Fujitsu Stylistic LT User Manual

FMW43PR1
Mini-Dock
User’s Guide
This mini-dock is designed to extend the connectivity of your pen tablet by providing a number of ports that are not available on the system. Refer to Figures 1, 2, and 3 for port locations. The mini-dock can also be used as a charging dock for periods when the pen tablet is not being used.
This mini-dock provides the following interfaces:
Video Port
Used for connecting a video monitor for displaying the contents of the pen tablet screen.
Floppy Disk Drive Port
Used for connecting the optional floppy disk drive (FMWFD2).
•PS/2-style Keyboard Port
Used for connecting a keyboard with a PS/2-style connector.
PS/2-style Mouse Port
Used for connecting a mouse with a PS/2-style connector.
AC Adapter Port
Used for connecting the AC adapter to supply power to the system.
Parallel Port
Ordinarily used for connecting a printer.
Serial Port
Used for connecting a serial device.
Floppy Disk Drive FMWFD2
USB Device
Mini-Dock
LAN Port
Used for connecting the pen tablet’s optio nal internal LAN module to a LAN hub.
Note: The mini-dock is required in order to use the
internal LAN module; there is no LAN port on the pen tablet.
•USB Port
Used for connecting Universal Serial Bus-compliant devices.
Pen Tablet
PC Card
Video Monitor
PS/2-Style Keyboard
PS/2-Style Mouse
Printer
Figure 1. Mini-Dock peripheral Interfaces
Fujitsu is a registered trademark of Fujitsu Ltd. © 2000 Fujitsu PC Corporation
8/00 Page 1 of 2 58-0737-00B
Theviewingangleofthemini-dockcanbeadjusted to four different positions. The bottom of the support bail on the rear of the support platform (see Figure
3). snaps into one of four slots. When storing the mini-dock, flip the bail up against the back of the support platform to allow the platform to lie flat.
Installing the System into the Mini-Dock 0
Cautions
• Dropping conductive material onto the charging contacts couldresult in internal damage to the pen tablet circuitry.
• Prior to installing your pen tablet into the mini-dock, be sure to power down your system first. Failureto do so could result in damage to the system or the mini-dock.
Support Bail
PS/2-style Mouse Port
Figure 2. Right Side of Mini-Dock
AC Adapter Port
LAN Port
Support Platform
1. Shut down the system by selecting Start> Shut Down> Shut Down.
2. Position the pen tablet against the positioning guideandthebackofthemini-dock.
3. Slide the pen tablet into the tray at the bottom of the mini-dock and press it down firmly until it is seated, as shown in Figure 4. The alignment guide in the bottom of the tray ensures that the system is properly seated over the connector.
4. Re-start your system.
Positioning Guide
Pen Tablet
Parallel Port
Serial Port
Video Port
Figure 3. Rear and Left-Side of Mini-Dock
Fujitsu is a registered trademark of Fujitsu Ltd. © 2000 FujitsuPC Corporation
Floppy Disk Drive Port
PS/2-style Keyboard Port
USB Port
Mini-Dock Base
Mini-Dock
Figure 4. Installing the System in the Mini-Dock
Removing the System from the Mini-Dock 0
1. Shut down the system by selecting Start> Shut Down> Shut Down.
2. Whileholdingthebaseofthemini-dockwithone hand, grasp the pen tablet at the top and firmly pull it straight up from the base.
3. Restart your system.
-
-
Loading...