Furrion FSW8P12-CF User Manual

Page 1
8inch Active Subwoofer
Model No: FSW8P12-CF
Page 2
Warranty
Congratulations your purchase of a Furrion product. All Furrion are made to stringent quality standards and if used properly for
Safety information
Specifications
Operating voltage
11 – 15V DV
Output power
120W (2ohm @ 1%THD)
Frequency response
40Hz – 160Hz
Signal to noise ratio
>90dB
Input sensitivity
80nV (1%THD)
Current consumption (max)
15A
Dimension
418x254x92mm
their intended purpose you should enjoy many years use form your purchase. We are pleased to provide you with a 1 year warranty on all Furrion products. The details of this warranty are set out in the term and condition (see reverse) with supplement the authorized dealers Term and Condition of Sale
Ensure the +12V lead is disconnected from the battery before you connect any new equipment. Ensure the mounting location will not interfere with the gas tank, brake lines or electrical wiring. Ensure the Subwoofer is securely fastened to the vehicle to prevent damage in the event of an accident. Ensure all wiring is protected to avoid pinching or crushing which could result in damage to the audio system. Ensure the mounting location has sufficient air flow around the amplifier. Ensure you use the recommended gauge wire/cable for all amplifier connections. Improper installation may damage the Subwoofer or the vehicle.
Page 3
Product Overview
Front Panel
Fuse
Power Terminals
DC +12V Battery
Remote Control
Ground/negative
Frequency Cutting
Level Input
Power LED Indicator
RCA Line In
Page 4
Installation
Wiring
Product Care
Ensure the audio system is turned off before making any connections. Connect the power wires to the terminal Pay attention to respect cable polarity All wires/connection must be insulated with electrical tape and fitted with protective connector shields where ever possible Separate Audio and Power wiring to avoid interference. Connect the signal input according to the selected input (see the picture below)
Level Control We recommend the following method Turn “Frequency cutting” and Level Input” levels to middle level Adjust the level control until the desired maximum volume is achieved without distortion Adjust the frequency cutting and the level input sensitivity. Place all the knobs in the center position, and start adjusting the gain follows the frequency cutting to optimize the best match vehicle acoustics.
Fuse
Turning off the subwoofer and disconnecting all the connection and turning before replacing blown fuse Only use 15A fuse
Please remember that your Furrion product is an electronic device, and so needs to be treated with care: Do not subject it to mechanical shock or vibrations. Do not subject it to excessive heat. Keep it away from water and excessively humid areas. Keep it away from high electromagnetic fields. There are no user-serviceable parts inside. Opening the product or try to repair it will terminate the warranty.
Loading...