Futaba FHSS2 24G User Manual

2

FHSS2-24G 2.4GHz Module User Manual.

Futaba corporation

1080 Yabutsuka Chosei-son Chosei-gun

Chiba 299-4395 JAPAN

1. Features

 2.4GHz Frequency Hopping Spread Spectrum (FHSS) radio transceiver module.

 Operates in the unlicensed worldwide ISM band (2.4 GHz to 2.483.5GHz) band

 Fully integrated power regulation with a wide input unregulated operating range

4.0 to 7.2V.

 Equipped Fully integrated local oscillator and 26MHz 20ppm reference crystal

 100mA operating current

 Transmit power 40mW EIRP

 Receive sensitivity up to -95dBm

 FHSS data rates up to 500kbps

 1/2 mile operating range

2. Pin assign

Pin Number

J103 1 I/O 1 Input/output 1

J104 1 I/O 6 Input/output 6

Name Description

I/O 2 Input/output 2

3 I/O 3 Input/output 3

4 I/O 4 Input/output 4

5 I/O 5 Input/output 5

6 GND Module Ground

2 I/O 7 Input/output 7

3 I/O 8 Input/output 8

4 I/O 9 Input/output 9

5 I/O 10 Input/output 10

6 I/O 11 Input/output 11

7 LED LED control output

8 Vcc Module power input

9 Vdd 3.3V Regulated power output

3. Specifications

Parameter Value Units

Storage temperature

Operating temperature

Transmit power (conducted) 16 max dBm

Receive Sensitivity -95 dBm

Input voltage 4.0 ~ 7.2 Volt

Output voltage 3.3 Volt

Transmit current 100 max mA

4. Module User Requirements

4.1 This module must be integrated into a device where the user cannot access the

antenna connector and should not be able to remove or install the module.

4.2 Under a 2.14dBi antenna can be used with this module. The antenna must not

exceed the gain and pattern of the standard dipole antenna.

-20 ~ +80 Degrees Celsius

-10 ~ +45 Degrees Celsius

4.3 The device must contain the following permanent labeling on the exterior of the

device as follows:

Contains FCC ID: AZPFHSS2-24G

4.4 The user manual of the device must contain the following paragraph:

This device complies with part 15 of the FCC rules. Operation is subject to

the following two conditions: (1) This device may not cause harmful

interference, and (2) this device must accept any interference received,

including interference that may cause undesired operation.

Caution: Changes or modifications not expressly approved by the party

responsible for compliance could void the user’s authority to operate the

equipment.

This product contains a radio transmitter with wireless technology which has

been tested and found to be compliant with the applicable regulations