Page 1
IT-REFERENCE 15 OWNER’S MANUAL
Page 2
IT-REFERENCE 15 OWNER’S MANUAL
The IT- R e f e r e n c e 1 5 F e a t u r e s
• D isc r ete symm etri c al b alan ced powe r ca n cels hum -ind u cin g noi se
• Power Factor correction provides surplus current for power-starved amplifiers
• L inea r Fi lter i ng Techn olog y fo r un e qual ed a u dio / v i deo clar i ty
• S e ries Multi-S t age Protecti o n Plus provid e s virtually m a intenance-fr e e
A C surge suppr e s sion
• Detachable surge suppression module for telco and cable / satellite connectors
Page 3
IT-REFERENCE 15 OWNER’S MANUAL
well as symmetrically balanced power. This
without compromising electrical safety. This
will immediately notice far clearer, stunningly
Page 4
IT-REFERENCE 15 OWNER’S MANUAL
with sweet, non-glaring ease while imaging
warranty period should your original ownership
•
Do not disassemble or modify in any way.
No user-serviceable parts inside
•
Keep away from moisture and avoid
excessive humidity
•
Do not allow liquids or foreign objects to
enter the unit
•
Household lighting equipment may not
be connected to the IT-Reference
15 because their sockets are not
designed for use with balanced
symmetrical power and may present a
shock hazard. We recommend that
only audio, video and computer
processing equipment be connected to
the IT-Reference 15.
•
The power supply cord or plug has been
frayed or cut.
•
Objects have fallen or liquid has spilled
into the unit.
•
The IT-Reference 15 has been exposed to
rain or other moisture.
•
The IT-Reference 15 does not appear to
operate normally, or exhibits a marked
change in performance.
•
The IT-Reference 15 has been dropped, or
the enclosure damaged.
Page 5
IT-REFERENCE 15 OWNER’S MANUAL
without a safety ground is considered improper
Amps. The IT-Reference 15 will operate with
AC Cable Routing
All power amplifi ers, receivers and powered
Page 6
IT-REFERENCE 15 OWNER’S MANUAL
Amp operation, and peak current demands
when the IT-Reference is fi rst turned on or
wear over the life time of the product, and
Page 7
IT-REFERENCE 15 OWNER’S MANUAL
AC power output, whereby both the neutral
we need to assure that safety is always
with nothing connected to the IT-Reference 15’s
AC Transient Voltage Surge
Voltage Shutdown
wired with a daisy-chained neutral from a homes
Page 8
IT-REFERENCE 15 OWNER’S MANUAL
Although the Furman SMP+ circuit assures
will dim, even though AC power is present at
power without the operator manually turning
Voltage Surge Suppressors
All in-line surge suppressors feature
Page 9
IT-REFERENCE 15 OWNER’S MANUAL
purchaser of the product is allowed fi fteen days from the
purchaser shall notify Furman in writing of the claimed
purchaser to return the product to the Furman factory or
Amplifi er
Audio Pre-
Amplifi er
policy up to $500.00. In order to make a claim for this
Page 10
IT-REFERENCE 15 OWNER’S MANUAL
All warranties contained herein are null and void if: the
power strips, UPS’s, other surge protectors, three-to-two-
prong adapters, or extension cords. Any such installation
protect against acts of God (other than lightning) such as
product in anyway with a generator, heater, sump pump,
period provided above. Furman shall not have any other
part of this Limited Warranty is determined to be void or
purchase or if the product was registered on-line, this is
please be sure it is adequately packed and cushioned
Page 11
IT-REFERENCE 15 OWNER’S MANUAL
AC Current Capacity:
Input - 20 Amp capacity required
Output - 11 - 15 Amp RMS * (maximum, all outlets combined - continuous)
AC input impedance, allowing power amplifi ers to work more effi ciently.
Transverse (Differential) Mode: >40 dB from 10Khz. - 100 kHz. >80 dB from 100 kHz. – 1GHz.
(Linear attenuation curve from 0.05 – 100 ohms line impedance)
Common Mode: >90 dB, 10Hz. - 50 kHz. >40 dB 50kHz. – 1MHz.
2 (symmetrical balanced outlets)
5 (linearly fi ltered outlets)
4 (power factor corrected outlets – 4 amps RMS reserve – resistive load – over 55 amps peak charge)
120VAC Line – Zero Ground Contamination. (188V peak
clamping @ 6000V 3000A input)
4” H x 17” W x 16.25” D (standard 2RU without feet)
53 lbs.
8.5 Watts for display and control circuits independent of actual load.
C-ETL (pending)
Page 12
IT-REFERENCE 15 OWNER’S MANUAL
Furman Sound, Inc.
1997 South McDowell Blvd.
Petaluma, California 94954-6919 USA
Phone: 707-763-1010 Fax: 707-763-1310
Web: www.furmansound.com
E-mail: info@furmansound.com
Loading...