Friedrich D25D User Manual
www.sylvane.com 1-800-934-9194
Dehumidifier
D25D, D50D, D70D
Installation and Operation Manual
Models
D25D Volts: 115/60Hz Capacity: 25 Pints Moisture Removal: 25 Pint/Day
D50D
D70D
920-198-10 (3-10)
Volts: 115/60Hz
Volts: 115/60Hz
Capacity: 50 Pints
Capacity: 70 Pints
Moisture Removal: 50 Pint/Day
Moisture Removal: 70 Pint/Day
www.sylvane.com 1-800-934-9194
920-198-10
Congratulations!
Thank you for your decision to purchase the Friedrich Dehumidier. Please read thoroughly of this Installation and Operation Manual.
THANK YOU, on behalf of our entire company,
for making such a wise purchase.
Table of Contents
DESCRIPTION OF COMPONENTS ....................................................................................................................................................................................... 3
FUNCTION EXPLANATION .................................................................................................................................................................................................... 3
INSTALLATION INSTRUCTIONS............................................................................................................................................................................................ 4
OPERATION INSTRUCTIONS ................................................................................................................................................................................................ 4
OPERATING DO'S AND DON'TS ...........................................................................................................................................................................................6
CONTINUOUS DRAINAGE ..................................................................................................................................................................................................... 8
MAINTENANCE ..................................................................................................................................................................................................................... 10
IN CASE OF EMERGENCY ................................................................................................................................................................................................... 11
2
www.sylvane.com 1-800-934-9194
DESCRIPTION OF COMPONENTS
Figure 1
AIR FILTER
MOIST AIR
INTAKE
CONTROL PANEL
920-198-10
DEHUMIDIFIED
DRY AIR VENT
HANDLE
DRAIN BUCKET
FUNCTION EXPLANATION
Figure 2
BUCKET FULL LAMP
LAMP LIGHTS WHEN
DRAIN BUCKET IS
FULL AND NEEDS TO
BE EMPTIED.
FAN SPEED
HIGH/LOW
POWER
ON/OFF
DEFROST LAMP
LAMP LIGHTS WHEN UNIT IS
DEFROSTING (SEE PAGE 5).
TIMERS
WHEN THE UNIT IS ON PRESS THE
TIMER BUTTON TO DISPLAY THE
POWER OFF TIMER.
SELECT FROM 1-24 HOURS OF
RUNNING TIME UNTIL THE UNIT
SHUTS OFF AUTOMATICALLY.
WHEN THE UNIT IS OFF PRESS THE
TIMER BUTTON TO DISPLAY THE
POWER ON TIMER. SELECT FROM
1-24 HOURS UNTIL THE UNIT WILL
TURN ON AUTOMATICALLY.
ROLL CASTERS
DRAIN PUMP OUTLET
(ONLY ON 50 AND 70 PINT MODELS)
CURRENT TEMP / TIMER SET DISPLAY
WHEN THE UNIT IS RUNNING THE CURRENT TEMP IS DISPLAYED.
WHEN THE TIMER BUTTON IS PRESSED THIS WINDOW DISPLAYS
THE TIMER SETTING THEN REVERTS BACK TO THE TEMPERATURE
AFTER 10 SECONDS.
CURRENT HUMIDITY DISPLAY
DISPLAYS THE CURRENT
RELATIVE HUMIDITY (RH) IN
THE ROOM. WHEN THE OR
IS PRESSED THE HUMIDITY
SETTING IS DISPLAYED.
SET HUMIDITY
ADJUST THE HUMIDITY % FROM
30% TO 90% RH BY PRESSING THE
OR BUTTONS. HUMIDITY IS
ADJUSTED IN 5% INCREMENTS.
CONTINUOUS
DRAINAGE OUTLET
°C/°F SELECTOR
PRESS THE °C/°F
SWITCH BUTTONS
IT WILL SWITCH
BETWEEN °C AND °F.
FRD001
FRD002
3
www.sylvane.com 1-800-934-9194
920-198-10
INSTALLATION INSTRUCTIONS
Follow the steps below for unpacking and set up your unit.
STEP 1. Remove unit from carton and inspect.
STEP 2. Remove accessories from drain bucket.
STEP 3. Install Roll Casters (D25D models only) per installation
instructions below.
STEP 4. Set up unit in position with adequate clearance. Installation
of unit is complete.
Roll Caster Installation (D25D Models only)
STEP 1. Locate Roll Casters removed during STEP 2 above.
STEP 2. Lay unit on its side for ease of installation.
STEP 3. Insert Roll Casters in slots as shown (See Figure 3) until they
click into place.
Figure 3
ROLL CASTER
OPERATION INSTRUCTIONS
WARNING
Electrical Hazards
Do not fold power cord as shown at left.
Make sure the plug is placed fully and
firmly into the receptacle.
Do not use multiple sockets as shown at
left.
FRD031
STEP 4. Set the unit upright. Roll Caster installation is complete.
STEP 5. Allow unit to sit upright 1 hour before operating.
Allow 8 inches of space on all sides of the unit.
Figure 4
8’’
8’’
8’’
4
8’’
FRD032
Make sure the plug is clean.
After turning the unit off please take plug
out of the receptacle.
Do not have wet hands when connecting
the power plug.
Do not pull the power cord to avoid a
broken cord, which can lead to danger.
Loading...