FSR FL-1550 Installation Instructions Manual

FL-1550 INSTALLATION INSTRUCTIONS

FSR

244 Bergen Boulevard, Woodland Park, NJ 07424, Phone: [phone] - Fax: [phone]

BOX INSTALLATION

FOR FINISHED WOOD FLOORS ONLY. LOCATE AND POSITION BOX IN ACCORDANCE WITH
FLOOR PLANS. HOLE TO BE CUT IN FLOOR - 12" x 8-1/8". SECURE WITH #6 FLAT HEAD
HARDWARE (BY INSTALLER). OPENING SHOULD BE RABBETED 3/16" DEEP (USE BOX AS
TEMPLATE). ROUTE CONDUIT (BY INSTALLER) TO BOX AS REQUIRED.

(4) #6 FLAT HEAD

HARDWARE

(BY INSTALLER)

RABBET OPENING

(USE BOX AS TEMPLATE)

12" x 8-1/8" HOLE IN FLOOR

3/16"

FLOORING MATERIAL

FLOOR BOX

GANG MOUNTING BRACKET

GANG MOUNTING BRACKET

REMOVE GANG MOUNTING BRACKET AND CONFIGURE
PER CUSTOMER SPECIFICATIONS (SEE GANG MOUNTING
BRACKET CONFIGURATIONS). INSTALL COVER PLATE,
DIVIDER & DIVIDER HOLDER AS REQUIRED.

DIVIDER ASSEMBLY

DIVIDER HOLDER

(2) #8-32 x 1/4" LG

PAN HEAD SCREW

DIVIDER HOLDER ASSEMBLY

(WITH OR WITHOUT DIVIDER)

(2) #8-32 x 1/4" LG

FLAT HEAD SCREW

DIVIDER

COVER PLATE

GANG MOUNTING BRACKET

(3) #6-32 SCREW

COVER PLATE ASSEMBLY

(2) #6-32 x 1/4" LG
PAN HEAD SCREW

DIVIDER HOLDER
WITH DIVIDER

43243 LIT1632

GANG MOUNTING BRACKET

GANG MOUNTING BRACKET CONFIGURATIONS

PER CUSTOMER SPECIFICATIONS, CONFIGURE GANG MOUNTING BRACKETS AS
SHOWN BELOW AND REASSEMBLE INTO BOX (DECORA WALL PLATES SHOWN AS
REFERENCE AND NOT INCLUDED).

GANG MOUNTING BRACKET

COVER PLATE

GANG MOUNTING BRACKET

DIVIDER
HOLDER

(2) DIVIDER HOLDER

OPTIONAL DIVIDER

OPTIONAL DIVIDER

1-GANG/2-GANG CONFIGURATION 1-GANG/3-GANG CONFIGURATION

GANG MOUNTING BRACKET GANG MOUNTING BRACKET

OPTIONAL DIVIDER OPTIONAL DIVIDER

DIVIDER
HOLDER

2-GANG/2-GANG CONFIGURATION 3-GANG/1-GANG CONFIGURATION

GANG MOUNTING BRACKET

DIVIDER
HOLDER

INSTALLING ELECTRONIC COMPONENTS

PULL WIRES AND CABLES TO BOX AS REQUIRED (REMOVAL OF GANG MOUNTING
BRACKETS MAY BE REQUIRED). TERMINATE WIRES AND CABLES TO ELECTRONIC
COMPONENTS, AND INSTALL ELECTRONIC COMPONENTS ONTO GANG MOUNTING
BRACKETS.

GANG MOUNTING BRACKET

(2) DIVIDER HOLDER
(NO DIVIDER USED)

4-GANG CONFIGURATION

INSTALLED
ELECTRONIC
COMPONENT