FUJIFILM FinePix S2 PRO REPAIR MANUAL

DIGITAL CAMERA
FinePix S2 Pro
EEPROM REPAIR MANUAL
U/E-Model
WARNING
THE COMPORNENTS IDENTIFIED BY THE MARK ON THE SCHEMATHIC DIAGRAM AND IN THE PARTS LIST ARE CRITICAL FOR SAFETY. PLEASE REPLACE ONLY BY THE COMPORNENTS SPECIFIED ON THE SCHMATHIC DIAGRAMAND IN THE PARTS LIST. IF YOU USE WITH PART NUMBER UN-SPECIFIED, IT MAY RESULT IN A FIRE AND AN ELECTORICAL SHOCK.
FUJI PHOTO FILM CO.,LTD.
Printed in Japan 2002.12(T.S.)

SAFETY CHECK-OUT

After correcting the original problem, perform the following safety check before returning the product to the customer.
FinePix S2 Pro EEPROM REPAIR MANUAL
1. Check the area of your repair for unsoldered or poorly sol dered connections. Check the entire board sur face for solder splasher and bridges.
2. Check the interboard wiring to ensure that no wires are “pinched” or contact high-wattage resistors.
3. Look for unauthorized replacement parts, particu larly tran sistors, that were installed during a previ ous repair. Point them out to the customer and rec ommend their replacement.
4. Look for parts which, though functioning, show obvi ous signs of deterioration. Point them out to the cus tomer and recommend their replacement.
5. Check the B + voltage to see it is at the values specified.
6. Make leakage - current measurements to determine that exposed parts are acceptably insulated from the supply circuit before returning the product to the customer.
7. CAUTION: FOR CONTINUED
PROTECTION AGAINST FIRE HAZARD, REPLACE ONLY WITH SAME TYPE 2.5 AMPERES 125V FUSE.
2.5A125V
2.5A125V
RISK OF FIRE­REPLACE FUSE AS MARKED
ATTENTION: AFIN D'ASSURER UNE PROTECTION PERMANENTE CONTRE LES RISQUES D'INCENDIE, REMPLACER UNIQUEMENT PAR UN FUSIBLE DE MEME, TYPE 2.5 AMPERES, 125 VOLTS.
8.
WARNING:
WARNING!
HIGH VOLTAGE
TO REDUCE THE ELECTRIC SHOCK, BE CAREFUL TO TOUCH THE PARTS.
2
FinePix S2 Pro EEPROM REPAIR MANUAL

CONTENTS

1.Outline.................................................................................................4
2.How to install the EEPROM modification software into PC.................4
3.Modification .........................................................................................4
4.Inspection.......................................................................................... 11
5.Memo ................................................................................................12
3
FinePix S2 Pro EEPROM REPAIR MANUAL

1.Outline

Some of Nikon Bodies used for FinePix S2 Pro have troubles and so modification is necessary. Judge the objective camera and modify it according to this manual.

2.How to install the EEPROM modification software into PC

The software is stored by the compression method. Defreeze the folder and then copy it. Copy the EEPROM modification software into the C drive of PC. Copy it as shown in Fig. 2.
My Computer
3.5inch FD(A:)
(C:)
ZJ00635-100
ZJ00635-101
S2Pro_EEPROM_UE
(Fig.1) (Fig.2)
After copying, open the folder and double-click FFWJ.EXE.
-->The software starts.
My Computer
3.5inch FD(A:)
(C:)
ZJ00635-101
ZJ00635-100
S2Pro_EEPROM_UE

3.Modification

Carry out the procedure according to the instructions on the screen.
<Step 1>
4
Loading...
+ 9 hidden pages