FSR FL-500P, FL-600P User Manual

FL-500P/600P COVER INSTALLATION INSTRUCTIONS

FSR

1.

REMOVE AND DISCARD TEMPORARY COVER AND SCREWS.

244 Bergen Boulevard, Woodland Park, NJ 07424, Phone: [phone] - Fax: [phone]

2.

INSTALL CABLE INTERFACES AND CONNECTOR PLATES IF PREVIOUSLY
NOT INSTALLED. CLEAN AREA IN AND AROUND ENTIRE TOP EDGE OF
BOX AND APPLY 1/4" CONTINUOUS BEAD OF RTV SILICONE SEALANT.

CLEAN AND APPLY SEALANT
AROUND ENTIRE EDGE

(8) FLAT HEAD SCREW

TEMPORARY COVER

CLEAN AND APPLY SEALANT
AROUND ENTIRE EDGE

3.

INSTALL COVER WITH SUPPLIED O-RINGS AND FLAT HEAD SCREWS.
INSTALL FINISHED FLOORING MATERIAL.

(8) FLAT HEAD SCREW

(8) O-RING

COVER

43051 LIT1479

4.

REMOVE COVER BY LIFTING AND PULLING HANDLE UPWARD AS
SHOWN (CABLE ACCESS DOOR WILL FALL INWARD IF NOT ALREADY
OPEN). COVER CAN NOW BE PLACED FLAT ON FLOOR. CONNECT
CABLES AS REQUIRED. PRIOR TO REINSTALLING COVER, SWING
CABLE ACCESS DOOR ONTO VELCRO ON UNDERSIDE OF COVER.
REVERSE COVER REMOVAL STEPS TO REINSTALL COVER AND PUSH
FIRMLY ON CORNERS TO SNAP COVER SECURELY IN PLACE.

COVER SHOWN WITH CABLE

ACCESS DOOR OPEN

HANDLE

COVER

CABLE ACCESS DOOR

COVER TAB

WHEN REINSTALLING COVER

BE SURE TO INSERT COVER TABS

INTO OPENING ABOVE RIM TABS

OPENING

RIM TAB