FrSky FSH-01, FGS-01, FLVS-01, GPS-01, TAS-01 Instruction Manual

...

www.frsky-rc.com

2011/7/14

Instruction

Instruction Manual

Manual

Manual for

for

for FrSky

FrSky

FrSky Sensor

Sensor

Sensor Hub

Hub

Hub and

and

and Sensors

Sensors

1 FrSky

FrSky

FrSky Sensor

Sensor

Sensor Hub

Hub

Hub (

(

( FSH-01

FSH-01

FSH-01 )

)

FrSky Sensor Hub is recommended to connect digital side port (G, TX, RX) of FrSky telemetry receiver and FrSky sensors by the provided cable, to serve as an information collecting and processing center, monitor the model status and feedback all data back to FrSky DHT-U.

Dimension:

Dimension: 37*30*8mm Weight:

Weight:

Weight: Operating

Operating

Operating Voltage

Voltage

Voltage Range:

Range:

Range: 4~10V

Operating

Operating Temperature

Temperature

Temperature Range:

Range:

Range: -20~80 ℃

Feature:

Feature: Firmware upgradable Definition:

Definition:

Fuel : Fuel Gauge Sensor GPS : GPS Vario : V ariometer Sensor Volt : Lipo Voltage Sensor Temp1/2 : T emperature Sensor

Power : Power Supply RPM : RPM Sensor Acc : Triaxial Acceleration Sensor Data : use provided cable to connect to digital side port (G, TX, RX) of FrSky telemetry receive r

Installation:

It is recommended to take the length of all sensors ’ wires into consideration before mounting, and use double-sided tape to install FrSky sensor hub at an appropriate place in the model.

2 FrSky

FrSky

FrSky Sensors

Sensors

Different sensors facilitate to monitor different data, such as fuel lever, speed, longitude, latitude, altitude, temperature, RPM, acceleration, etc. If the model is driven by battery, users could use in-built or external battery voltage sensor to monitor model ’ s battery voltage.

2.1

2.1 Fuel

Fuel

Fuel Gauge

Gauge

Gauge Sensor

Sensor

Sensor (FGS-01)

(FGS-01)

Measurement

Measurement Levels:

Levels:

Levels: Empty, 1/4, 2/4, 3/4, Full

Length

Length of

of the

the

the Sensor

Sensor

Sensor Film:

Film:

Film: 62mm

Installation:

Installation: Use double-sided tape to attach both circuit board and sensor film firmly to the outside of the fuel tank.

How

How to

to replace

replace

replace the

the

the sensor

sensor

sensor film:

film:

Lift the locking tab on both sides of the port, insert the sensor film and press the locking tab back into place to secure the sensor film in the circuit board. Confirm the orientation is correct.

N ote:

ote:

ote: The

The

The fuel

fuel

fuel tank

tank

tank MUST

MUST

MUST be

be empty

empty

empty at

at the

the

the start

start

start of

of this

this

this process

process

process for

for

for the

the

the sensor

sensor

sensor to

to accurately

accurately

accurately read

read

read the

the

the fuel

fuel

fuel level.

level.

FGS-01

FGS-01 does

does

does not

not

not apply

apply

apply to

to metal

metal

metal tank

tank

tank or

or petrol

petrol

petrol /

/ gasoline.

gasoline.

2.2

2.2 GPS

GPS

GPS (GPS-01)

(GPS-01)

GPS feedbacks various data, such as speed, longitude and latitude.

Longitude:

Longitude: dddmm.mmmm E/W

www.frsky-rc.com

Latitude:

Latitude: ddmm.mmmm N/S Installation:

Installation:

Installation: Use double-sided tape to install the GPS on any appropriate surface of the airframe.

Note:

Note: Up

Up right

right

right position

position

position is

is recommended.

recommended.

2.3

2.3 Variometer

Variometer

Variometer Sensor

Sensor

Sensor (FVAS-01)

(FVAS-01)

Measurement

Measurement Range

Range

Range of

of Altitude:

Altitude:

Altitude: 0~9000m

Accuracy:

Accuracy: 1m Installation:

Installation:

Installation: Use double-sided tape to install the variometer sensor on any appropriate surface of the airframe.

Note:

Note: Wind

Wind

Wind will

will

will affect

affect

affect the

the

the altitude

altitude

altitude reading.

reading.

2.4

2.4 Lipo

Lipo

Lipo Voltage

Voltage

Voltage Sensor

Sensor

Sensor (F

(F L

L VS-01)

VS-01)

FrSky lipo voltage sensor will be released quite soon, which can monitor voltage for each cell. Current FrSky voltage sensor (FBVS-01) is suggested to be connected to telemetry receiver ’ s analog ports (A1 & A2).

2.5

2.5 Temperature

Temperature

Temperature Sensor

Sensor

Sensor (TEMS-01)

(TEMS-01)

Up to two temperature sensors can be used at the same time. They are commonly used to read temperatures of model accessories, such as electric motor, ESC, glow and gas engine cylinder head, battery, muffler, voltage regulator, BEC, tailpipe and ambient air.

Measurement

Measurement Range:

Range:

Range: - 2 0~250 degrees Celsius/ - 4 ~482 degrees Fahrenheit

Accuracy:

Accuracy: 1 degree Celsius/ 1 degree Fahrenheit Installation:

Installation:

Installation: Use zip ties to hold the temperature sensor tightly against the accessory that requires temperature reading.

2.6

2.6 RPM

RPM

RPM Sensor

Sensor

Sensor (RPMS-01)

(RPMS-01)

RPM sensor reads RPM data by using an optical sensor.

Measurement

Measurement Range:

Range:

Range: 0~ 6 0000r/min

Installation:

Installation: Point the RPM sensor straight up at any accessory that requires RPM reading.

Note:

Note: Indoor

Indoor

Indoor alternating

alternating

alternating current

current

current lighting

lighting

lighting will

will

will affect

affect

affect the

the

the RPM

RPM

RPM reading.

reading.

2.7

2.7 Triaxial

Triaxial

Triaxial Acceleration

Acceleration

Acceleration Sensor

Sensor

Sensor (TAS-01)

(TAS-01)

Measurement

Measurement Range:

Range:

Range: ± 8g (9.8m/s2)

Accuracy:

Accuracy: 0.016g Installation:

Installation:

Installation: Use double-sided tape to install the triaxial acceleration sensor on any appropriate surface of the airframe.

X/Y/Z axis has been labeled on the sensor.

FrSky FSH-01, FGS-01, FLVS-01, GPS-01, TAS-01 Instruction Manual

Specifications and Main Features

Frequently Asked Questions

User Manual