Fujitsu ASTG18KUCA, ASTG09KUCA, ASTG12KUCA User Manual

AIR CONDITIONER Wall Mounted Type

ASTG09KUCA

R32

REFRIGERANT

This Air Conditioner contains and operates with refrigerant R32.

THIS PRODUCT MUST ONLY BE INSTALLED OR SERVICED BY QUALIFIED PERSONNEL.

Refer to Commonwealth, State, Territory and local legislation, regulations, codes, installation & operation manuals, before the installation, maintenance or service of this product.

OPERATING MANUAL

Contents

Safety Precautions ..........................................................En-1

Indoor Unit Overview and Operations .............................En-3

Remote Controller Overview and Operations ..................En-4

Timer Operation...............................................................En-6

Human Sensor (Energy Saving) ......................................En-8

Demand Response and Indoor Unit Operation ...............En-8

General Informations on Operation .................................En-9

Care and Cleaning.........................................................En-10

Troubleshooting ............................................................. En-12

ASTG12KUCA ASTG18KUCA

Before using this product, read these instructions thoroughly and keep this manual for future reference.

Safety Precautions

To prevent personal injury, injury to others, or property damage, read this section carefully before you use this product, and be sure to comply to the following safety precautions. Incorrect operation due to failure to follow the instructions may cause harm or damage, the seriousness of which is classiﬁ ed as follows:

WARNING CAUTION

This mark warns of death or serious injury. This mark warns of injury or damage to property.

This mark denotes an action that is PROHIBITED.

• Explanation of symbols displayed on the indoor unit or outdoor unit.

WARNING

CAUTION

• The appliance shall be installed, operated and stored in a

room with a ﬂ oor area larger than 1.54m2 (18 model only)

• The appliance contains no user-serviceable parts. Always consult authorized service personnel for repairing, installation, and relocation of this product.

Improper installation or handling will cause leakage, electric

shock, or ﬁ re.

• In the event of a malfunction such as burning smell, immediately stop operation of the air conditioner, and disconnect all the power supply by turning off the electrical breaker or disconnecting the power plug. Then consult authorized service personnel.

• Take care not to damage the power supply cable.

If it is damaged, it should only be replaced by authorized

service personnel.

• In the event of refrigerant leakage, be sure to keep away from ﬁ re or any ﬂ ammables, and consult authorized service personnel.

• If you see lightning or hear thunder, there might be a lightning strike.

To prevent electric shock hazard, turn off the air conditioner

by using the remote controller, and do not touch the unit or the power plug during thunderstorm.

This symbol shows that this appliance uses a ﬂ ammable refrigerant. If the refrigerant is leaked and exposure to an external ignition source, there is a risk of ﬁ re.

This symbol shows that the Operation Manual should be read carefully.

This symbol shows that a service personnel should be handling this equipment with reference to the Installation Manual.

This symbol shows that information is available such as the Operating Manual or Installation Manual.

WARNING

This mark denotes an action that is COMPULSORY.

• The appliance shall be stored in a room without continuously

operating ignition sources (for example: open ﬂ ames, an operating gas appliance or an operating electric heater).

• The appliance shall be stored in a well-ventilated area.

• Be aware that refrigerants may not contain an odour.

• The appliance shall be stored so as to prevent mechanical damage from occurring.

• Disposing of the product shall be done properly, in compliance with national or regional regulations.

• During transportation or relocation of the indoor unit, pipes shall be covered with the wall hook bracket for protection. Do not move the appliance by holding the indoor unit pipes. (The stress applied to the pipe joints may cause the ﬂ ammable gas to leak during operation).

• This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.

• Children should be supervised to ensure that they do not play with the appliance.

(continued)

PART No. 9319356082

9319356082_01_OM_EN.indd 19319356082_01_OM_EN.indd 1 7/1/2013 11:02:30 AM7/1/2013 11:02:30 AM

En-1

Safety Precautions (continued)

• Do not install the unit in area ﬁ lled with mineral oil such as a

factory or area containing a large amount of splashed oil or steam such as a kitchen.

• Do not start or stop the operation of this product by inserting or pulling out the power plug, or by turning on or off the circuit breaker.

• Do not use inﬂ ammable gases near the unit.

• Do not expose yourself directly to the cooling airﬂ ow for many hours.

• Provide occasional ventilation during use.

• Always operate the unit with air ﬁ lters installed.

• Ensure that any electronic equipment is at least 1 meter away from either the indoor unit or outdoor unit.

• Unplug the power supply cable when not using the indoor unit for an extended period.

• After long period of use, check whether the installation stand does not deteriorate to prevent the unit from falling down.

• The airﬂ ow direction and the room temperature should be carefully considered when you use this product in a room with infants, children, elderly or sick persons.

• Do not direct the airﬂ ow at ﬁ replaces or heating apparatus.

• Do not block or cover the intake grille and the outlet port.

• Do not apply any heavy pressure to radiator ﬁ ns.

• Do not climb on, place objects on, or hang objects from the unit

WARNING

CAUTION

• Do not insert your ﬁ ngers or any other objects into outlet

port, open panel, or intake grille.

• Do not operate with wet hands.

• Do not use means to accelerate the defrosting process or to clean the appliance, other than those recommended by the manufacturer.

• Do not pierce or burn.

• Do not place vase or water container on the unit.

• Do not place any other electrical products or household belongings under indoor unit or outdoor unit.

Dripping condensation from the unit might get them wet, and

may cause damage or malfunction of your property.

• Do not expose the unit directly to water.

• Do not use this product for preservation of food, plants, animals, precision equipment, art work, or other objects. This may cause quality deterioration of those items.

• Do not expose animals or plants to the direct airﬂ ow.

• Do not drink the drainage from the air conditioner.

• Do not pull the power supply cable to disconnect the plug.

• Do not touch the aluminum ﬁ ns of heat exchanger built-in the indoor or outdoor unit to avoid personal injury when you install or maintain the unit.

Indoor unit accessories

Remote controller

Batteries Air cleaning ﬁ lters Filter holders

Remote controller holder

Tapping screws (M3 × 12 mm)

Battery (R03/LR03/AAA × 2) loading and remote controller preparation

Remote controller holder installation

321

Screws

Insert

WARNING

Take care to prevent infants and young children from accidentally swallowing the batteries.

CAUTION

• Do not attempt to recharge dry batteries.

• Do not use dry batteries that has been recharged.

Slide up

Press CLOCK ADJUST button to start clock setting.

Set the day of the week by pressing SELECT button (Monday to

Sunday). *By pressing the TEMP. () buttons, the time indicator can be changed from a 24-hour to a 12-hour clock.

Press NEXT button to continue.

Set the time by pressing SELECT button.

Pressing  or  changes the value by the minute. Pressing down on  or  changes the value by 10 minutes.

En-2

9319356082_01_OM_EN.indd 29319356082_01_OM_EN.indd 2 7/1/2013 11:02:44 AM7/1/2013 11:02:44 AM

OPERATING MANUAL

To complete, press the SEND button close to the indoor unit.

Settings may not be properly sent if pressed from a distance.

Notes:

• Use speciﬁ ed type of batteries only.

• Do not mix different types or new and used batteries together.

• Batteries can be used about 1 year in ordinary use.

• If the remote control range noticeably shortens, replace the batteries, and press RESET button as shown in page 5.

Indoor Unit Overview and Operations

AIR CONDITIONER Wall Mounted Type

1 Intake grille

Before starting operation, make sure that the intake grille has been shut completely. Incomplete closing may have an effect on the proper

function or performance of the product.

2 MANUAL AUTO button

Use when the remote controller is lost or there is a malfunction.

Status Action Mode or operation

In operation Press more than 3 seconds. Stop

Stopping Press more than 3 seconds and

less than 10 seconds.

Press more than 10 seconds. (Only for servicing.*)

After cleaning Press less than 3 seconds. Filter indicator reset

*:To stop forced cooling, press this button or START/STOP button on

the remote controller.

AUTO

Forced cooling

3 Front panel

4 Human Sensor

Used for Energy Saving Program. Controls temperature setting by detecting people in the room.

See page 8

5 Vertical airﬂ ow direction louver

Each time you press SET button on the remote controller, the angle of the vertical airﬂ ow direction louver moves as follows:

COOL or DRY mode HEAT mode

• Do not adjust by hand.

• At the beginning of AUTO or HEAT mode, they may stay on position 1 for a while for adjustment.

• If the angle is set to position 4–7 for more than 30 minutes in COOL or DRY mode, the louver will automatically return to position 3.

• Keeping the position 4-7 during COOL or DRY mode may cause condensation to form, and the drops may damage your property.

*: Default setting in each mode.

6 Drain hose

7 Remote controller signal receiver

CAUTION

For appropriate signal transmission between remote controller and indoor unit, keep the signal receiver away from the following items

- Direct sunlight or other strong lights

- Flat-panel television screen

In rooms with instantaneous ﬂ uorescent lights, such as in- verter type ones, the signal may not be transmitted properly. In such a case, consult the store of purchase.

765

10 OPERATION indicator (green)

Lights in normal operation, and blinks slowly in Automatic defrosting operation. Blinks during Demand Response operation. For details, refer to page

Horizontal airﬂ ow direction louvers

CAUTION

Before you adjust the horizontal airﬂ ow direction, make sure that the vertical airﬂ ow direction louver has been stopped completely

Adjust two knobs by hand.

Air ﬁ lter

Air cleaning ﬁ lters

Purify or deodorize the air, and provide fresh airﬂ ow.

See page 10

See page 11

8 ECONOMY indicator (green)

Lights in ECONOMY operation and in 10 °C HEAT operation.

9 TIMER indicator (orange)

Lights in TIMER operation, and blinks slowly when the timer setting error is detected. For details, refer to “Auto-restart function” on page 9.

OPERATING MANUAL

9319356082_01_OM_EN.indd 39319356082_01_OM_EN.indd 3 7/1/2013 11:02:46 AM7/1/2013 11:02:46 AM

En-3

Remote Controller Overview and Operations

CAUTION

• To prevent malfunction or damage of the remote controller:

- Place remote controller at where will not be exposed to direct sunlight or excessive heat.

- Remove batteries if the product is not going to be used for an extended period.

- Exhausted batteries must be removed immediately, and be disposed according to the local laws and regulations of your region.

• If leaking battery ﬂ uid comes in contact with your skin, eyes,

or mouth, immediately rinse with plenty of clean water, and consult your physician.

• Obstacles such as a curtain or wall between the remote controller and the indoor unit may affect the appropriate signal transmission.

• Do not apply strong shocks to the remote controller.

• Do not pour water on the remote controller.

You can quickly start operation with the following 3 steps:

1 START/STOP button

2 MODE button

Switches operation mode in following order.

AUTO COOL DRY FAN HEAT

Notes in HEAT mode:

• At the beginning of the operation, the indoor unit operates at very low fan speed for about 3–5 minutes for preparation, then switches to the selected fan speed.

• Automatic defrosting operation overrides the heating operation when necessary.

3 TEMP. (temperature) buttons

Sets the desired temperature. In COOL or DRY mode, the temperature needs to be set lower than the current room temperature. In HEAT mode, the temperature needs to be set higher than the current room temperature. Otherwise, corresponding operation mode may not start.

Temperature setting range

AUTO/COOL/DRY 18–30 °C

HEAT 16–30 °C

Notes: Temperature control is not available in FAN mode.

4 Remote controller display

In this section, all the possible indicators are displayed for description. In actual operation, the display is linked with the button operation, and only shows the necessary indicators for each setting.

5 POWERFUL button

Activates the POWERFUL operation. The unit will operate at maximum power and strong airﬂ ow to quickly cool down or warm up the room. When activated, the indoor unit will emit 3 short beeps. To turn off, press the POWERFUL button again. The indoor unit will then emit 2 short beeps. POWERFUL operation is automatically turned off in the following situations:

• Adjusted room temperature reaches the set temperature in COOL, DRY, or HEAT mode.

• 20 minutes have passed after the POWERFUL operation mode has been set.

Even in situations above, the POWERFUL operation will not automatically turn off unless it has run for a certain amount of time.

Notes:

• The airﬂ ow direction and the fan speed are controlled automatically.

• This operation cannot be performed simultaneously with ECONOMY operation.

• POWERFUL operation will override the OUTDOOR UNIT LOW NOISE, ENERGY SAVING functions. Both functions, if set, will start after the POWERFUL operation is turned off.

6 10 °C HEAT button

Starts 10 °C HEAT operation that mainains the room temperature at 10 °C so as to prevent the room temperature to drop too low. After pressing the button to start the 10 °C HEAT operation, the indoor unit emits 2 short beeps and the ECONOMY indicator (green) will turn on. To turn off, press the START/STOP button. The Economy indicator will turn off.

Notes:

• In 10 °C HEAT operation mode, only the vertical airﬂ ow direction can be adjusted by using the SET button.

• HEAT mode will not be performed if the room temperature is warm enough.

(continued)

En-4

9319356082_01_OM_EN.indd 49319356082_01_OM_EN.indd 4 7/1/2013 11:02:47 AM7/1/2013 11:02:47 AM

OPERATING MANUAL

+ 8 hidden pages