FSR FLH20-1-JBC User Manual

FSR

FLH20-1-JBC JUNCTION BOX
(OR ABANDONMENT) COVER

INSTALLATION GUIDE

244 Bergen Boulevard, West Paterson, NJ 07424, Phone: [phone] - Fax: [phone]

(6) #8-32 FLAT

EXISTING RIM

HEAD SCREW

1/4" BEAD OF

RTV SILICONE

REMOVE ALL
RTV SILICONE

1a. EXISTING RIM - IF NO RIM REMOVAL IS REQUIRED, GO TO
STEP 1b. OTHERWISE, REMOVE EXISTING COVER AND
REMOVE CHAIN FROM COVER (NOT SHOWN). REMOVE
EXISTING RIM. REMOVE ALL
REMOVED PARTS AND HARDWARE MAY BE DISCARDED,
OR STORED FOR POSSIBLE FUTURE USE. CONTINUE TO
STEP 1b.

COVER

RTV SILICONE FROM BOX.

RTV SILICONE PLACEMENT DETAIL

CONTINUOUS

1b. NEW INSTALLATION
COVER AND SCREWS (NOT SHOWN), IF APPLICABLE.
APPLY A CONTINUOUS 1/4" BEAD OF RTV SILICONE TO THE
INSIDE CORNER OF ALL 4 SIDES OF THE CONCRETE-STOP
FLANGE ON THE BOX (SEE RTV SILICONE PLACEMENT
DETAIL). QUICKLY INSTALL RIM ONTO BOX WITH
PROVIDED #8-32 x 1/4" FLAT HEAD PHILIPS SCREWS, ONLY
IN COUNTERSUNK HOLES.

STUD FOR ALTERNATE
LOCATION OF CHAIN

RIM

COVER

- REMOVE AND DISCARD TEMPORARY

(2) #8-32 FLAT HEAD SCREW

BLIND TAPPED HOLE

CHAIN FROM BOX

#8-32 PAN HEAD SCREW

2. INSTALL BOX-ATTACHED CHAIN TO COVER WITH PROVIDED
#8-32 x 1/4" PAN HEAD PHILIPS SCREW. CHAIN FROM BOX
CAN BE REMOVED AND INSTALLED IN ALTERNATE LOCATION,
IF DESIRED.

(4) #8-32 FLAT HEAD SCREW

(4) O-RING

4. SECURE COVER TO BOX; SLIP PROVIDED O-RINGS ONTO
PROVIDED 1"-LONG SCREWS, RIGHT UP TO THE SCREW'S
HEAD, AND TIGHTEN THESE SCREWS INTO THE
COUNTERSUNK THROUGH-HOLES.

43137 LIT1239

C-1062

3. INSTALL PROVIDED #8-32 x 1" FLAT HEAD PHILIPS SCREWS
INTO BLIND TAPPED HOLES ON COVER. SCREWS WILL BE
USED AS LIFTING HANDLES TO OPEN OR CLOSE BOX. ONCE
COVER IS IN PLACE, SCREWS ARE TO BE REMOVED AND
USED TO SECURE COVER.

5. INSTALL PROVIDED #8-32 x 1/4" FLAT HEAD PHILIPS SCREWS
INTO BLIND TAPPED HOLES ON COVER.

BLIND TAPPED HOLE

(2) #8-32 FLAT HEAD SCREW