Frigidaire FGGF3056KFS, DGGF3032KBM, FPGF3081KFN, FFGF3023LMD, FFGF3023LBD Installation Instructions Manual

INSTALLATION AND SERVICE MUST BE
PERFORMED BY A QUALIFIED INSTALLER.
IMPORTANT: SAVE FOR LOCAL ELECTRICAL
INSPECTOR'S USE. READ AND SAVE THESE
INSTRUCTIONS FOR FUTURE REFERENCE.

• ALL RANGES
CAN TiP

• INJURYTO PERSONS
COULD RESULT

• iNSTALL ANTI=TIP

DEVICE PACKED WiTH
RANGE

• SEE iNSTALLATiON
INSTRUCTIONS

if the information in this

manual is not followed exactly, a fire or

explosion may result causing property
damage, personal injury or death.

FOR YOUR SAFETY:

m Do not store or use gasoline or other

flammable vapors and liquids in the
vicinityofthis oranyotherappliance.

WHAT TO DO iF YOU SMELL GAS:

= Do not try to light any appliance.
= Do not touch any electrical switch;

do not use any phone in your

building.

= immediately call your gas supplier

from a neighbor's phone. Follow
the gas supplier's instructions.

= if you cannot reach your gas

supplier, call the fire department.

installation and service must be
performed by a qualified installer,

service agency or the gas supplier.

Provide proper fuel type

Before proceeding: Your range is factory preset to
operate on natural gas. If L.P. conversion is needed,
contact your local L.P. Gas provider for assistance.

The L.P. conversion kit may be located on the lower rear
back panel of the range. If no L.P. kit is provided, contact
your product dealer to obtain the correct L.P. conversion kit.

for applicable agency

__ Refer to your serial plate

certifications

important notes to the installer

• Read all instructions contained in these installation
instructions before installing range.

• Remove all packing material from the oven
compartments before connecting the gas and
electrical supply to the range.

• Observe all governing codes and ordinances.

• Be sure to leave these instructions with the consumer.

important notes to the consumer

• Keep these instructions with your Use & Care Guide

for future reference.

• Be sure your range is installed and grounded properly
by a qualified installer or service technician.

Special instructions for appliances installed in the State of
Massachusetts:

This appliance can only be installed in the State of
Massachusetts by a Massachusetts licensed plumber or
gas fitter. When using a flexible gas connector, it must not
exceed 3 feet (36 inches) in length. A "T" handle type
manual gas valve must be installed in the gas supply line to
this appliance.

IMPORTANT SAFETY INSTRUCTIONS

Installation of this range must conform with local codes or,
in the absence of local codes, with the National Fuel Gas

Code ANSI Z223. l--latest edition when installed in the
United States.

When installed in a manufactured (mobile) home,
installation must conform with the Manufactured Home

Construction and Safety Standard, Title 24 CFR, Part 3280
[formerly the Federal Standard for Mobile Home
Construction and Safety, Title 24, HUD (Part 280)] or, when
such standard is not applicable, the Standard for
Manufactured Home Installations, ANSI/NCSBCS A225.1,

or with local codes.
This range has been design certified by CSA International.

As with any appliance using gas and generating heat, there

are certain safety precautions you should follow. You will

find them in the Use & Care Guide, read it carefully.

1

p/n 316903000 (1004)

iMPORTANT SAFETY iNSTRUCTiONS

Be sure your range is installed and grounded
properly by a qualified installer or service

technician.

• This range must be electrically grounded in
accordance with local codes or, in their absence,

with the National Electrical Code ANSI/NFPA
No .70mlatest edition when installed in the United

States. See Grounding Instructions on page 8.

• Before installing the range in an area covered with
linoleum or any other synthetic floor covering,
make sure the floor covering can withstand heat at
least 90°F above room temperature without
shrinking, warping or discoloring. Do not install the
range over carpeting unless you place an insulating
pad or sheet of 1/4-inch thick plywood between the
range and carpeting.

• Make sure the wall coverings around the range
can withstand the heat generated by the range.

• Do not obstruct the flow of combustion air at the
oven vent nor around the base or beneath the

lower front panel of the range. Avoid touching the
vent openings or nearby surfaces as they may
become hot while the oven is in operation. This range
requires fresh air for proper burner combustion.

• Air curtain or other overhead range hoods, which
operate by blowing a downward air flow on to a range,
shall not be used in conjunction with gas ranges other
than when the hood and range have been designed,
tested and listed by an independent test laboratory for

use in combination with each other.

DO NOT MAKE ANY ATTEMPT TO

OPERATE THE ELECTRIC IGNITION OVEN DURING AN
ELECTRICAL POWER FAILURE. RESET ALL OVEN

CONTROLS TO "OFF" IN THE EVENT OF A POWER
FAILURE,

The electric ignitor will automatically re-ignite the oven
burner when power resumes if the oven thermostat control
was left in the "ON" position.

When an electrical power failure occurs during use, the
surface burners will continue to operate.

During a power outage, the surface burners can be lit with
a match. Hold a lighted match to the burner, then slowly
turn the knob to the LITE position. Use extreme caution
when lighting burners this way.

Never leave children alone or

unattended in the area where an appliance is in use.
Teach children the proper, safe use of all appliances. Never
leave the oven door open when the range is unattended.

Stepping, leaning or sitting on the doors

or drawers of this range can result in serious injuries
and can also cause damage to the range.

• Do not store items of interest to children in the
cabinets above the range. Children could be

seriously burned climbing on the range to reach items.

• To eliminate the need to reach over the surface
burners, cabinet storage space above the burners

should be avoided.

• Adjust surface burner flame size so it does not
extend beyond the edge of the cooking utensil.

Excessive flame is hazardous.

• Do not use the oven as a storage space. This
creates a potentially hazardous situation.

• Never use your range for warming or heating the
room. Prolonged use of the range without adequate
ventilation can be dangerous.

• Do not store or use gasoline or other flammable
vapors and liquids near this or any other
appliance. Explosions or fires could result.

• Reset all controls to the "OFF" position after using
a programmable timing operation.

• Unlike some gas ranges, the cooktop is not
removable. Do not attempt to remove the cooktop.

2

Tools you will need

(Wear safety glasses when using tools):
For leveling legs and Anti=Tip Bracket:

• Adjustable wrench or channel lock pliers (Fig. a)

• 5/16" Nutdriver or flat head screwdriver (Fig. b)

• Electric drill & 1/8" drill bit (3/16" Masonry drill bit if

installing in concrete) (Fig. c)

• Level (Fig. d)
For gas supply connection:

• Adjustable wrench and pipe wrench (Figs. a & e)
For burner flame adjustment:

• Phillips head and small flat-blade screwdrivers (Figs. f
&g)

Materials you will need:

• Pipe joint sealant that resists action of LP/Propane

gas (Fig. h)

• Gas line manual shut-off valve (Fig. i)

• A new flexible metal appliance conduit (1/2" NPT x

3/4" or 1/2" I.D.) must be design certified by CSA
International. Because solid pipe restricts moving the
range, we recommend using a new flexible conduit (4
to 5 foot length) for each new installation and
additional reinstallations. (Fig. j)

• Use new flare union adapters (1/2" NPT x 3/4" or 1/2"
I.D.) (Fig. k)

Materials supplied with appliance:

• Anti=Tip Template (Fig. I)

• Anti-Tip bracket; includes 2 mounting screws (Fig, m)

Tools

Materials

Fig. a

Fig. b

Fig. c

Fig. h

Fig. i

Fig. e

Fig. f

Fig. g

Fig. d

Fig. k

Fig. j

IVlaterials supplied with appliance

Fig. I

3

Fig. m