounted in an area that will
eliminate exposure to fuel, water and vibration.

As with any electronic components, proper precautions are urged to prolong the
life and increase the performance of the SBS-01T.

To ensure that the SBS-01T is functioning as desired,
please test accordingly.

Allow a slight amount of slack in the SBS-01T cables
and fasten them at a suitable location to prevent any
damage from vibration during flight.

 If used in applications that exceed the maximum operating

 Do not fly until inspection is complete.

Mounting Precautions

●

Please take care to ensure that the
only portion of the temperature
sensor that touches the desired
surface (cylinder head, motor can,
etc.) is the sensing unit itself as
indicated in the image below.
To prevent damage, do not allow
the remaining parts of the SBS-01T
to touch the areas that will become
hot.

Temperature
detection part

●LED Indication

Green--Normal operation
Red--No signal reception

Green/Red--When setting
up the slot

Green/Red Alternate blink

--Unrecoverable error

INSTRUCTIONMANUAL

Thank you for purchasing Futaba's

Temperaturesensor

with a telemetry enabled transmitter/receiver, is used to indicate
the operating temperatures of the item to which it is attached.
To maximize your enjoyment, and to ensure proper sensing,
please read through this manual thoroughly. We also encourage
you to retain the manual for future reference should the need
arise.

SBS-01T Temperature Sensor.

This sensor, used in conjunction

LED

Receiver connection / Slot

●

The SBS-01T may only be used with telemetry
enabled receivers that offer S.BUS 2 port(s).
Please refer to the manual(s) that accompanied
your transmitter and/or receiver for proper
connection methodology. Please note that the
proper default slot for this accessory is number
one. Information on how to change the slot
assignment is included in the transmitter's manual.

number

setup

to telemetry receiver
S.BUS2 Port

Futaba Service Center
3002 N Apollo Drive Suite 1, Champaign, IL 61822
U.S.A.
TEL [phone] or E-mail: [e-mail]
(Support)