Friedrich PDE07K3SG Installation
Model PXGA
Installation Instructions
STANDARD LOUVER
For Use With Packaged Terminal Units
Please read these instructions completely before attempting installation.
NOTE: These instructions apply to the Packaged Terminal Unit Standard Louver Installation Kit ONLY. Refer to chassis
Installation/Operation manual and Wall Sleeve Installation Instructions for additional information.
Check box for parts listed in Figure 1.
Installation
1. Remove the center support and weatherboard if still
installed in the sleeve.
2. Insert six plastic grommets into the louver openings
from the outside of the louver as shown in Figure 2.
3. Insert two #8 x 3/8” sheet metal screws (provided)
in the top two outside edge plastic grommets, and
tighten them half way into the grommets.
Figure 1
Quantity
1
6
6
Figure 2
Parts List - Standard Louver
Description
Stamped Aluminum Louver
Plastic Grommets
#8 x 3/8" Sheet Metal Screws
Plastic Handles
CAUTION: Bodily injury can be caused by louvers
falling from a building during installation. It is
recommended that a safety line be attached
to the louver and to an anchor point inside the
building during installation.
4. Grasp the louver by the attached plastic handles.
Position it with the condensate drain knockouts facing down. From inside the building, maneuver the
louver through the wall sleeve and pull it toward you
until the screw heads are inserted into the keyhole
slots at the top of the wall sleeve. Tighten the two
screws completely.
5. Insert the remaining screws into the remaining holes
and tighten securely.
Stamped
Louver
Stamped
Louver
Knockout For
Drain Opening
Grommet
#8 x 3/8"
Sheet
Metal
Screw
Wall Sleeve
920-122-00 (3-07)
Models PXAA / PXBG / PXSC
Installation Instructions
ARCHITECTURAL LOUVER
For Use With Packaged Terminal Units
Please read these instructions completely before attempting installation.
NOTE: These instructions apply to the Packaged Terminal Unit Architectural Louver Installation Kit ONLY. Refer to chassis
Installation/Operation manual and Wall Sleeve Installation Instructions for additional information.
Check box for parts listed in Figure 1.
Figure 1
Quantity
1
4
4
4
Parts list - Architectural Louver
Description
Architectural Louver
#10-24 x 1" Threaded Metal Studs
#10-24 Hex Nuts
7/32" I.D. Flat Washers
Installation
1. Screw a threaded metal stud into each of the holes
at the four corners of the louver.
Figure 2
Louver
2. From inside the building, grasp the louver at the
vertical supports and maneuver the louver through the
wall sleeve. Pull towards you until the threaded studs
are inserted into the four holes of the wall sleeve.
CAUTION: Bodily injury can be caused by louvers
falling from a building during installation. It is
recommended that a safety line be attached to
the louver and an anchor point inside the building
during installation.
3. While holding the louver with one hand, start washers
and nuts on each of the four studs. Tighten the nuts
securely.
Architectural
Louver
Threaded Stud
Wall
Sleeve
920-122-00 (3-07)
Loading...