Friedrich Cp08, Cp06 Service Manual

06 CP08

CP

0

F

hr

Fan

Speed

Timer
0n/0ff

Auto

Swing

CoolMoney

Fan

Saver

Only

®

Temp

Dry

Power

Mode

0

F

hr

Fan
Speed

Auto

Swing

CoolMoney

Fan

Saver

Only

®

Temp

Dry

Timer

Power

Mode

0n/0ff

200

7

Congratulations! Thank you for choosing
Friedrich.

Your Friedrich unit is designed for
maximum comfort and quietness.

Table of Contents

Introduction ..................................................................................2

Safety Precautions.......................................................................3

How to operate your Friedrich ...................................................5

Adjusting the Air Flow Direction.................................................6

Care and Maintenance .................................................................7

Hardware Location.......................................................................8

Installation Instructions

..........................................................

9

Troubleshooting Tips .................................................................17

Warranty ......................................................................................18

2

Introduction

115V~ 230V~

Power cord may include a current
interrupter device. A test and reset button is
provided on the plug case. The device
should be tested on a periodic basis by first
pressing the TEST button and then the
RESET button. If the TEST button does not
trip or if the RESET button will not stay
engaged, discontinue use of the air
conditioner and contact a qualified service
technician.

Before Operating Your Unit

Make sure the wiring is adequate foryour unit.

If you have fuses, they should be of the time delay type. Before you install or relocate this unit, be sure that
the amperage rating of the circuit breaker or time delay fuse does not exceed the amp rating listed in figure 1.

DO NOT use an extension cord.

The cord provided will carry the proper amount of electrical power to the unit; an extension cord will not.

Make sure that the receptacle is compatible with the wall plug provided.

This insures proper grounding. If you have a two-prong receptacle you will need to have the circuit replaced
by a certified electrician with a grounded circuit that meets all national and local codes and ordinances. You
must use the three-prong plug furnished with the air conditioner.

MODEL

CIRCUIT

TIME DELAY

AMP VOLT

RATING OR

FUSE

PLUG FACE

NEMA NO.

G

N

CP06 CP08

15

N OT E !

Aluminum house wiring may pose special problems. Consult a qualified electrician.

125

5-15P

Figure 1

For the Best Cooling Performance and Energy Efficiency

Keep the filter clean

Make sure that your air conditioner is always in top performing condition by cleaning the filter regularly.
Instructions for removing and cleaning the filter can be found on page 7.

Provide good air flow

Make sure that the airflow to and from the unit is clear. Your air conditioner puts the air out at the side of
the unit, and takes in air at the left. Airflow is critical for good operation. It is just as important on the
outside of the building that the airflow around the unit exterior is not blocked.

Unit Placement

If your air conditioner can be placed in a window or a wall that is shaded by a tree or another building, the
unit will operate even more efficiently. Using drapes or blinds on the sunny side of the dwelling will also
add to your unit's efficiency.

E

Insulation

Good insulation will be a big help in maintaining desirable comfort levels. Doors should have weather
stripping. Be sure to caulk around doors and windows.

ENGLISH

WARNING

Safety Precautions

To prevent injury and property damage, follow these instructions.

■Incorrect operation due to ignoring instructions can cause harm or damage. The seriousness is classified
by the following indications.

WARNING This symbol indicates the possibility of death or serious injury.

CAUTION

This symbol indicates the possibility of injury or damage to
properties only.

■Meanings of symbols used in this manual are as shown below.

Never Do This

Always Do This

Plug in the power plug
properly.

• Otherwise, it will cause electric
shock or fire due to heat
generation.

Do not operate or stop the
unit by inserting or pulling
out the power plug.

• It will cause electric shock or fire
due to heat generation.

Do not damage or use an
unspecified power cord.

• It will cause electric shock or fire.

•

If the power cord is damaged, it must
be replaced by the manufacturer or a
Friedrich-certified service agent.

Do not modify power cord
length.

• It will cause electric shock or fire
due to heat generation.

Do not operate with wet
hands or in damp
environment.

• It will cause electric shock.

Do not direct air flow directly
at room occupants.

•

This could lead to health problems

.

3

4

6. AUTO SWING

This button can automatically control the air flow
direction.

Fan

Speed

Timer

0n/0ff

Saver

6

7

Ai r

Po wer

P uri fie r

0

F

Fa n S pee d

Ti me r

Auto

Swing

Tem p

Mod e

A

S win g

hr

Auto

Temp

Swing

Power

5

6

CoolMoney

Fan

®

Only

Dry

Mode

1

2

4

3

5

3

dry operation.

(dehumidify operation)

2

1

7

To receive the signal from remote controller.