Wiring Diagram
AV IN
AV OUT
SUBWOOFER OUT
HDMI JACK
R R R
L L L
IR REMOTE JACK
AUDIO IN
ANTENNA
WIRING CONNECTING SOCKET
Specification
GENERAL
Supply Voltage DC 12V
Current Consumption Max.5A
Power Output 2x 20 W
Number of channels 2 STEREO channels.
Unit Dimensions (L X W X H): 130X 113 X 86 (mm)
FM SECTION
Frequency range 87.5Mhz - 108Mhz (Europe)
87.5 Mhz - 107.9Mhz (U.S.A.)
87.5 Mhz - 108Mhz (Australia)
Effective sensitivity 3uV.
I.F Frequency 10.7MHz.
AM SECTION
Frequency range 522Khz - 1620Khz
530khz - 1710Khz
(U.S.A.)
522 Khz - 1710Khz (Australia)
Effective sensitivity 40dB.
I.F Frequency 450KHz
Preamp Output 1 V Output
USB PLAYBACK
System MP3 audio system.
Frequency characteristics 20Hz -100Hz dB
10KHz-20KHz dB.
<=5
<=5
Signal to noise (USB) 50dB [1KHz] .
(Europe)
WALLMOUNT Entertainment System
Locations and Names of the Controls
Wiring connecting socket view
15
14
13
10
9
8
7
6
5
12345
6
GREY
GREY/BLACK
YELLOW +12V DC MEMORY B+
BLACK
POWER GROUND
Mounting Installation
4
3
2
1
19 20 21 22 23 24
11
12
16
17
18
Location
* Choose a mounting location away from humid areas, water sources, appliances or
any equipment that can radiate heat.
* Select an area on a wall or cabinet which is free from cable, fuel or brake lines and
ensure the area behind the wall mount stereo has a vent hole or if it is an enclosed box
and has adequate room around the rear of the unit for cooling.
* Ensure when the stereo is mounted in the cut out that the wires at the rear of the unit
are not pressed against the heat sink
Installing the unit.
* Before finally installing the unit, connect the wiring temporarily and make sure
the unit and the system work properly.
*Fix the unit with screw according to following diagram.
SCREW
PLASTIC FRAME
OF THE FRONT PANEL
1. POWER & MUTE BUTTON
2. LCD DISPLAY
3. VOLUME + BUTTON
4. VOLUME - BUTTON
5. SEL/AUX MODE BUTTON
6. AV MODE BUTTON
7. AM/FM MODE BUTTON
8. HDMI MODE BUTTON
9. USB MODE BUTTON
10. BT MODE BUTTON
11. NEXT BUTTON
12. PREVIOUS BUTTON
13. 1/ PLAY/PAUSE BUTTON
14. 2/STOP BUTTON
15. 3/RPT BUTTON
16. 4/RDM button
17. 5/ BACKLIGHT/HANG UP BUTTON
18. 6/CLOCK ADJUST/ALARM/TEL BUTTON
19. RESET BUTTON
20. HEADPHONE SOCKET
21. AUX IN JACK
22. HDMI IN JACK
23. MICROPHONE IN
SCREW
24. USB SOCKET
1. Remove plastic frame of the front panel from the unit.
2. Fix the unit with 4 pieces #8 pan head self tapping screw.
3. Put back plastic frame of the front panel to the unit.
Page 1 Page 7