Furman D10-PFP User manual

D10-PFP INSTRUCTIONS

The D10-PFP is a sturdy, rack-mountable power distributor featuring ten circuit breaker protected rear
panel outlets. Install a D10-PFP in your rig or component rack to safely power all of your equipment.

Note that the D10-PFP is a power distributor only, and offers no conditioning or surge protection
functions, making it an ideal extension to an existing branch circuit.

MAXIMUM LOAD:

The ten circuit breaker protected outlets are rated at 15 Amps, which is equivalent to 1800 Watts at 120
Volts. If the total load on the D10-PFP (combining all outlets) exceeds 15 Amps, the circuit breaker
(located on the front panel) will trip, cutting off power to all connected equipment. Should this happen,
reduce the load by unplugging one or more units from the D10-PFP, then push the circuit breaker
button in to reset it.

CAUTION:

Only for use with 15 Amp circuits utilizing a minimum of 14 AWG.

D10-P FP POWER DI STRIBUTOR

POWER ON

15 AMP

INS02805 REV A 02/08