Furrion FGH4ZSA-SS, FGH4ZSA-SB User Manual

RV Gas Cooktop
Operating and Installation Instructions
This manual is for use with
Furrion FGH4ZSA-SS RV Gas Cooktop
Furrion FGH4ZSA-SB RV Gas Cooktop
1
IMPORTANT SAFETY INSTRUCTIONS
WARNING: If the information in this manual is not followed
exactly, a re or explosion may result causing property damage, personal injury or death.
WARNING: NEVER cover any slots, holes or passages in
the oven bottom or cover an entire rack with material such as aluminum foil. Doing so blocks airow through the oven and may cause carbon monoxide poisoning. Aluminum foil lining may also trap heat, causing a re hazard.
— Do not store or use gasoline or other ammable vapors and liquids in
the vicinity of this or any other appliance.
— WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electrical switch.
• Do not use any phone in your recreational vehicle.
• Clear the recreational vehicle of all occupants.
• Turn o the gas supply tank valve(s) or main gas supply.
Immediately call your gas supplier from a neighbor’s phone.
Follow the gas supplier’s instructions.
• If you cannot reach your gas supplier, call the re department. — Have the gas system checked and leakage source corrected by a
qualied installer, service agency, manufacturer or dealer or the gas supplier.
Keep this instruction manual with your appliance for future use.
The model and serial number are printed on the enclosed product
registration card.
2
Welcome
Furrion FGH4ZSA-SS RV Gas Cooktop Furrion FGH4ZSA-SB RV Gas Cooktop
Thank you for your purchase of our Furrion RV cooktop, we hope you will have an enjoyable experience with this product and it provides many memorable mealtimes.
With your purchase, you receive one of the best warranties in the RV industry. Take a moment to read the full warranty statement. It’s also important to register your Furrion appliance to ensure that you don’t miss out on exclusive owner benets, such as; assurance that you will be taken care of in the unlikely event that service becomes necessary during the warranty period, and a proof-of-purchase record in case of a insurance claim. You may register online at http://furrion.com/productregistration-com/
If you have any further questions regarding our products, please contact us at
support@furrion.com
3
Contents
Safety Instruction ............................................................................................
Cooktop Feature Guide ..................................................................................
Using Your Cooktop..........................................................................................
Getting Started ................................................................................................
Installation ........................................................................................................
Igniter Battery Replacement...........................................................................
Technical Specications...................................................................................
Trouble Shooting ..............................................................................................
Warranty ............................................................................................................
Exploded Drawing ............................................................................................
5-6 7 8 9 10-12 13 14 15 16-17 18-19
4
Safety Instruction
IMPORTANT SAFETY INSTRUCTIONS
WARNING: To reduce the risk of re, electrical shock, injury to persons, or damage when using the cooktop, reading the user manual before use. All installation must conform with state or other and Standards for Recreational Vehicles, ANSI/NFPA 1192.
Do not touch surface Burners, grates, or metal areas near these Burners or on the cooktop. Surface burners may be hot even though the ames are not
visible. Areas near surface burners may become hot enough to cause burns. During and after use, do not touch or let clothing or other ammable materials touch these areas until they have had sucient time to cool. Among these areas are the cooktop and the surfaces facing the cooktop.
Wear Proper Apparel—Loose-tting or hanging garments should never be worn while using the appliance. Do not let clothing or other ammable materials contact hot surfaces.
Do Not Use Water or Flour on Grease Fires— Smother the re with a pan lid, or use baking soda, a dry chemical or foam-type extinguisher.
When heating fat or grease, watch it closely. Fat or grease may catch re if
allowed to become too hot.
Use Only Dry Pot holders—Moist or damp pot holders on hot surfaces may result in burns from steam. Do not let the pot holders touch the ame or burners. Do not use a towel or other bulky cloth instead of a pot holder.
Do Not Heat Unopened Food Containers— Buildup of pressure may cause container to burst and result in injury.
Know which knob controls each surface burner.
Always turn the knob to the LITE position when igniting the burners. Visually check that the burner has lit. Then adjust the ame so it does not extend beyond the edge of the utensil.
never leave surface Burners unattended at High Heat settings—Boilovers
cause smoking and greasy spillovers that may ignite, or a pan that has boiled dry may melt.
use proper pan size—This appliance is equipped with one or more surface burners of dierent sizes. Select utensils having at bottom large enough to cover the surface burner. The use of undersized utensils
5
Safety Instruction
Do not store ammable materials near burners or let grease or other ammable substances accumu- late on this appliance.
Never leave this appliance unattended when in use. Boilovers and greasy spills may smoke or ignite.
WARNING: COOKTOP MUST BE SECURED BY THE SEALING TAPE PROVIDED.
WARNING:
NEVER use this appliance as a space heater to heat or warm the room. Doing so may result in carbon monoxide poisoning and overheating of the oven.
Important safety notice
The California Safe Drinking Water and Toxic Enforcement Act requires the Governor of California to publish a list of substances known to the state to cause cancer, birth defects or other reproductive harm, and requires businesses to warn customers of potential exposure to such substances.
CAUTION: Do not store items of interest to children in cabinets above a range or on the
back guard of a range – children climbing on the range to reach items could be seriously injured.
WARNING: Gas leaks cannot always be detected by smell. Gas suppliers recommend
that you use a gas detector approved by UL or CSA. For more information, contact your gas supplier. If a gas leak is detected, follow the “What to do if you smell gas” instructions.Disconnect power before servicing. Always perform a leak test according to the manufacter's instructions.
Maintenance – Keep cooktop area clear and free from combustible materials, gasoline, and other ammable vapors and liquids. Storage in or on the cooktop – Flammable materials should not be stored in an oven or near surface cooktop units. Pressure / Leak test using 11- 13.8WCI pressure
6
Feature
1 Product Rating Plate (bottom of cooktop) 2 Control Knob 3 Surface Burner (large) 4 Burner Grate 5 Burner Pan 6 Ignite button
Cooktop Feature Guide
3
4
5
1 26
Gas Cooktop : FGH4ZSA-SS / FGH4ZSA-SB
7
Using your cooktop
How to use your cooktop
A B C D
A: Manual electric igniter
B, C, D: Gas valve control knob.
Lighting the Surface burners:
1, Ensure all cooktop knobs are turned clockwise to the OFF position.
2, Check the main gas supply valve is in the OPEN position.
3, Push and turn cooktop knob 90 deg anti-clockwise to the large ame icon.
4, Push down on cooktop knob and press the spark ignition button together to light
the burner.
5, Continue to hold down the cooktop knob for 10-15 seconds to disable the safety cut
o.
6. To select simmer setting, turn the control knob counter clockwise at the lowest setting.
* This cooktop is tted with a burner safety cut o, if a ame is not present the gas
supply will automatically shut o.
* If no spark is present when pressing the ignitor, check or replace the AA battery buy
unscrewing the ignitor cover. NOTE: For your safety, never attempt to operate the appliance with battery power exhausted.
Shut o instructions
When the cooktop is not in use or a replacemnet gas bottle is needed to be installed.
1, Turn all knobs clockwise to the o position.
2, Before transit, turn the main gas supply o at the shut o valve.
8
The Burner Flame
Keep your arms and face away from being directly above the cooking area. Look through the cooking grate and observe the burner's ame below.
Flames should appear similar to the good ame show in diagram right.
Yellow
Good
Bad
Blue
Yellow
Blue
A good ame should be blue with a yellow tip.
Holes in Burner
Some yellow tips on ames up to 1 inch in length are acceptable as long as no carbon or soot deposits appear.
If ames are excessively yellow and irregular, the oil residue may not be completely burned o, or the venturi may be clogged or may not be properly positioned over the orices. Allow the appliance to cool before repositioning the venturi over the valve and orices.
Getting Started
Important
Never extend the ame beyond the outer edge of the utensil. A higher ame simply wastes heat and energy, and increases the risk of being burned by the gas ame.
Caring for your cooktop:
Use a nonabrasive stainless steel cleaner and apply with a soft lint-free cloth. To bring out the natural luster, lightly wipe surface with a water-dampened microber cloth followed by a dry polishing chamois. Always follow the grain of stainless steel.
To Clean the Burner Grates- Be sure burners and grates are cool before you place your hand, a pot holder, cleaning cloths or other material on them. The cast iron burner grates can be washed in hot soapy water. Rinse thoroughly and dry the grates with a cloth - don't put them on the cooktop while still wet. Be sure the grates are positioned securely over the burners. To remove burned on food, place the grates in a covered container or plastic bag. Add 1/4 cup ammonia and soak for 30 minutes. Wash, rinse well and dry. An abrasive cleaner can be used for stubborn stains.
Allow burners to cool. Use mild detergent or degreaser to clean. Rinse with water and towel dry. Be careful not to damage or bend the igniters or thermocouples on the side of each burner when cleaning. Ensure the burners are completely dry before attempting to inginte
Using a damp cloth, wipe with mild detergent or spray degreaser; rinse and dry. Do not place in dishwasher.
9
14 3⁄8
(365mm)
3 3⁄8
(85mm)
1
23 ½
(597mm)
2”min
(51mm min)
2”min
(51mm min)
2”min
(51mm min)
Installation
The appliance must be installed only by a quali ed person in compliance with the instructions provided.
Please ensure to install this product per manufacturers instructions to avoid harm to persons, animals or damage property.
Important: Please ensure the battery or power supply has been removed before any adjustments or maintenance work is completed.
Installation for Cooktop (without Oven)
• Make the cut-out in the countertop per  gure (Fig. A)
• Install the gas supply hose with 5/8-18UNF connection and shut o valve to the back wall on the left hand side of the cooktop cut out.
• Ensure to leave enough hose length so the cooktop can be tted and removed
• Ensure there is ventilation hole for air circulation around the cooktop in the cabinet.
• The depth of cabinets installed above cooking top should not exceed 13 in (330 mm).
• Ensure the countertop, surrounding materials and bonding agents have a temperature rating of no less than 193˚F (95˚C) to avoid deformation or discolouration.
• Before  tting the cooktop to the cavity a x the roll of sealing putty (included in the cooktop packaging) around the underside edge. Once putty is installed completely around the underside, remove the putty protective  lm and then  t the cooktop in
cut out. Push down on the cooktop edges to seal and  x the appliance securely.
10
Fig. A
Installation
Installation for Cooktop (with Furrion FSRI22LA Oven)
• Make the cut-out in the countertop per (Fig. B) When marking the cutout, ensure to measure the cut out from the front of the cabinets to ensure the oven vent is in the correct position.
• Install the gas supply hose with 5/8-18UNF connection and shut o valve to the back wall on the left hand side of the cooktop cut out.
• Two gas lines will be run for a Oven + Cooktop installation. Ensure to connect the cooktop to the upper gas connection.
• Ensure there is ventilation hole for air circulation around the cooktop in the cabinet.
• Ensure the countertop, surrounding materials and bonding agents have a temperature rating of no less than 193˚F (95˚C) to avoid deformation or discolouration.
• Before  tting the cooktop to the cavity a x the roll of sealing putty (included in the cooktop packaging) around the underside edge. Once putty is installed completely around the underside, remove the putty protective  lm and then  t the cooktop in cut out. Push down on the cooktop edges to seal and  x the appliance securely.
18 ⁄
(467mm)
2”min
(51mm min)
16 ¾
(426mm)
2
1
2”min
(51mm min)
1 ⁄
(41.3mm)
23 ½
(597mm)
2”min
(51mm min)
Fig. B
When installing a oven with a cooktop, ensure to measure the cooktop cut out position from the front of the cabinet. The critical dimension is to make sure the distance from the front of the cabinet to the rear of the countertop cut out is 18 ⁄” . This is so the oven vent can be  tted together with the cooktop.
11
Installation
Gas connection:
Connect the cooktop to a designated gas supply line from the RV main gas line which runs externally under the RV oor. Do not use a existing gas connection inside the RV to supply two appliances.
Cooktop must be connected separately, each appliance must have separate isolation valves to render them independent from one another.
This cooktop can be used with Propane Gas only. This cooktop is tted with a threaded 5/8-18UNF male attachment. For installation use
copper pipe and CSA or UL certied connectors which comply to USA and Canadian safety standards.
Ensure when cooktop is installed the exible gas supply pipe cannot touch any moving parts. Make sure adequate space is available so the supply pipe will not be bent or damage after installation.
Checking that the connection is gas tight
Once installation is complete, before nal tment check all pipe ttings for gas leaks by pressurizing the system to 13.8WCI then using a soapy solution or certied gas leak detector to check for possible leaks.
12
Loading...
+ 28 hidden pages